ISUZU TF SERIES 2004 Workshop Manual

ELECTRICAL-BODY AND CHASSIS 8A-383

CIRCUIT DIAGRAM 4JA1-L (RHD)




RW48AXF009401

8A-384 ELECTRICAL-BODY AND CHASSIS

CIRCUIT DIAGRAM 4JA1-TC / 4JH1-TC (LHD)




RTW48AXF009101

ELECTRICAL-BODY AND CHASSIS 8A-385
KEYLESS ENTRY
PARTS LOCATION (RHD)







RTW48AXF024201 & RTW48AXF024301

8A-386 ELECTRICAL-BODY AND CHASSIS

PARTS LOCATION (LHD)






RTW48AXF024401 & RTW48AXF024501

ELECTRICAL-BODY AND CHASSIS 8A-387

CIRCUIT DIAGRAM (RHD) Sheet 1/2




RTW48AXF023501

8A-388 ELECTRICAL-BODY AND CHASSIS

CIRCUIT DIAGRAM (RHD) Sheet 2/2



RTW48AXF023601

ELECTRICAL-BODY AND CHASSIS 8A-389

CIRCUIT DIAGRAM (LHD) Sheet 1/2




RTW48AXF023701

8A-390 ELECTRICAL-BODY AND CHASSIS

CIRCUIT DIAGRAM (LHD) Sheet 2/2




RTW48AXF023801

ELECTRICAL-BODY AND CHASSIS 8A-391
Remote key
Remove Key Assembly
Replacing the battery in the remote control unit
Replace the battery as soon as the range of the remote control
starts to become reduced.
Open the underside of the remote control unit by removing the
battery cover with a screwdriver as shown in the illustration.
Replace the battery, ensuring that it is inserted correctly.
Replace the battery cover so that it engages audibly. The
battery change must be performed within 3 minutes, otherwise
the remote control will have to be reprogrammed. Make sure
that you dispose of old batteries in accordance with
environmental protection regulations.
604RW055

8A-392 ELECTRICAL-BODY AND CHASSIS

TECH-2 OPERATION AND PROGRAMING
KEYLESS ENTRY
General Description
When the anti-theft and keyless entry control unit and/or the
transmitters (remote keys) are replaced, the security codes
and/or transmitter ID codes must be programmed by using he
Tech-2. The following pages show the procedures to program
in regard to the anti-theft and keyless entry system. Please
refer to Tech-2 scan tool user’s guide in detail.








901RW180
Legend
(1) PCMCIA Card (4) DLC Cable
(2) RS 232 Loop Back Connector (5)Tech–2
(3) SAE 16/19 Adaptor