Mercury Villager 1996 Owner's Manuals

Instrument Panel Controls
111
*
[IP10820(ALL)06/95]
The defroster will turn off when the ignition key is turned to
the OFF or START position.
*
[IP10830(ALL)06/95]
Never use sharp instruments or abrasive window cleaners to
clean the inside of your rear window. If you do, you may
damage the wires that are bonded to the inside of the rear
window, and cause damage to the rear window defogger.
[IP10840(ALL)06/95]
Rear Wiper and Washer
[IP10850(ALL)04/95]
The controls for the rear wiper and washer can also be found
on the instrument panel to the right of the instrument cluster.
The rear wiper and washer controls operate with the ignition in
the ACC and ON positions.
[IP10900(ALL)06/95]
13-1/2 pica
art:0040080-D
Rear wiper and washer switch locations
[IP10950(ALL)04/95]
To turn on the rear wiper, press the RR WIPER switch. The
wiper will operate until it is turned off. The wiper will complete
one cycle every 10 to 15 seconds. To turn off the rear wiper,
press the RR WIPER switch a second time.
File:06vxipn.ex
Update:Mon Jun 3 14:33:05 1996

112
[IP11000(ALL)04/95]
To activate the rear washer, press the RR WASH switch. For a
constant spray, hold the switch for a few seconds. For less
washer fluid, press the switch once and release it. When you
activate the washer, the wiper will cycle twice and then stop.
*
[IP11050(ALL)04/95]
Do not activate the washer for longer than fifteen seconds
continuously. This could damage the washer pump system.
*
[IP11100(ALL)04/95]
Hazard Flasher Switch
*
[IP11150(ALL)04/95]
The hazard flasher is used to alert other drivers to hazardous
situations.
*
[IP11200(ALL)09/93]
The hazard flasher switch operates the same lamps as the turn
signal lever. When the hazard flasher is activated, all of these
lamps will flash on and off. The turn signal indicators cannot be
used when the hazard lamps are flashing. Operation of the
hazard flashers does not affect operation of the brakelamps.
*
[IP11300(ALL)12/93]
The flashers work even with the key out of the ignition. The
flashers will work for up to two hours when the battery is fully
charged and in good condition. They will not drain the battery
excessively. If the flashers run for longer than two hours or if
your battery is not fully charged, your battery may be drained
to the point where the vehicle will not start.
[IP11400(ALL)01/93]
The hazard flasher switch is located on the instrument panel to
the right of the instrument cluster.
*
[IP11500(ALL)09/93]
To use the hazard flasher:
*
[IP11600(ALL)02/94]1.
Push the HAZARD switch; you will see the turn signal
arrows flash.
*
[IP11700(ALL)09/93]2.
To stop the hazard flashers, push the HAZARD switch again.
File:06vxipn.ex
Update:Mon Jun 3 14:33:05 1996

Instrument Panel Controls
113
[IP11800(ALL)06/95]
13-1/2 pica
art:0040078-D
Hazard flasher switch location
[IP12100(ALL)01/93]
Interior and Exterior Lights
*
[IP12200(ALL)01/94]
To turn on the headlamps, parking lamps, marker lamps, tail
lamps and instrument panel lights, use the headlamp control
knob, to the left of the instrument cluster.
*
[IP12300(ALL)01/93]1.
Turn the headlamp knob to the first position to turn on the
parking lamps, tail lamps, license plate lamps, marker lamps
and instrument panel lights.
*
[IP12400(ALL)05/95]2.
Turn the headlamp knob to the second position to turn on
the headlamps in addition to the parking lamps, tail lamps,
license plate lamps, marker lamps and instrument panel
lights.
File:06vxipn.ex
Update:Mon Jun 3 14:33:05 1996

114
[IP12500(ALL)09/93]
13-1/2 pica art:0040074-E
The headlamp control knob
[IP12600(ALL)01/93]
A chime will sound if any of the exterior lamps are on when
the driver's door is opened.
%*
[IP12625(ALL)05/95]
Cleaning the Exterior Lamps
*
[IP12650(ALL)05/95]
Do not use dry paper towel, chemical solvents or abrasive
cleaners to clean the lamps, as these may cause scratches or
crack the lamps.
%*
[IP12700(ALL)01/93]
Daytime Running Light (DRL) System
(Canadian vehicles only)
*
[IP12800(ALL)03/95]
The Daytime Running Light (DRL) system turns the high beam
headlamps on, with a reduced light output, when:
*
[IP12900(ALL)01/93]
n
the vehicle is ªrunningº
*
[IP13000(ALL)01/93]
n
the vehicle has a fully released parking brake
*
[IP13100(ALL)01/93]
n
the headlamp system is in the OFF position
*
[IP13200(ALL)01/93]
NOTE: You may notice that the lights flicker when the engine
is turned on or off. This is a normal condition.
File:06vxipn.ex
Update:Mon Jun 3 14:33:05 1996

Instrument Panel Controls
115
*
[IP13300(ALL)05/95]
RWARNING
The Daytime Running Light (DRL) system will not
illuminate the tail lamps and parking lamps. Turn on
your headlamps at dusk. Failure to do so may result in a
collision.
*
[IP13400(ALL)01/93]
Lighting Up the Instrument Panel
[IP13500(ALL)01/93]
The instrument panel lights can be turned on by turning the
headlamp control knob to either the first or second position.
You can brighten or dim the instrument panel lights with the
DIM switch. The DIM switch is located near the headlamp
controls.
[IP13600(ALL)01/93]
Pushing and holding the right side of the switch will continue
to brighten the lights until the maximum brightness is reached.
Release the switch to maintain the desired brightness. The DIM
feature works similarly to dim the instrument panel lights when
the left side of the switch is pushed.
[IP13700(ALL)06/94]
7-1/2 pica art:0040076-B
The instrument panel brightness control
File:06vxipn.ex
Update:Mon Jun 3 14:33:05 1996

116
[IP13800(ALL)09/93]
Autolamp On/Off Delay System (If equipped)
*
[IP13900(ALL)02/95]
The autolamp sets the headlamps to turn on and off
automatically. You can use the autolamp to:
*
[IP14000(ALL)09/93]
n
turn on the headlamps automatically at night
*
[IP14100(ALL)09/93]
n
turn off the headlamps automatically during daylight
[IP14200(ALL)01/93]
n
keep the headlamps on for approximately three minutes after
you turn the key to OFF.
*
[IP14300(ALL)01/95]
To set the autolamp:
[IP14400(ALL)02/94]1.
Make sure the headlamp control knob is in the OFF position.
If the knob for the headlamps is on, the autolamp system is
canceled.
[IP14500(ALL)04/94]2.
Turn the ignition key to ON to start your vehicle.
[IP14600(ALL)01/93]3.
Use the autolamp thumbwheel to activate the autolamp
feature. It is located to the left of the instrument cluster. The
white mark indicates the approximate center of the
thumbwheel.
File:06vxipn.ex
Update:Mon Jun 3 14:33:05 1996

Instrument Panel Controls
117
[IP14700(ALL)09/93]
13-1/2 pica
art:0040077-B
Autolamp thumbwheel location
[IP14800(ALL)01/93]4.
Move the thumbwheel all the way to the right. The
autolamp will automatically turn the lamps on and off.
[IP14900(ALL)01/93]
NOTE: Be sure that you do not put anything on top of the
photodiode located in the top right side of the
instrument panel speaker grille. The photodiode
controls the autolamp; if it is covered, the photodiode
reacts as if it is nighttime, and the headlamps will be
illuminated.
File:06vxipn.ex
Update:Mon Jun 3 14:33:05 1996

118
[IP15000(ALL)09/93]
13-1/2 pica
art:0040081-B
Autolamp photodiode location
[IP15100(ALL)01/93]
To turn the autolamp off, move the thumbwheel all the way to
the left.
[IP15200(ALL)04/95]
You can set the autolamp so the headlamps stay on for
approximately three minutes after you turn off your ignition.
The farther the thumbwheel is moved to the right, the longer
the headlamps stay on.
[IP15300(ALL)01/93]
The chime will sound when the autolamp system turns the
headlamps on and the driver's door is open.
[IP15400(ALL)01/93]
Interior Lamps
[IP15500(ALL)07/93]
The front dome lamp is located overhead between the driver
and front passenger seats. However, if your vehicle is equipped
with a power sun roof, the dome lamp is located behind the
driver's seat.
[IP15600(ALL)01/93]
The rear dome lamp is located overhead near the rear seating
positions.
File:06vxipn.ex
Update:Mon Jun 3 14:33:05 1996

Instrument Panel Controls
119
[IP15700(ALL)09/93]
10-1/2 pica
art:0040075-D
The dome lamp switch positions
[IP15800(ALL)07/93]
Either dome lamp will stay illuminated if the switch is pushed
to the ON position. The dome lamps will stay off if the switch
is pushed to the OFF position. When the switch is positioned to
the door/middle position, the dome lamps will come on when
either of the front doors or the sliding door is opened. The front
dome lamp, footwell lamps, and the sliding door step lamp
have a time delay feature and will gradually dim within about
15 seconds.
[IP15900(ALL)03/95]
The rear dome lamp also illuminates when the liftgate is opened
and goes off when it is closed. However, the rear dome lamp
will not remain lit in the ON position unless the ignition switch
is in the ON position. This feature is intended to help avoid a
run-down battery which can occur when a light is left on
unintentionally.
[IP15950(ALL)02/95]
If the vehicle doors are not fully closed and the interior lamps
remain illuminated, they will eventually turn off automatically
to prevent the battery from becoming discharged. Lamps that
illuminate when the front doors and the sliding door are open
will turn off after approximately 30 minutes. Lamps that are
illuminated when the liftgate is open will turn off after
approximately 60 minutes.
File:06vxipn.ex
Update:Mon Jun 3 14:33:05 1996

120
*
[IP16000(ALL)04/95]
Illuminated Entry System (If equipped)
[IP16100(ALL)06/95]
If your vehicle is equipped with this option, the interior
courtesy lamps (footwell, stepwell, and dome lamps) will light
when either of the front doors or the sliding door is opened. If
you have the optional Keyless Entry System the lamps will also
light whenever any keypad or remote keyless entry transmitter
button is pressed. One of the stepwell lamps is located near the
sliding door entrance and there is one on each front door. The
footwell lamps are located below the instrument panel near the
driver's and front passenger's feet. When the liftgate is opened,
the optional liftgate lamp, rear dome lamp and sliding door
stepwell lamp are illuminated.
[IP16200(ALL)01/93]
The lamps that have the time delay feature will automatically
dim until they turn completely off approximately 15 seconds
after the doors are closed. When the key is placed in the
ignition and turned to the ON position, the lamps will turn off.
[IP16300(ALL)09/93]
Overhead Map Lamps (If equipped)
[IP16400(ALL)01/93]
The power sunroof overhead console also contains the overhead
map lamps.
[IP16500(ALL)09/93]
10-1/2 pica
art:0040082-A
The overhead map lamps
File:06vxipn.ex
Update:Mon Jun 3 14:33:05 1996