INFINITI QX56 2010 Factory Service Manual
Page 2931 of 4210
PG
POWER SUPPLY ROUTING CIRCUITPG-21
< COMPONENT DIAGNOSIS >
C
DE
F
G H
I
J
K L
B A
O P
N
ABMIA1183GB
Revision: April 20092010 QX56
Page 2932 of 4210
PG-22
< COMPONENT DIAGNOSIS >
POWER SUPPLY ROUTING CIRCUIT
Wiring Diagram —Igniti on Power Supply —
INFOID:0000000005146578
ABMWA0066GB
Revision: April 20092010 QX56
Page 2933 of 4210
PG
POWER SUPPLY ROUTING CIRCUITPG-23
< COMPONENT DIAGNOSIS >
C
DE
F
G H
I
J
K L
B A
O P
N
ABMWA0434GB
Revision: April 20092010 QX56
Page 2934 of 4210
PG-24
< COMPONENT DIAGNOSIS >
POWER SUPPLY ROUTING CIRCUIT
ABMWA0435GB
Revision: April 20092010 QX56
Page 2935 of 4210
PG
POWER SUPPLY ROUTING CIRCUITPG-25
< COMPONENT DIAGNOSIS >
C
DE
F
G H
I
J
K L
B A
O P
N
ABMWA0069GB
Revision: April 20092010 QX56
Page 2936 of 4210
PG-26
< COMPONENT DIAGNOSIS >
POWER SUPPLY ROUTING CIRCUIT
ABMIA1184GB
Revision: April 20092010 QX56
Page 2937 of 4210
PG
POWER SUPPLY ROUTING CIRCUITPG-27
< COMPONENT DIAGNOSIS >
C
DE
F
G H
I
J
K L
B A
O P
N
ABMIA1185GB
Revision: April 20092010 QX56
Page 2938 of 4210
PG-28
< COMPONENT DIAGNOSIS >
POWER SUPPLY ROUTING CIRCUIT
ABMIA1186GB
Revision: April 20092010 QX56
Page 2939 of 4210
PG
POWER SUPPLY ROUTING CIRCUITPG-29
< COMPONENT DIAGNOSIS >
C
DE
F
G H
I
J
K L
B A
O P
N
ABMIA1187GB
Revision: April 20092010 QX56
Page 2940 of 4210
PG-30
< COMPONENT DIAGNOSIS >
POWER SUPPLY ROUTING CIRCUIT
Fuse
INFOID:0000000005146579
• If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse.
• Use fuse of specified rating. Never use fuse of more than specified
rating.
• Do not partially install fuse; always insert it into fuse holder prop- erly.
• Remove fuse for “ELECTRICAL PARTS (BAT)” if vehicle is not used for a long period of time.
Fusible LinkINFOID:0000000005146580
A melted fusible link can be detected either by visual inspection or by
feeling with finger tip. If its condition is questionable, use circuit
tester or test lamp.
CAUTION:
• If fusible link should melt, it is possible that critical circuit
(power supply or large current carrying circuit) is shorted. In
such a case, carefully check and eliminate cause of malfunc-
tion.
• Never wrap outside of fusible link with vinyl tape. Important: Never let fusible link touch an y other wiring harness, vinyl or
rubber parts.
CEL083
1 : Fusible link
ALMIA0015GB
Revision: April 20092010 QX56