display INFINITI QX4 2005 Factory Service Manual

REAR WIPER AND WASHER SYSTEM
WW-47
C
D
E
F
G
H
I
J
L
MA
B
WW
Revision: October 20052005 QX56
Display Item List
Rear Wiper Does Not OperateEKS00BEI
1. REAR WIPER ACTIVE TEST
1. Turn on rear wiper using "ACTIVE TEST". Refer to WW-46, "
ACTIVE TEST" .
2. Make sure rear wiper operates.
OK or NG
OK >> GO TO 7.
NG >> GO TO 2.
2. CHECK REAR WIPER MOTOR CIRCUITS
1. Turn ignition switch OFF.
2. Disconnect BCM connector and rear wiper motor connector.
3. Check continuity between BCM harness connector terminals
and rear wiper motor harness connector terminals.
OK or NO
OK >> GO TO 3.
NO >> Repair harness or connector.
3. CHECK GLASS HATCH AJAR SWITCH
1. Make sure hatch glass is closed.
2. Check continuity between BCM connector M19 terminal 42 (GR)
and ground.
OK or NG
OK >> GO TO 4.
NG >> Repair harness if shorted. If not, refer to BL-117,
"GLASS HATCH AJAR SWITCH CHECK" for further
glass hatch ajar switch diagnosis.
Test item Display on CONSULT-II screen Description
Front wiper HI output FR WIPER (HI) Front wiper HI can be operated by any ON-OFF operation.
Front wiper LO output FR WIPER (LO) Front wiper LO can be operated by any ON-OFF operation.
Front wiper INT output FR WIPER (INT) Front wiper INT can be operated by any ON-OFF operation.
Rear wiper output RR WIPER Rear wiper can be operated by any ON-OFF operation.
Wiper should operate.
Te r m i n a l s
Continuity
ConnectorTerminal
(wire color)ConnectorTe r m i n a l
(wire color)
M1955 (SB)
D7044 (SB)
Ye s
54 (Y) 6 (Y)
WKIA2091E
42 (GR) - Ground : Continuity should not exist.
WKIA2092E