radio antenna MITSUBISHI LANCER EVOLUTION 2007 Service Repair Manual

INDEX - In order of parts nameC-19
Wiring diagram
page Circuit diagram page Connector
No. Parts name
PPurge control solenoid valveB-23B-91,99B-11,15
RRadiator fan relayA-09XB-73,102,176,182B-6,8
Rear combination lamp (LH)F-16B-110,114,126,134,138,143,144,145B-38,39
Rear combination lamp (RH)F-09B-111,115,129,134,138,142,144,145B-38,39
Rear fog lamp relayC-219B-54,55,126,129B-23,29
Rear room lampD-05B-118,122B-30,32
Remote controlled mirror (LH)E-02B-192,193B-34,36
Remote controlled mirror (RH)E-13B-192,193B-34,36
Remote controlled mirror switchC-138B-192,193B-21,27
ResistorB-138B-89,97B-13,17
ResistorC-16B-174,180B-18,24
Roof antennaC-141B-196B-21,27
Roof wiring harness (RH) and J/B
combinationC-218B-54,55,118,119,122,123B-23,29
Room lampD-03B-118,122B-30,32
SSeat belt pretensioner (LH)D-28B-249,251B-31,33
Seat belt pretensioner (RH)D-26B-249,251B-31,33
Secondary air control solenoid valveB-142B-91,99B-13,17
Side turn signal lamp (LH)A-02B-134,138B-6,8
Side turn signal lamp (RH)A-01B-135,139B-6,8
Spare connector (for front fog lamp
relay)A-04XB-73,258B-6,8
Spare connector (for front fog lamp
switch)C-101B-258B-20,26
Spare connector (for front fog lamp)A-31B-258B-7,9
Spare connector (for radio)C-104B-196,197B-20,26
Spare connector <for front door
speaker (LH)>E-04B-196B-34,36
Spare connector <for front door
speaker (RH)>E-21B-196B-35,37
Spare connector <for rear speaker
(LH)>F-01B-197B-38,39
Spare connector <for rear speaker
(RH)>F-08B-197B-38,39
SRS-ECUC-21B-248,249,250,251B-18,24

CHASSIS ELECTRICAL -Pole Antenna54A-41
POLE ANTENNA
REMOVAL AND INSTALLATION
3 1
2
4
5
Removal steps
A
A"1. Antenna base
2. Radio plug
3. Knob assembly
4. Center panel assembly (Refer to
GROUP 52A - Instrument Panel.)DInstrument under cover (Refer to
GROUP 52A - Instrument Panel.)
DInstrument panel (Refer to GROUP
52A.)
5. Antenna feeder cable
REMOVAL SERVICE POINT
AA"ANTENNA BASE REMOVAL
Use the following steps to easily route antenna feeder cable
in the event of installation:
1. Tie string at the top end of feeder cable.
2. Pull out feeder cable until pipe end of antenna base is visible.
3. Insert string into the hole at pipe end of antenna base,
and wrap vinyl tape on the string.
Caution
Tape should be wrapped so that the string cannot
be removed.
4. Gradually pull out remove antenna base.
Hole
Tape
Junction block
String
String