FORD ESCORT 1996 7.G Owners Manual

99 [SR20520(ALL)08/95]
one third page art:0070121-C
Figure 8: Securing the chest clip
[SR20530(ALL)08/95]
half page art:0070118-D
Figure 9: Chest clip indicator window
File:03ctsre.ex
Update:Tue Sep 19 15:05:35 1995

100 [SR20540(ALL)08/95]10. Pull on the safety belt tongues to be sure
that they are both latched. See Figure 10.
[SR20550(ALL)08/95]
half page art:0070123-B
Figure 10: Checking for securely latched buckle and locked
retractor
[SR20560(ALL)08/95]
11. If the child sleeps or tries to get out of the
child seat, pull shoulder out fully to put the
retractor into automatic lock mode. Allow
belts to tighten snugly against the child's
shoulders. See Figure 10.
[SR20570(ALL)08/95]
Automatic lock mode keeps a sleeping child in
position and prevents the child from getting out
of the seat while the vehicle is in motion. Older
children who do not fall asleep in the child seat
may be secured with the retractor in the
emergency locking mode. The belts will lock
automatically during a collison or hard braking.
File:03ctsre.ex
Update:Tue Sep 19 15:05:35 1995

101 [SR20580(ALL)08/95]
To remove the child from the built-in child
seat:
[SR20590(ALL)08/95]
1. Squeeze the tabs on the top and bottom of
the chest clip and pull the halves apart to
open the chest clip. Refer back to Figure 8.
[SR20600(ALL)08/95]
2. Press the release button on the crotch safety
belt buckle.
[SR20610(ALL)08/95]
3. Slide the shoulder belts off the child's
shoulders and remove the child. Refer back
to Figure 6.
[SR20620(ALL)08/95]
To stow the built-in child seat:
[SR20625(ALL)08/95]
When the built-in child seat is not in use, it can
be stowed so that an adult may use the center of
the rear seat or the rear seatback can be folded
down.
[SR20630(ALL)08/95]
1. Return the child seat cushion to the upright
position.
[SR20640(ALL)08/95]
2. Make sure shoulder belts are in the center of
the back of the child seat. Attach the cushion
retention clip. Fold the child seat up into the
seatback while tucking the top edge of the
child seat under the flap. See Figure 11.
[SR20650(ALL)08/95]
3. Press firmly in the center of the child seat to
keep in the stowed position. You will not be
able to unlock the rear seatback if the
built-in child seat is not stowed properly.
File:03ctsre.ex
Update:Tue Sep 19 15:05:35 1995

102 [SR20660(ALL)08/95]
one third page art:0070156-EFigure 11: Stowing the built-in child seat
[SR20670(ALL)08/95]
Inspection after a collision:
[SR20680(ALL)08/95]
RWARNING
All built-in child restraints, including
seats, buckles, retractors, seat latches,
interlocks, and attaching hardware should
be inspected by a qualified Dealer
technician after any collision. If the child
seat was in use during a collision, Ford
recommends replacing it. However, if the
collision was minor and a qualified
technician finds that the child restraints
do not show damage and continue to
operate properly, they do not need to be
replaced. Built-in child seats not in use
during a collision should also be
inspected and replaced if either damage or
improper operation is noted.
[SR20690(ALL)08/95]
Built-in child seat maintenance
[SR20700(ALL)08/95]
Regularly inspect the lap and shoulder belts
system of your child seat. See your Ford dealer
if the shoulder belt webbing is frayed, or if the
buckle and tongue are damaged and/or do not
function properly.
File:03ctsre.ex
Update:Tue Sep 19 15:05:35 1995

103 [SR20710(ALL)08/95]
Cleaning the built-in child seat
[SR20720(ALL)08/95]
Your built-in child seat may be cleaned with
mild soap and water. Do not use household
cleaners as they may weaken the webbing or
damage the plastic parts. For your convenience,
the liner is removable and can be
machine-washed and air-dried. See Figure 12.
[SR20730(ALL)09/95]
one third page art:0070256-D
Figure 12: Removing the washable liner
File:03ctsre.ex
Update:Tue Sep 19 15:05:35 1995

105
Starting Your Escort
*
[ST03300(ALL)03/95]
Ignition
%*
[ST03400(ALL)01/95]
Understanding the Positions of the Ignition
[ST03500(ALL)09/95]
Your vehicle may have one of the following lock
cylinders depending on when it was built:
[ST03600(ALL)09/95]
quarter page art:0070292-A
The ignition lock cylinders
[ST03605(ALL)02/94]
LOCK locks the steering wheel when the key is
removed. It also locks the console-mounted
gearshift on vehicles with automatic transaxles.
To turn the key to this position on an automatic
transaxle vehicle, the shift control lever must be
in P (Park).
*
[ST03610(ALL)05/95]
RWARNING
LOCK position does not lock the gearshift
on floor-mounted manual transaxle
gearshifts. If the parking brake is not set
and the gearshift is moved out of gear,
your vehicle may move unexpectedly and
injure someone.
File:04ctste.ex
Update:Tue Sep 19 14:42:54 1995

106 [ST03615(ALL)08/95]The automatic transaxle console-mounted
gearshift will lock only when you turn the key
to LOCK. When the gearshift is in any gear
position but P (Park), the ignition key cannot be
turned to LOCK or be removed from the
steering column.
[ST03620(ALL)02/95]
If you have a manual transaxle, you must push
the key in while turning to the LOCK position
in order to remove the key.
*
[ST03625(ALL)01/95]
LOCK is the only position that allows you to
remove the key. The LOCK feature helps to
protect your vehicle from theft.
[ST03635(ALL)09/95]
OFF (if equipped) allows you to shut off the
engine and all accessories without locking the
steering wheel.
*
[ST03650(ALL)07/95]
ACC (accessory) allows some of your vehicle's
electrical accessories such as the radio and the
windshield wipers to operate while the engine is
not running.
[ST03850(ALL)02/95]
ON allows you to test your vehicle's warning
lights (except the brake system warning light) to
make sure they work before you start the
engine. (The brake system warning light will
remain lit if the parking brake is set or if there
is a problem with the brake system.) The key
returns to the ON position once the engine is
started and remains in this position while the
engine runs.
[ST03900(ALL)02/95]
START cranks the engine. Release the key once
the engine starts so that you do not damage the
starter. The key should return to ON when you
release it. The START position also allows you
to test the brake system warning light.
File:04ctste.ex
Update:Tue Sep 19 14:42:54 1995

107 %
*
[ST04500(ALL)02/95]
Removing the Key From the Ignition
*
[ST04600(ALL)05/94]
Procedures for removing your key from the
ignition vary, depending on whether your
vehicle has an automatic or manual transaxle.
*
[ST04700(ALL)04/94]
If your vehicle has an automatic transaxle:
*
[ST04800(ALL)06/92]
1. Put the gearshift lever in P (Park).
*
[ST04900(ALL)01/95]
2. Set the parking brake fully.
*
[ST04950(ALL)03/95]
3. Turn the ignition key to LOCK.
*
[ST05100(ALL)03/95]
4. Remove the key.
*
[ST05200(ALL)04/94]
If your vehicle has a manual transaxle:
*
[ST05300(ALL)06/92]
1. Put the gearshift lever in 1 (First).
*
[ST05400(ALL)01/95]
2. Set the parking brake fully.
[ST05450(ALL)02/95]
3. Turn the ignition key counterclockwise to
ACC. Push the key in while turning to
LOCK.
*
[ST05900(ALL)03/95]
4. Remove the key.
%*
[ST06000(ALL)05/95]
If the key is stuck in the LOCK position, move
the steering wheel left or right until the key
turns freely.
*
[ST07500(ALL)06/95]
RWARNING
Always set the parking brake fully and
make sure that the gearshift is securely
latched in P (Park) (automatic transaxle) or
in 1 (First) (manual transaxle).
File:04ctste.ex
Update:Tue Sep 19 14:42:54 1995

108
*
[ST07600(ALL)01/93]
RWARNING
Do not leave children, unreliable adults,
or pets alone in your vehicle. They could
accidentally injure themselves or others
through inadvertent operation of the
vehicle. Further, on hot, sunny days,
temperatures in a closed vehicle could
quickly become high enough to cause
severe and possibly fatal injuries to
people as well as animals.
%
*
[ST07700(ALL)03/95]
Fuel-Injected Engines
*
[ST07800(ALL)03/95]
When starting a fuel-injected engine,the most
important thing to remember is to avoid
pressing down on the accelerator before or
during starting. Only use the accelerator when
you have problems getting your vehicle started.
SeeStarting Your Enginein this chapter for
details about when to use the accelerator while
you start your vehicle.
*
[ST08200(ALL)03/95]
Starting Your Vehicle
%*
[ST08300(ALL)05/94]
Preparing to Start Your Vehicle
*
[ST08350(ALL)07/95]
RWARNING
Do not start your vehicle in a closed
garage or other enclosed area. Never sit in
a stopped vehicle for more than a short
period of time with the engine running.
Exhaust fumes are toxic. SeeGuarding
Against Exhaust Fumesin this chapter for
more instructions.
File:04ctste.ex
Update:Tue Sep 19 14:42:54 1995

109
*
[ST08400(ALL)01/95]
Before you start your vehicle, do the following:
*
[ST08500(ALL)08/95]
1. Make sure all occupants in the vehicle
buckle their safety belts. SeeSafety Restraints
in the Index for more details.
*
[ST08600(ALL)03/95]
2. Make sure the headlamps and other
accessories are turned off when starting.
*
[ST08700(ALL)02/92]
3.If you have an automatic transaxle, make
sure that the gearshift is in P (Park) and the
parking brake is set before you turn the key.
[ST08750(ALL)03/95]
If you have an automatic transaxle, your
vehicle has a special shift-lock safety feature.
It prevents you from moving the gearshift
lever out of the P (Park) position unless the
ignition is in the ON position and your foot
is on the brake. To move the gearshift lever,
you must also depress the thumb button.
*
[ST08800(ALL)07/93]
If you have a manual transaxle, make sure
that the parking brake is fully set, push the
clutch pedal to the floor, and put the
gearshift into Neutral before you turn the
key.(Remember, the starter will operate
only if the clutch pedal is pushed all the
way to the floor.)
[ST09000(ALL)06/95]
4. Before you start your vehicle, you should
check the warning lights on the instrument
panel to make sure that they work. Refer to
theWarning Lights and Gaugeschapter.
%*
[ST09400(ALL)02/95]
Starting Your Engine
*
[ST09500(ALL)06/95]
To start your engine:
*
[ST09600(ALL)05/95]
1. Follow the steps underPreparing to Start
Your Vehicleat the beginning of this section.
*
[ST09650(ALL)03/95]
2. Turn the ignition key to the ON position.
*
[ST09720(ALL)06/95]
3. DO NOT depress the accelerator pedal when
starting your engine. DO NOT use the
accelerator while the vehicle is parked.
File:04ctste.ex
Update:Tue Sep 19 14:42:54 1995