drain bolt GREAT WALL HOVER 2006 Service User Guide

Brake-22
2. Install the piston gasket in the tong body.
a. Screw the bleed screw into the bleed hole;
b. Install the square gasket in the sealing groove of two cylinders of
pump respectively after coat its working surface with proper
rubber lubricant.
Tightening torque 7
10Nm.
3. Connect the brake pipeline
Connect the brake oil pipe to the tong.
Tightening force: 50
5Nm
4. Fill up the brake system with the brake fluid and drain the air
in the brake system.
5. Check for leakage of brake fluid.
Rear parking brake
pull-out piece
spring draw bar
hand brake
stay wire
front brake shoe
lower tension spring
clearance-adjusting bolt
clearance-adjusting gear
clearance-adjusting
bolt head
pull-out piece
spring seat
pulling arm pin
rear brake shoe
brake shoe pulling arm
saddle type washer
push pedal
push pedal
release spring
stopper
upper release spring
rear brake disc
Used component which can not be used any more.
Removal of rear brake
Remarks: When the brake torque of the hand brake cannot meet
the brake requirement, the thickness of the brake shoe gasket
shall be tested. If it is less than the minimum value of brake show
gasket, the brake shoe shall be replaced.
minimum thickness: 1.0mm

Appendix D-18
15 front cross stabilizer rod
-connecting bar bottom
arm bolt M10×1.25-8 63±5 39 brake petrol pipe joint M10×1.25 16
16 long longitudinal tie
connecting bolt M14×
1.5-10.9 200±20 40 safety belt body connecting bolt 7/16″-8.8
40±2
17 short longitudinal tie
front connecting bolt
M14×1.5-10.9 180±15 41 safety belt seat connecting bolt 7/16″-8.8 40±2
18 short longitudinal tie rear
connecting bolt M14×
1.5-10.9 200±20 42 body suspension connecting bolt M10×1.25-9.8 63±5
19 cross tie -carriage
connecting bolt M14×
1.5-10.9 200±20 43 Engine oil pan drain bolt 40±5
20 cross tie -rear axle fixing
nut M14×1.5-8 180±15 44 Transmission/transfer case refueling/drain bolt 30～35
21 rear cross stabilizer rod
-rear axle fixed bolt M8
×1.25-8.8 23±3 45 front drive axle refueling bolt M20×1.5 145±5
22 rear cross stabilizer rod
-connecting bar -carriage
bolt M10×1.25-8 63±5 46 Front drive axle drain bolt Rc1/2 30～35
23 standby tire bracket fixed
bolt 10×1.25-8.8 63±5 47 rear drive axle refueling/drain bolt M20×1.5 145±5
24 standby tire lifter fixed
bolt M8×1.25-8.8 25±3 48 Starter and wheel box connecting bolt 30±3