sunroof MITSUBISHI LANCER EVOLUTION X 2008 Workshop Manual

HEADLINING
TSB Revision
INTERIOR52A-15
HEADLINING
REMOVAL AND INSTALLATIONM1521001400973
Pre-removal and Post-installation Operation
•Removal and Installation of Front Pillar Trim, Upper Cen-
ter Pillar Trim, Rear Pillar Trim (Refer to P.52A-10).
•Removal and Installation of Instrument Under Cover
(Refer to
P.52A-6).
AC609656
2
6
1
1
1
1
3 4
45
5
7
7
8
8
9 8
9 10
10
8
AB
A
A
Section A – AClip
Claw
8
3
<Vehicles without sunroof>
<Vehicles with sunroof>
Note
(1) : Clip positions
(2) : Claw positions

HEADLINING
TSB Revision
INTERIOR52A-16
Required Special Tool:
•MB990784: Ornament Remover
REMOVAL SERVICE POINTS
.
<<A>> SUN VISOR HOLDER REMOVAL
Insert the special tool MB990784 into side claws of the sun
visor holder through the both sides of the sun visor holder to
remove the hinges.
.
<<B>> HEADLINING ASSEMBLY REMOVAL
To remove the clip, insert a vinyl cord into a clearance between
the clip and the headlining, and pass it around the clip. Then,
pull out the clip downwards while pulling the vinyl cord.
Removal steps
1.Assist grip
2.Rear dome light assembly <Vehicles
without sunroof>
3.Front dome light
4.Sun visor assembly
<<A>>5.Sun visor holder
6.Sunroof lid inner weather strip rear
<Vehicles with sunroof>
<<B>>7.Headlining
8.Assist grip bracket
9.Front side roof energy absorption box
<Vehicle with sunroof>
10.Rear side roof energy absorption box
<Vehicle with sunroof>
Removal steps (Continued)
AC005512
MB990784
MB990784
Sun visor holder
AF
AC600751AD
Clip
Headlining Vinyl cord