JAGUAR XFR 2010 1.G Workshop Manual

Installation).

Installation

1. Offer up the panel. Check alignment, if correct, proceed to next step, if
not rectify and recheck before proceeding.

2. Install the front bumper.
Tighten to 25Nm.













3. The installation of associated panels and components is the reversal of
removal procedure.

Bumpers - Front Bumper Cover
Removal and Installation

Removal


NOTE: Removal steps in this procedure may contain installation details. Published: 11-May-2011


1. WARNING: Make sure to support the vehicle with axle stands.

Raise and support the vehicle.

2. Torque: 3 Nm 3. Torque:
Retaining screws 2 Nm Retaining bolts 7 Nm

5. NOTE: This step requires the aid of another
technician.

www.JagDocs.com

Installation).







Installation

2.

















3. NOTE: Do not disassemble further if the component is
removed for access only.

1. To install, reverse the removal procedure.

Bumpers - Rear Bumper Cover
Removal and Installation

Removal


NOTE: Removal steps may contain installation details. Published: 11-May-2011

1. Remove the rear lamp assemblies.

Refer to: Rear Lamp Assembly (417-01 Exterior Lighting, Removal and Installation).

2. Torque: 7 Nm 3.

Bumpers - Rear Bumper
Removal and Installation

Removal


NOTE: Removal steps in this procedure may contain installation details. Published: 11-May-2011

1. Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation).

2.
3.

1. To install, reverse the removal procedure. www.JagDocs.com

Front safety belt retractor to seat track retaining bolt 40 30 - Front safety belt retractor retaining bolt 40 30 - Front safety belt D loop retaining bolt 40 30 - Front safety belt buckle retaining bolt 40 30 - Front safety belt shoulder height adjuster retaining bolts 25 18 - Rear centre safety belt retractor retaining bolts 40 30 - Rear safety belt long end retaining bolts 40 30 - Rear safety belt D loop retaining bolt 40 30 - Rear safety belt long end retaining bolt 40 30 - Rear safety belt buckle retaining bolts 40 30 -