service INFINITI QX56 2007 Factory Service Manual

BODY REPAIR
BL-171
< SERVICE INFORMATION >
C
D
E
F
G
H
J
K
L
MA
B
BL
N
O
P
The symbols used in this section for cutting and welding / brazing operations are shown below.
PIIA0149E

BL-172
< SERVICE INFORMATION >
BODY REPAIR
• Front pillar butt joint can be determined anywhere within shaded
area as shown in the figure. The best location for the butt joint is at
position A due to the construction of the vehicle. Refer to the front
pillar section.
• Determine cutting position and record distance from the locating
indent. Use this distance when cutting the service part. Cut outer
front pillar over 60 mm above inner front pillar cut position.
• Prepare a cutting jig to make outer pillar easier to cut. Also, this will
permit service part to be accurately cut at joint position.
• An example of cutting operation using a cutting jig is as follows.
1. Mark cutting lines.
A: Cut position of outer pillar
B: Cut position of inner pillar
2. Align cutting line with notch on jig. Clamp jig to pillar.
3. Cut outer pillar along groove of jig. (At position A)
4. Remove jig and cut remaining portions.
5. Cut inner pillar at position B in same manner.
HOODLEDGE
PIIA0150E
PIIA0151E
PIIA0152E
PIIA0153E

BODY REPAIR
BL-173
< SERVICE INFORMATION >
C
D
E
F
G
H
J
K
L
MA
B
BL
N
O
P
• Work after radiator core support has been removed.
FRONT PILLAR
LIIA1154E

BL-174
< SERVICE INFORMATION >
BODY REPAIR
• Work after rear hoodledge reinforcement has been removed.
LIIA1108E

BODY REPAIR
BL-175
< SERVICE INFORMATION >
C
D
E
F
G
H
J
K
L
MA
B
BL
N
O
P
LIIA1109E

BL-176
< SERVICE INFORMATION >
BODY REPAIR
LIIA1110E

BODY REPAIR
BL-177
< SERVICE INFORMATION >
C
D
E
F
G
H
J
K
L
MA
B
BL
N
O
P
CENTER PILLAR
LIIA1111E

BL-178
< SERVICE INFORMATION >
BODY REPAIR
LIIA1112E

BODY REPAIR
BL-179
< SERVICE INFORMATION >
C
D
E
F
G
H
J
K
L
MA
B
BL
N
O
P
OUTER SILL
LIIA1118E

BL-180
< SERVICE INFORMATION >
BODY REPAIR
REAR FENDER
WIIA0285E