MITSUBISHI iMiEV 2016 1.G Owners Manual

Dinghy towing
Driving safety 6-11
6
CAUTION Your vehicle is not
designed to be dinghy
towed behind a motor home. Dinghy towing can cause damage to the elec- tric motor unit. Damage caused by dinghytowing will not be covered by the vehicle warranty.
BK0220401US.book 11 ページ ２０１５年６月３日　水曜日　午前７時４２分

BK0220401US.book 12 ページ ２０１５年６月３日　水曜日　午前７時４２分

7
Comfort controlsVents ................................................................................................7-2 Air conditioning ..........
...........
...........
...........
...........
...........
.........
.....7-4
Important air conditioning operating tips ..
...........
...........
.........
.....7-10
Air purifier ..................................................................................... 7-11 Remote Climate Control ................................................................ 7-11 AM/FM electronically tune
d radio with CD player
(if so equipped) .......................................................................... 7-11 To play iPod/USB memory devi
ce tracks via
voice operation
(vehicles with Bluetooth
® 2.0 interface) ...................................7-20
Steering wheel audio remote control
switch (if so equipped) ........7-22
Error codes .....................................................................................7-24 Handling of compact discs .............................................................7-25Antenna ..........................................................................................7-27 Clock (if so equipped) ....................................................................7-27 General information about your radio .....
...........
...........
...........
.....7-28
BK0220401US.book 1 ページ ２０１５年６月３日　水曜日　午前７時４２分

Vents 7-2 Comfort controls
7
N00729900265 N00730200314
Adjust the direction of the air flow by moving the knob (A) and vent.
When the dimple (A) is pressed, the vent opens.To close the vent, press the dimple (B) on the opposite side.
N00736400581
To change the position and amount of air flowing from the vents,
turn the mode selec-
tion dial. Refer to “Mode selection dial” on page 7-5. These symbols are used
in the next several
illustrations to demonstrate the quantity of air coming from the vents. : Small amount of air from the vents: Large amount of air from the vents
Ve n t s 1- Center vents 2- Side vents
NOTE
 Do not place beverages on top of the instru- ment panel. If they splash into the air condi- tioning vents, they coul
d damage the system.
Air flow and direction adjust- ments Center vents
1- Left-right adjustment 2- Up-down adjustmentSide vents
NOTE
 On rare occasions, air from the vents of an air-conditioned vehicle
may be foggy. This is
only moist air cooling suddenly and does notindicate a problem.  Do not let drinks or ot
her liquids get into the
vents as they could pr
event the air condition-
ing from operating normally.
Changing the mode selection
BK0220401US.book 2 ページ ２０１５年６月３日　水曜日　午前７時４２分

Vents
Comfort controls 7-3
7
Air flows only to the upper part of the passen- ger compartment. Air flows to the upper part of the passenger compartment, and flows to the leg area.
Air flows mainly to the leg area.
Air flows to the leg area, the windshield and the door windows.
Face position Foot/Face position
NOTE
 With the mode select
ion dial between the
“ ” and “ ” positions, air flows mainly to the upper part of the passenger compart-ment. With the mode se
lection dial between
the “ ” and “ ” positions, air flows mainly to the leg area.
Foot position
Foot/Defroster position
NOTE
 With the mode select
ion dial between the
“ ” and “ ” positions, air flows mainly to the leg area. With the mode selection dial between the “ ” and “ ” positions, air flows mainly to the windshield and door windows.
BK0220401US.book 3 ページ ２０１５年６月３日　水曜日　午前７時４２分

Air conditioning 7-4 Comfort controls
7
Air flows mainly to the windshield and the door windows.
N00730300328
The air conditioning can only be used when the ready indicator is illuminated.
N00730501314
Defroster position Air conditioning
NOTE
 If the energy level gauge is at 0 bars or the power down warning light
illuminates, the
vehicle interior may
not be cooled/heated
even though the dial or switch is operated. Furthermore, the defog performance may bealso reduced. Refer to “Energy leve
l gauge” on page 5-41.
Refer to “Power down warning light” onpage 5-46.
Control panel A- Temperature control dial B- MAX switch C- Blower speed selection dial D- Air conditioning switchE- Mode selection dial F- Air selection switch
NOTE
 There is an interior air temperature sensor (G) in the illustrated position.Never place anything ov
er the sensor, since
doing so will prevent it from functioning properly.
BK0220401US.book 4 ページ ２０１５年６月３日　水曜日　午前７時４２分

Air conditioning
Comfort controls 7-5
7
N00736500191
When the electric motor switch is in the “ON” position, select the blower speed by turning the blower speed selection dial.Turning the dial clockwise will increase the blower speed; turning the dial c
ounterclockwise will
decrease it. When the dial is set to the “OFF” When the dial is set to the “AUTO” position, the air flow is adjusted automatically accord- ing to the temperature of the interior and theposition of the temperature control dial.
N00736600235
Use this dial to adjust the temperature of the air flow from the vents. Turn the temperature control dial clockwiseto make the air warmer. Turn it counterclock- wise to make the air cooler. When the dial is set to middle (
) position,
only uncooled and unheated air will flow. When the dial is moved to middle (
) posi-
tion when using cooling or heating, cooling or heating stops.
N00736700210
To change the position and amount of air flowing from the vents, turn the mode selec-tion dial. Refer to “Changing the mode selec- tion” on page 7-2.
Blower speed selection dial
Temperature control dial
NOTE
 When the dial is moved from middle (
)
position to the left while the air conditioning is not operating, the ai
r temperature will not
change.
 When the dial is moved to middle (
) posi-
tion and then to the left while the air condi-tioning is operating,
the air conditioning
system is operating again.  When the temperature control dial is set to “C” position, the air se
lection will be auto-
matically set to the re
circulation position and
the air conditioning will operate.When the dial is moved thereafter, the air conditioning continues to
operate and the air
selection setting returns to the setting beforethe dial was set to “C” position.
Mode selection dial
NOTE
BK0220401US.book 5 ページ ２０１５年６月３日　水曜日　午前７時４２分

Air conditioning 7-6 Comfort controls
7
The vents change to the following positions according to the position of the temperaturecontrol dial. Refer to “Temperature
control dial” on page
7-5.
N00736800400
Normally, use the outside
air position to keep
the windshield and side windows clear and to quickly remove fog or frost from the wind- shield. To change the air selection, simply press the air selection switch.  Outside air {Indicator light (A) OFF} Outside air is introduced into the passen- ger compartment. Recirculated air {Indicator light (A) ON} Air is recirculated
inside the passenger
compartment.
If high cooling performance is desired, or, if the outside air is dusty
or contaminated in
some way, use the
recirculat
ion position.
Switch to the outside
air position every now
and then to keep the windows from foggingup.
“AUTO” positionTemperature control
dial position
Ve n t s
Between “C” and mid-
dle(
)
: Upper part
of front passen- ger compart-
ment
Mid- dle(
)
Set the dial to middle (
)
from the “C”
: Upper part
of front passen- ger compart-
ment
Set the dial to middle (
)
from the “H”
: Leg area
Between middle ( ) and “H”
Near middle
( )
: Leg area
Near “H”
windshield, and door windows
CAUTION When using the mode se
lection dial between
the “ ” and “ ” positions, prevent fog- ging by pressing the air selection switch toselect outside air. (Refer to “Air selection switch

Air conditioning
Comfort controls 7-7
7
N00731000465
Push the switch, and the air conditioning compressor will turn on. The air conditioning indicator light (A) will come on. Push the switch again and the air condition- ing compressor will stop and the indicatorlight (A) goes off.
N00766500015
When the blower speed selection dial is notOFF and the MAX switch is pressed, the indi- cator light (A) illumina
tes and cooling/heat-
ing performance and
the air conditioning
setting is changed according to the tempera- ture control dial position. When the switch is pr
essed again, the opera-
tion returns to the mode before pressing the switch.
The heating capability is at maximum. The air flow is at maximum. The air conditioning au
tomatically operates
and the cooling capabi
lity is at maximum.
N00731101290
1. Set the mode selection dial to the “ ” 2. Set the air selection switch (A) to the out- side position.3. Turn the temperature control dial clock- wise or counterclockw
ise to the desired
temperature between middle (
) and “H”
position. 4. Select the desi
red blower speed.
Air conditioning switch MAX switch
When the temperature control dial is set between middle ( When the temperature control dial is in middle (
) position
When the temperature control dial is set between

Air conditioning 7-8 Comfort controls
7
1. Set the mode selection dial to the “ ”
2. Set the air selection switch (A) to the out- side position.3. Turn the temperature control dial clock- wise or counterclockwise to between mid- dle (
) position and