Hyundai Equus 2016 Owner's Manual

Page 381 of 477

7-24
Maintenance
The use of an unauthorized fluid
may result in transmission mal-
function and failure. Use only the
authorized automatic transmis-
sion fluid. (Refer to “Recommended
lubricants and capacities” in the
chapter 8.)
Brake hoses and lines
Confirm the proper installation, and
check for any frictions, cracks, dete-
rioration and leakage. If necessary,
immediately replace any deteriorated
or damaged parts.
Brake fluid
Check the brake fluid level. The level
should be between “MIN” and “MAX”
marks on the reservoir. Use only the
hydraulic brake fluid, which meet the
requirements of the DOT3/DOT4
specifications.
Brake discs, pads, calipers
and rotors
Check the pads and the disc for any
excessive wear-out, and inspect
calipers for any fluid leakage.
Exhaust pipe and muffler
Inspect the exhaust pipes, muffler
and hangers for any cracks, deterio-
rations, or damages. Start the
engine, and listen carefully for any
gas leaking noise. If necessary, tight-
en connections or replace the dam-
aged parts.
Suspension mounting bolts
Check the suspension connections
for any looseness or damage. If nec-
essary, retighten the bolt to the spec-
ified torque.
Steering gear box, linkage &
boots/lower arm ball joint
After stopping the vehicle and turn-
ing off the engine, confirm the steer-
ing locking (tightening).
Check the bends for any linkage or
damage. Check the dust boots and
ball joints for any deterioration,
cracks, or damage. If necessary,
replace the damaged parts.
Power steering pump, belt and
hoses
Check the power steering pump and
hoses for any leakage or damage. If
necessary, immediately replace any
damaged or leaking parts. Inspect
the power steering belt (or drive belt)
for any cuts, cracks, excessive wear-
out, oil saturation or looseness. If
necessary, replace or adjust the
damaged part.
Drive shafts and boots
Check the drive shafts, boots and
clamps for any cracks, deterioration,
or damage. If necessary, replace or
grease the damaged part.
Air conditioning refrigerant
Check the air conditioning lines and
connections for any leakage or dam-
age.
NOTICE

Page 382 of 477

7-25
Maintenance07
Checking the engine oil level
1. Be sure the vehicle is on levelground.
2. Start the engine and allow it to reach a normal operating temper-
ature.
3. Turn the engine off and wait for the oil fluctuation to stabilize in the oil
pan (approximately 5 minutes).
4. Pull the dipstick out, wipe it clean, and re-insert it fully.
5. Pull the dipstick out again and check the level. The level should
be between F and L. Do not overfill the engine oil.
This may damage the engine.
while adding or changing it. If
you spill out the engine oil in the
engine compartment, immedi-
ately wipe it off.
When it is near to or at L, add the
engine oil to bring it up to F. Do not
overfill it.
Use a funnel to prevent oil spillage
over the engine components.
Use only the authorized engine oil. (Refer to “Recommended lubricantsand capacities” in the chapter 8.)
NOTICE
E E N
N G
GI
IN
N E
E
O
O I
IL
L
OVI075002N
- Radiator hose
Do not touch the radiator hose
while checking or adding the
engine oil. This may burn your
skin.
WARNING
OVI075003N

Page 383 of 477

7-26
Maintenance
Changing the engine oil and
filter
Have engine oil and filter changed by
an authorized EQUUS dealer in
accordance with the Maintenance
Schedule, as specified in the begin-
ning of this chapter.
Engine oil contains chemicals
known to the State of California
to cause cancer, birth defects
and reproductive harm. Used
engine oil may cause irritation
or cancer of the skin if left in
contact with the skin for pro-
longed periods of time. Always
protect your skin by washing
your hands thoroughly with
soap and warm water as soon
as possible after handling used
oil.
CALIFORNIA PROPOSI-TION 65 WARNING
OVI075161N

Page 384 of 477

7-27
Maintenance07
The high-pressure cooling system
has a reservoir filled with the year-
round antifreeze coolant. The reser-
voir is already filled at the factory.
Check the antifreeze protection and
coolant level at least once a year, at
the beginning of the winter season,
and before traveling to a colder
region.
Checking the coolant level
E EN
N G
GI
IN
N E
E
C
C O
O O
OL
LA
A N
N T
T
(Continued)

operating, but when the
engine and radiator are hot,
do not remove the radiator
cap or the drain the plug. Hot
coolant and steam may blow
out under pressure, causing a
serious injury.
The electric motor (of
the cooling fan) is
controlled by the
engine coolant tem-
perature, refrigerant
pressure and driving speed. It
may operate, even when the
engine is not running. Use
extreme caution, when working
near the cooling fan blades. So,
you are not injured by the fan-
blade rotation. As the engine
coolant temperature decreases,
the electric motor will automati-
cally turn off. This is a normal.
When your vehicle is equipped
with GDI, the electric motor (of
the cooling fan) may operate
until the negative battery cable
is disconnected.
WARNING
Removing the radia-
tor cap
Never attempt to remove the radiator cap while the engine
is running, or when the engine
is hot. This may damage the
cooling system and the
engine, resulting in a serious
personal injury due to the hot
coolant or steam.
Turn the engine off and wait until it cools down. Use
extreme care when removing
the radiator cap. Wrap a thick
towel around it, and slowly turn
it in a counterclockwise direc-
tion to the first stop. Step back
while the pressure is released
from the cooling system.
When you are sure all the pres-
sure is released, press down
on the cap over a thick towel,
and turn it in a counterclock-
wise direction to remove it.
(Continued)
WARNING

Page 385 of 477

7-28
Maintenance
Check all the cooling system hoses
and heater hoses. If necessary,
replace any swollen or deteriorated
one. The coolant level should
be between F and L marks
on the coolant reservoir,
when the engine is cool.
When the coolant level is low, add
distilled (deionized) water. Bring up
the level to F, but do not overfill.
When frequent additions are
required, have an authorized
EQUUS dealer inspect your cooling
system.
Recommended engine coolant
When adding coolant, use the deionized water, distilled water or
soft water. Never add hard water in
the coolant. An improper coolant
mixture may result in serious mal-
function or engine damage.
The engine parts are made of alu- minum and must be protected by
an ethyleneglycol-based coolant
from any corrosion and freezing.
DO NOT USE alcohol or methanol coolant, nor mix them with the
authorized coolant. Do not use the solution of which
the antifreeze portion is above
60% or below 35%. This may
reduce the solution effects.
Mix the water and antifreeze in the half-and-half ratio. This solution will
work in most situations.
For the proper mixture ratio, refer to
the following table.
Information
The half-and-half ratio solution of
water and antifreeze is effective at a
temperature of -31°F (-35°C) and
higher.
i
OVI075004N
5°F (-15°C) 35 65
-13°F (-25°C) 40 60
-31°F (-35°C) 50 50
-49°F (-45°C) 60 40
Ambient
Temperature Mixture Percentage (volume)
Antifreeze Water

Page 386 of 477

7-29
Maintenance07
Changing the coolant
Have coolant changed by an author-
ized EQUUS dealer in accordance
with the Maintenance Schedule, as
specified in the beginning of this
chapter.
Cover a thick cloth around the
radiator cap, before refilling the
coolant, in order to prevent the
coolant spillage over the engine
parts, such as the generator.
NOTICE
OVI075005N
Radiator cap
Do not remove the radiator cap,
when the engine and radiator
are hot. Hot coolant and steam
may blow out under pressure
and burn your skin, causing a
serious injury.
WARNING
- Coolant
Do not fill the radiator coolant or antifreeze in the washer
fluid reservoir.
Radiator coolant may obscure your visibility, when sprayed
on the windshield. This may
cause loss of vehicle control,
or damage the paint and body
trim.
WARNING

Page 387 of 477

7-30
Maintenance
Checking the brake fluid level
Check the fluid level in the reservoir
on a regular basis. The fluid level
should be between MAX and MIN
marks on the reservoir.
Before opening the reservoir cap to
add brake fluid, clean the area
around the reservoir cap to prevent
brake fluid from being contaminated.
When the level is low, add fluid near
to the MAX level. The level decreas-
es, as the vehicle drives. This is a
normal, associated with the wear-out
of the brake linings. When the fluid
level is excessively low, have the
brake system checked by an author-
ized EQUUS dealer.
Use only the authorized brake fluid.(Refer to “Recommended lubricantsor capacities” in the chapter 8.)
Never mix different types of fluid.
Do not spill the brake fluid over
the body paint. This may damage
the paint. The brake fluid, which is
exposed in the air for an extended
period of time, should not be
used, as its quality cannot be
guaranteed. It should be disposed
in a proper manner. Do not add
unauthorized fluid. A few drops of
mineral-based oil, such as engine
oil, in your brake system may
damage brake system parts.
NOTICE
B B R
RA
A K
KE
E
F
F L
LU
U I
ID
D
- Loss of brake fluid
When the brake system
requires frequent fluid addition,
the vehicle should be inspected
by an authorized EQUUS dealer.
WARNING
- Brake fluid
When changing and adding
brake fluid, pay special atten-
tion to it. Before washing your
hands, do not touch your eyes.
When the brake fluid should
come in contact with your eyes,
immediately wash them with
fresh tap water. Immediately
have your eyes examined by a
doctor.
WARNING
OVI075006N

Page 388 of 477

7-31
Maintenance07
Checking the power steering
fluid level
Check the fluid level in the power
steering reservoir on a regular basis,
after parking on a level ground. The
fluid level should be between MAX
and MIN marks on the gauge at a
normal temperature.
Before adding power steering fluid,
clean the area around the reservoir
cap to prevent power steering fluid
contamination.
When the level is low, add the fluid
near to the MAX level.
When the power steering system
requires frequent fluid addition, have
the vehicle inspected by an author-
ized EQUUS dealer. To avoid damage to the power
steering pump, do not operate
the vehicle for a prolonged peri-
od of time, when the power
steering fluid level is low.
Never start the engine when the reservoir tank is empty.
Pay special attention while adding the fluid. So, any dirt
does not get into the tank.
Low level of the fluid may increase the steering effort and
noise from the power steering
system.
The use of the unauthorized fluid may reduce the effects of
the power steering system and
damage it.
Use only the authorized power steer-ing fluid. (Refer to "Recommendedlubricants or capacities" in the chap-ter 8.)
Checking the power steering
hose
Check the connections for any oil
leakage, damages and twists, before
driving.
NOTICE
P P O
O W
W E
ER
R
S
S T
T E
EE
ER
R I
IN
N G
G
F
F L
LU
U I
ID
D
OVI075162N

Page 389 of 477

7-32
Maintenance
Checking the washer fluid
level
The washer fluid reservoir is trans-
parent, so that you can visually
check the washer fluid level.
If necessary, add the washer fluid.
Plain water may be used, when the
washer fluid is unavailable. However,
you may add antifreezing solvents to
the fluid to prevent it from freezing,
before driving at a cold temperature.
W WA
AS
SH
H E
ER
R
F
F L
LU
U I
ID
D
OVI075008N
- Coolant
Do not add the radiator
coolant or the antifreeze in
the washer fluid reservoir.
obscures your visibility, when
sprayed on the windshield.
This may cause loss of vehi-
cle control, or damage the
paint and body trim.
(Continued)
(Continued)
The washer fluid containsome amounts of alcohol.
Thus, it is flammable under
certain circumstances. Keep
the washer fluid or the reser-
voir away from any sparks or
flames. This may damage the
vehicle, or injure the occu-
pants.
to humans and animals. Do
not drink and avoid contact-
ing with the washer fluid. This
may cause a serious injury or
death.
WARNING

Page 390 of 477

7-33
Maintenance07
Filter replacement
It must be replaced, if necessary,
and should not be washed.
After checking the air cleaner ele-
ment, clean the filter.
Clean the filter by blowing the com-
pressed air.
Main air cleaner
1. Press the top of the fastener toremove the cover.
2. Loosen the clips and open the cover.
3. Clean the inside of the air cleaner.
A A I
IR
R
C
C L
LE
E A
A N
N E
ER
R
OVI075009N
■ Main air cleaner
OVI075010N
■ Chamber air cleaner
OVI075163N
OVI075011N

Page:   < prev 1-10 ... 341-350 351-360 361-370 371-380 381-390 391-400 401-410 411-420 421-430 ... 480 next >