display PEUGEOT 1007 2008 Owner's Guide (189 Pages)

4
85
The tank must be ﬁ lled with fuel with

the engine off.

 Open the fuel ﬁ ller ﬂ ap.

 Insert the key then turn it to
the left.

 Remove the cap and attach it to
the clip located on the inside of
the ﬂ ap.
A label on the inside of the ﬂ ap
indicates which type of fuel to use.
If you ﬁ ll your tank, do not continue
after the third cut-off of the pump
nozzle. This could result in vehicle
malfunctions.

The capacity of the tank is appro-
ximately 9 gallons (40 litres).

 After ﬁ lling the tank, lock the cap
and close the ﬂ ap.

You have enough fuel left to cover
approximately 30 miles (50 km).
The electric opening of the
left-hand door is inhibited
when the fuel ﬁ ller ﬂ ap is
open.
The key cannot be removed from the
cap’s lock until the cap is reﬁ tted on
the tank. FILLING THE FUEL TANK
When the tank’s minimum
level is reached, this war-
ning light comes on, accom-
panied by a message on the
multifunction display.
Low fuel level

5
86
LIGHTS STALK
Lights off Automatic switching on
of lights.
Side lights Dipped/main beam
headlamps Dipped/Main beam change
Pull the stalk fully towards you.
Front fog lamps and rear fog
lamp
Rotate the ring
B or C forwards to
switch on and backwards to switch
off. The status is displayed by the in-
dicator light on the instrument panel.
Vehicles ﬁ tted with a rear fog
lamp (ring B)
Rear fog lamp
Vehicles ﬁ tted with front fog
lamps and a rear fog lamp (ring C) Front fog lamps (1st rotation
of the ring forwards)
These operate with the side lights
and dipped headlamps.
Lights on
With the ignition off, a buzzer sounds
when the driver’s door is opened, if
you have left your lights on.
If the dipped headlamps remain
on, with the ignition off, they will be
switched off automatically after thirty
minutes maximum to prevent dis-
charging of the battery.
This can only operate with the dipped
and main beam headlamps.
Front and rear lights
Selection is by turning ring
A .

5
88
Daytime lights *
On vehicles which are equipped with
daytime lights, the dipped headlamps
come on when the vehicle is started.
Automatic switching on of
lights
The side lights and dipped beam
headlamps switch on automatically if
the light is poor and when the wind-
screen wipers operate continuously.
They switch off when the light be-
comes bright enough or the wind-
screen wipers are switched off.

In foggy weather or in
snow, the brightness
sensor can detect sufﬁ -
cient light, the lights will
not come on automati-
cally.

Do not cover the brightness sen-
sor, coupled with the rain sensor,
located in the centre of the wind-
screen behind the interior mirror.
It is used for automatic switching
on of the lights.
Coupling with the Follow Me
Home lighting
The association with the automatic
lighting function provides the follow
me home lighting with the following
additional options:
- selection of maintaining of the lighting for a duration of 15, 30
or 60 seconds in the vehicle pa-
rameters of the multifunction dis-
play conﬁ guration menu (except
in the case of the monochrome
display A for which the duration
is pre-set),
- automatic activation of the fol- low me home lighting when the
automatic lighting function is in
operation.
Activation
Turn the lighting control to the
"
AUTO " position.
Disarming
Turn the lighting control to a position
other than " AUTO ".
Operating fault
If the brightness sensor does not
function correctly, the lights come on
accompanied by the service warning
light, an audible signal and a mes-
sage on the multifunction display.
Consult a PEUGEOT dealer. Operating fault
If the brightness sensor does not
function correctly, the lights come on
accompanied by the service warning
light, an audible signal and a mes-
sage on the multifunction display.
Contact a PEUGEOT dealer.
Do not cover the brightness
sensor, coupled with the rain
sensor, located in the centre
of the windscreen behind
the interior mirror; the as-
sociated functions would no
longer be controlled.
This warning light comes on
on the instrument panel.
The instruments and controls (instru-
ment panel, multifunction display,
air conditioning control panel, ...)
are only lit on switching to the auto-
matic switching on of the lights mode
or when the lights are switched on
manually.
* According to country.

5
90
Windscreen wash
Pull the wiper stalk towards you. The
windscreen wash, then the wind-
screen wipers, operate for a speci-
ﬁ ed time.
Low wash-wipe/headlamp wash
ﬂ uid level
On vehicles ﬁ tted with headlamp
washers, this is indicated by an audi-
ble signal or a message on the multi-
function display.
This information is given each time
the front or rear wash-wipe control is
operated, until the reservoir is ﬁ lled.
When you stop, ﬁ ll the wash-wipe/
headlamp wash reservoir or have it
ﬁ lled. Do not cover the rain sen-
sor located on the wind-
screen behind the interior
mirror.
When using an automatic car wash,
switch off the ignition.
In winter, it is advisable to wait for the
windscreen to completely clear of ice
before operating the automatic wipe.
Rear windscreen wiper
Turn ring A to the ﬁ rst notch
for intermittent wiping.
When reverse gear is engaged, if the
windscreen wipers are in operation,
the rear wiper will start wiping.
Turn ring A past the ﬁ rst
notch; the windscreen wash
then the windscreen wiper
operate for a ﬁ xed period.
Automatic windscreen wipers
In
AUTO mode, the windscreen wip-
ers operate automatically and adapt
their speed to the intensity of the
rainfall .
Activation
Activation of the function is accom-
panied by a message on the multi-
function display.

The automatic windscreen wipers
function must be reactivated if the
ignition has been switched off for
more than one minute, by press-
ing the stalk downwards.
Deactivation
Deactivation of the function is ac-
companied by a message on the
multifunction display.
The function is deactivated when the
windscreen wipers stalk is moved to
position I , 1 or 2 .

In the event of malfunction of the
automatic windscreen wipers, the
windscreen wipers will operate in in-
termittent mode.
Contact a PEUGEOT dealer to have
the system checked.
Rear windscreen wash To activate or deactivate
this function, go to the
multi-function display
conﬁ guration menu.
If there is a signiﬁ cant ac-
cumulation of snow or ice
and when using a bicycle
carrier on the tailgate, deactivate the
automatic rear wiping by going to the
multifunction display conﬁ guration
menu.
Special position of the front
windscreen wiper
In the minute following switching off
of the ignition, any action on the stalk
positions the wipers in the centre of
the windscreen.
This action enables you to position
the wiper blades for winter parking,
cleaning or replacement (See corre-
sponding section).
To park the wipers after this has
been done, switch on the ignition and
operate the stalk.

6
92
HORN
Press one of the spokes of the stee-
ring wheel.
HAZARD WARNING LIGHTS
Press the button, the direction indica-
tors ﬂ ash.
They can operate with the ignition
off.
Automatic lighting of hazard
warning lights
When braking in an emergency, de-
pending on the force of deceleration,
the hazard warning lights come on au-
tomatically. They switch off automati-
cally the ﬁ rst time you accelerate.
It is also possible to switch them off
by pressing the button on the fascia.
TYRE UNDER-INFLATION DETECTION
Sensors ﬁ tted in each valve check
the pressure of the tyres while dri-
ving and trigger a warning in the
event of malfunction (speed above
12 mph (20 km/h)).
The tyre under-inﬂ ation detection
system is an aid to driving which does
not replace the need for the driver to
be vigilant or to drive responsibly.
Flat tyre This warning light comes
on on the instrument panel,
accompanied by an audible
signal and a message on the
multifunction display locating
the wheel concerned.

 Check the tyre pressures as
soon as possible.
This check must be carried out when
the tyres are cold.

6
93
This message is also dis-
played when one of the
wheels is away from the vehi-
cle (being repaired) or when
one or more wheels without
a sensor are ﬁ tted.
The spare wheel is not ﬁ tted with a
sensor.
All repairs and changing of
tyres on a wheel ﬁ tted with
this system must be carried
out by a PEUGEOT dealer.
If, when changing a tyre, you install
a wheel which is not detected by
your vehicle (example: ﬁ tting of snow
tyres), you must have the system
reinitialised by a PEUGEOT dealer.
Puncture
This warning light and the

STOP warning light come
on on the instrument panel,
accompanied by an audible
signal and a message on the multi-
function display locating the wheel
concerned.

 Stop immediately, avoiding
any sudden movement of the
steering wheel and the brakes.

 Change the damaged wheel
(punctured or very deﬂ ated
tyre), and have the tyre pressure
checked as soon as possible.
Sensor(s) not detected or faulty This warning light comes on
on the instrument panel, ac-
companied by an audible
signal and a message on the
multifunction display locating the wheel
or wheels which are not detected or in-
dicating a fault in the system.
Contact a PEUGEOT dealer to re-
place the faulty sensor(s). This system does not elimi-
nate the need to have the
tyre pressure checked regu-
larly (refer to the "Identiﬁ ca-
tion features" paragraph) to ensure
that the optimum dynamic perfor-
mance of the vehicle is maintained
and prevent premature wear of the
tyres, particularly in arduous driving
conditions (heavy load, high speed).
The tyre pressures must be checked
cold, at least once a month. Re-
member to check the pressure of the
spare wheel.
The tyre under-inﬂ ation detection
system may experience temporary
interference due to radioelectric
emissions on a frequency close to
that used by the system.

6
95
If this warning light comes on on
the instrument panel and the in-
dicator light on the button comes
on, this indicates that the ASR
and ESP systems are disarmed.
TRACTION CONTROL (ASR) AND DYNAMIC STABILITY CONTROL (ESP)
Operation of the ASR and ESP
systems The warning light ﬂ ashes if
the ASR or ESP is activated. Disarming
In exceptional conditions (starting a
vehicle which is bogged down, stuck
in snow, on soft ground, ...), it may
be advisable to disarm the ASR and
ESP systems, so that the wheels can
move freely and regain grip.

 Press the "ESP OFF" button,
located in the centre of the
fascia.
Reactivation
These systems are reactivated au-
tomatically each time the ignition is
switched back on or from 30 mph
(50 km/h).

 Press the "ESP OFF" button again
to reactivate them manually. Operating fault
If this warning light comes
on, accompanied by an au-
dible signal and a message
on the multifunction display,
this indicates a malfunction of these
systems.
Have the systems checked by a
PEUGEOT dealer.
The ESP/ASR systems offer excep-
tional safety in normal driving, but
this should not encourage the driver
to take extra risks or drive at high
speed.
The correct functioning of these
systems depends on observation of
the manufacturer’s recommenda-
tions regarding the wheels (tyres
and rims), the braking components,
the electronic components and the
PEUGEOT assembly and operation
procedures.
After an impact, have these systems
checked by a PEUGEOT dealer.
Activation of the ASR and ESP
systems
When the ignition is on, the ASR and
ESP systems are always active.
These systems are linked and com-
plement the ABS.
The ASR system optimises drive to
prevent the wheels skidding, by acting
on the brakes of the drive wheels and
on the engine. It also allows the direc-
tional stability of the vehicle to be im-
proved on acceleration.
If there is a variation between the tra-
jectory followed by the vehicle and
that required by the driver, the ESP
system automatically acts on the en-
gine and the brake of one or more
wheels, in order to put the vehicle
back on course, within the limits of
the laws of physics.

display PEUGEOT 1007 2008 Owner's Guide

Page 85 of 189

Page 86 of 189

Page 88 of 189

Page 89 of 189

Page 92 of 189

Page 93 of 189

Page 95 of 189

Page 96 of 189

Page 97 of 189

Page 99 of 189

PEUGEOT Manuals