sensor MAZDA MODEL 6 2010 Smart Start Guide (in English)

Key
12
Lock
Tr u n k
Panic
Alarm Unlock
Auxiliar y KeyAdvanced

Key
Driver’s Door Request Switch
Trunk Request Switch
Sensor (back of handle)
NOTE:

• Engine Stop
Continuously pushing the START/STOP button while
the engine is running will turn the engine OFF. Use
only in case of an emergency.

• Vehicle Entr y/Engine Start If the advanced key cannot be used due to a malfunction
or dead advanced key battery, use the auxiliary key
to lock /unlock the doors and to start the engine.
Engine Ready to
Start Indicator Light
ACC

Indicator
Light Ignition ON
Indicator Light
Key
Release
AUX Key(for opening
the doors
and starting
the engine)
KEYLESS ENTRY SYSTEM
This system remotely locks and unlocks the doors and the trunk, and opens
the power windows and moon roof.
Release Button Push to extend key.
•
Push & fold to retract key.
• Lock
Push once to lock
•
all doors.
Push twice (within five
•
seconds) for horn sound
verification that both
doors are locked.
Unlock Push once to unlock
•
driver’s doors.
Push twice (within three
•
seconds) to unlock all doors.
Push twice and hold to open
•
front windows and moon roof.
Panic Alarm
Push for one second or
•
more to activate alarm.
Push Lock, Unlock,
•
Trunk or Panic Alarm
to turn alarm off.
Tr u n k
Push and hold to open trunk.
•
S TARTIN g ThE EN gINE
While Carrying the Advanced Key…
•
Start the engine by pushing the START/STOP button, while
pushing the clutch pedal (manual transmission) or the brake pedal
(automatic transmission).
• Shut the engine OFF by pushing the START/STOP button again.
•
Activate Accessories (ACC) by pushing the START/STOP button
once without pushing the clutch or brake pedal.
• The key indicator light
will show g REEN when the advanced key
is detected and the brake pedal is pushed. The engine is ready to start.
The indicator flashes RED (for 3 seconds) when the key is not detected
or if the advanced keyless transmitter battery is dead. If illuminated
RED , the push button start may not start the engine, unless the
auxiliary key is used.
With the Auxiliary Key…
1 To start engine, locate the key slot cover on the
steering column and remove the cover.
2 Insert the auxiliary key into the key slot, then push the START/STOP
button with the clutch pedal (M/ T) or the brake pedal (A / T) pushed
down to start the engine.
ADVANCED KEYLESS ENTRY SYSTEM
•
This system allows you to lock /unlock the
doors, open the trunk lid and start the
engine without taking the key out.
While Carr ying the Advanced Key…
• Unlock the driver’s door by gently
grasping and pulling the door handle after
the beep sound is heard. The sensor on the
back side of the door handle will sense the
motion of your hand and unlock the door.
NOTE: If the door handle is pulled too quickly
(before door is unlocked), the door may not
open. Pull the door handle again to open.
• Unlock all doors by pushing the inner door
lock switch after opening the driver’s door.
• Open the trunk by pushing the trunk
request switch.
• Lock all doors by pushing the driver’s door
or passenger door request switch once.
• Open the front windows and moon roof
by pushing the unlock button on the
advanced keyless entry transmitter and then
pushing again and holding; release to stop.
• Close front windows and moon roof
by pushing and holding the driver’s door
request switch; release to stop.
180567_10a_Mazda6_SSG_050709.indd 2-35/7/09 9:43:57 AM

Feature Highlights
910
LIgh TIN g CONTROL/TURN SI gNAL LEVER WINDShIELD WIPER/WAS hER CONTROL LEVER
Pull
to Flash
h igh Beams Push for

h igh Beams
: Turns tail, parking, dashboard,
and headlights on.
AUTO: The light sensor
automatically determines
when to turn the
headlights on or off.
: Turns fog lights
on only when headlights
are on.
:
Turns tail, parking,
and dashboard lights on.
AUTO: The rain sensor senses the amount of rainfall and turns the wipers
on or off. Rotate ring away from you (clockwise) for less sensitivity and
towards you (counterclockwise) for more sensitivity.
N O T E :
Vehicles not equipped with AUTO wipers will have INT wipers. Set the lever
to INT and choose an interval timing by rotating the ring between fast and slow.
AUTO(auto wipers)
OFF
MIST(single swipe)
LO (low
speed wipers)
HI (high
speed wipers)
Pull lever
to dispense
washer fluid
- More sensitive
+ Less sensitive
180567_10a_Mazda6_SSG_050709.indd 10-115/7/09 9:45:48 AM

Feature Highlights
AUTO -DIMMIN g MIRRORS AND hOME LINK®
•
Auto-dimming automatically
darkens your rearview
mirror and both outside
door mirrors to reduce
headlight glare from the
vehicles behind you.
• Auto-dimming is activated
every time the vehicle
is started.
NOTE:

•
Both door mirrors will appear to have a halo, or ring, around the outer edge of
the mirror surface. This is actually the electrical circuitry that allows the mirrors
to dim. This is normal operation of the mirrors.

• In addition to the auto-dimming mirror’s front light sensor, there is also a
rear light sensor (not shown). Do not place or hang any objects over the front
or rear mirror light sensors; other wise, the auto-dimming mirrors will not
operate properly.
homeLink®
•
This feature provides a convenient way to replace up to three
transmitters such as garage door openers, home lighting remotes
and other radio frequency devices.
• Refer to your Owner’s Manual for complete programming details.
Auto-Dimming Mirrors
Auto-Dimming
Indicator LightAuto-Dimming
On
homeLinkLight

SensorAuto-Dimming
Off
On Off
6-SPEED MANUAL TRANSMISSION
Push the clutch pedal down completely
•
to start the engine and to shift gears.
To place the transmission in Reverse,
•
place shifter in the neutral position,
push the shifter down, move to the left
and push forward.
Your aluminum wheels have a protective
coating on them. Only use a mild soap or
neutral detergent with a sponge or soft cloth
to clean them. Using a wire brush, polishing
compound, solvent, or any type of abrasive
cleaner may damage the protective coating.
ALUMINUM WhEEL CARE
Lower
gear
h igher
g ear
11 12
SPORT AT MANUAL Sh IFT MODE
The Sport AT Manual Shif t Mode gives you
the feel of driving a manual transmission
by allowing you to manually shif t to control
engine rpm and torque when more control
is desired.
To Use Manual Shift Mode:
• Shift lever from D to M.
NOTE:
Changing to manual mode
can be done while driving the vehicle.
To Shift Up To A Higher Gear:
• Tap shift lever back (+) once.
To Shift Down To A Lower Gear:
• Tap shift lever forward (-) once.
Neutral
Position
180567_10a_Mazda6_SSG_050709.indd 12-135/7/09 9:46:36 AM

Feature Highlights
13
NOTE: Do not rely completely on the BSM system and be sure to look over
your shoulder before changing lanes:
• The BSM system can assist the driver in confirming the safety of the surroundings,
but is not a complete substitute.
• The driver is responsible for ensuring safe lane changes and other maneuvers.
• Always pay attention to the direction in which the vehicle is traveling and the
vehicle’s surroundings.
• The BSM system does not operate when the vehicle speed is lower than about
20 mph (32 km/h).
Turning BSM System Off
To manually turn the BSM system off, push the BSM OFF switch on the dash.
The BSM OFF indicator will illuminate in the instrument cluster when the BSM
system is off. The BSM system will automatically turn on the next time the
vehicle is started.
14
Your Vehicle
Detection Areas
PORTABLE AUDIO PL AYER INTE gRAT ION
USIN g ThE AUX JACK
Your vehicle is equipped with an AUX or auxiliary jack
that will allow you to play your portable audio player
through the vehicle’s audio system. Learn the system
when parked and do not let it distract you while driving.
Refer to the Owner’s Manual for additional information.
NOTE: You will need a cable with an 1/8 inch mini stereo
plug to connect your portable audio player into the aux jack.
1 Locate the AUX jack inside the center console.
2 Plug 1/8 inch mini stereo plug into the portable
audio player and into the AUX jack. Turn portable audio player on.
3 Turn the vehicle audio system on.
4 • Without Navigation System: Push AUX (or CD/AUX) button on
audio system OR push MODE button on steering wheel controls until
“AUX” is displayed.
• With Navigation System: Push SOURCE button on audio system,
then push AUX1 on screen OR push M ODE button on steering wheel
controls until “AUX1” is displayed.
5 Use the portable audio player controls to play music.
NOTE: Set the volume level on your por table audio player to the highest level before distortion starts. Then adjust the volume in the vehicle using the audio system
power/volume control or the steering wheel volume up and down controls.
Temperature
Display
(Driver)
Audio
INFORMATION DISPLAY
Temperature
Display
(Passenger)Trip Computer/
Clock
Climate
Control
B LIND S POT MONITORIN g (BSM) SYSTEM
The Blind Spot Monitoring (BSM) system is designed to assist the driver
by monitoring the blind spots to the rear of the vehicle on both sides.
• If your vehicle speed is 20 mph (32 km/h) or more, the BSM will warn
you of vehicles in the detection area by illuminating the BSM warning
lights located on the left and right door mirrors.
• If you operate a turn signal in the direction of an illuminated BSM
warning light, the system will also warn you with a beep and warning
light flash.
• BSM sensors are located under the left and right rear bumper areas.
The BSM system may not operate properly if the rear bumper gets too
dirty, so keep the rear bumper area clean.
Please refer to your Owner’s Manual for complete details.
180567_10a_Mazda6_SSG_050709.indd 14-155/7/09 9:47:16 AM