window ISUZU TFS SERIES 1997 Owner's Guide
Page 518 of 1600
CAB 10-21
13.Window Glass
First, align the height of regulator to the access hole.
Remove 2 screws attaching bottom channel and
regulator, then remove the glass.
Remove the window glass by tilting it as necessary.
17.Door Lock Assembly
Disconnect the linkage from the door outside handle,
inside lever and lock cylinder.
Remove the 2 bolts holding the outside handle from
inner side.
Remove the 3 bolts holding the door lock assembly.
Page 520 of 1600
CAB 10-23
REASSEMBLY
(Front Door)
15
23 21 24 2522 171620
Reassembly Steps
1. Outside handle
2. Door lock cylinder
3. Glass run front channel
4. Door lock assembly/Door lock actuator
5. Inside lever
6. Glass run rear channel
7. Glass run
8. Window regulator/Power window motor
9. Window glass
10. Water proof sheet
11. Speaker box
12. Bracket
13. Door mirror bracket14. Door mirror assembly
15. Outer waste seal
16. Inner waste seal
17. Power window box
18. Door pocket
19. Door trim pad
20. Door mirror cover/Tweeter
21. Door pull case
22. Speaker assembly
23. Speaker grill
24. Bezel
25. Power window switch/Windows regulator
handle
Page 521 of 1600
10-24 CAB
Important Operations
9.Window Glass
Insert the window glass into position by tilting it as
necessary, then set it against the channel of the window
regulator.
Attach the window glass to the window regulator with the
two screws.
10.Water Proof Sheet
Place the butyl type on the door panel so as not to cover
the drain hole.
25.Regulator Handle
Install the regulator handle as illustrated when closing
the window glass.