sensor LEXUS LS430 2003 Factory Repair Manual

As the temperature increases, the voltage decreases.
Result:
AIR CONDITIONING AMPLIFIER (TE - SG) TEST RESULT
B: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
C: REPLACE AIR CONDITIONING AMPLIFIER (SEE REPLACEMENT )
Fig. 49: Inspecting Air Conditioning Amplifier (TE
- SG)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
A: Go to next step
3.INSPECT A/C EVAPORATOR TEMPERATURE SENSOR
a. Remove the A/C evaporator temperature sensor.
b. Measure the resistance according to the value (s) in table below.
NGA
OK (Checking from the PROBLEM SYMPTOM TABLE)B
OK (Checking from the DTC)C

Standard:
A/C EVAPORATOR TEMPERATURE SENSOR RESISTANCE
<0029004c004a0011000300180013001d0003002c005100560053004800460057004c0051004a000300240012002600030028005900440053005200550044005700520055000300370048005000530048005500440057005800550048000300360048005100
5600520055[

Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
Tester connectionConditionSpecified condition
1 - 2-10°C (14°F)7.40 to 9.20 kohms
1 - 2-5°C (23°F)5.65 to 7.00 kohms
1 - 20°C (32°F)4.35 to 5.40 kohms
1 - 25°C (41°F)3.40 to 4.20 kohms
1 - 210°C (50°F)2.68 to 3.30 kohms
1 - 215°C (59°F)2.10 to 2.60 kohms
1 - 220°C (68°F)1.66 to 2.10 kohms
1 - 225°C (77°F)1.32 to 1.66 kohms
1 - 230°C (86°F)1.05 to 1.35 kohms

HINT:
As the temperature increases, the resistance decrease (see the graph below).
Fig. 51: Resistance/Temperature Graph

Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: REPLACE A/C EVAPORATOR TEMPERATURE SENSOR
HINT:
When replacing the evaporator temperature sensor, the attached sub-harness should be replaced along
with the sensor.
OK: Go to next step
4.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - A/C
EVAPORATOR TEMPERATURE SENSOR) (SEE ELECTRONIC CIRCUIT INSPECTION
PROCEDURE )
a. Measure the resistance according to the value (s) in the table below.
Standard:
AIR CONDITIONING AMPLIFIER - A/C EVAPORATOR TEMPERATURE SENSOR

Fig. 53: Identifying Terminals Of A/C Evaporator Temperature Sensor Connector
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: REPLACE AIR CONDITIONING AMPLIFIER (SEE REPLACEMENT
)
CIRCUIT DESCRIPTION
This sensor detects the register temperature and sends the appropriate signals to the A/C amplifier.
Fig. 54: DTC Detection Item Trouble Area Chart

Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

WIRING DIAGRAM
Fig. 55: Air Duct Sensor Circuit (Driver Side)

Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION PROCEDURE
1.READ VALUE ON HAND-HELD TESTER
a. Connect the hand-held tester to the DLC3.
b. Turn the ignition switch to the ON position and push the hand-held tester main switch on.
c. Select the item below in the DATA LIST, and read the display on the hand-held tester.
DATA LIST / AIR CONDITIONER:
DATA LIST / AIR CONDITIONER
OK:
The display is as specified in the normal condition.
Result:
AIR CONDITIONER TEST RESULT
ItemMeasure Item/Display (Range)Normal ConditionDiagnostic
Note
DUCT
TEMP-DDuct sensor (Driver side) / min.: -12.7°C
(9.14°F) max.: 76.55°C (169.79°F)Actual duct temperature is
displayed (Driver side)-

Fig. 56: Inspecting Air Conditioning Amplifier (TFACEDR - SG-3)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
Result:
AIR CONDITIONING AMPLIFIER (TFACEDR - SG-3) TEST RESULT
B: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
C: REPLACE AIR CONDITIONING AMPLIFIER (SEE REPLACEMENT )
A: Go to next step
3.INSPECT AIR DUCT SENSOR
a. Remove the air duct sensor.
b. Measure the resistance according to the value (s) in the table below.
Standard:
NGA
OK (Checking from the PROBLEM SYMPTOM TABLE)B
OK (Checking from the DTC)C

AIR DUCT SENSOR RESISTANCE
HINT:
As the temperature increases, the resistance decreases.
Fig. 57: Inspecting Air Duct Sensor

Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: REPLACE AIR DUCT SENSOR
OK: Go to next step
4.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - AIR DUCT
SENSOR) (SEE ELECTRONIC CIRCUIT INSPECTION PROCEDURE
)
a. Measure the resistance according to the value (s) in the table below.
Tester connectionConditionSpecified condition
D7-1 - D7-2at 0°C (32°F)14.5 to 19.0 kohms
D7-1 - D7-2at 25°C (77°F)4.8 to 5.2 kohms
D7-1 - D7-2at 50°C (122°F)1.6 to 2.0 kohms

Standard:
AIR CONDITIONING AMPLIFIER - AIR DUCT SENSOR RESISTANCE
Tester connectionConditionSpecified condition
A13-15 (TFACEDr) - D7-1AlwaysBelow 1 ohms
A13-10 (SG-3) - D7-2AlwaysBelow 1 ohms
A13-15 (TFACEDr) - Body groundAlways10 kohms or higher
A13-10 (SG-3) - Body groundAlways10 kohms or higher

Fig. 58: Checking Harness And Connector (Air Conditioning Amplifier - Air Duct Sensor)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: REPLACE AIR CONDITIONING AMPLIFIER (SEE REPLACEMENT )
CIRCUIT DESCRIPTION
This sensor detects the register temperature and sends the appropriate signals to the A/C amplifier.
Fig. 59: DTC Detection Item Trouble Area Chart

Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
WIRING DIAGRAM
Fig. 60: Air Duct Sensor Circuit (Passenger Side)

Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION PROCEDURE
1.READ VALUE ON HAND-HELD TESTER