Peugeot 107 Dag 2009 Manual Online

Page 81 of 99

9
72
PRACTICAL INFORMATION
3. Dipped headlamps/Main beam headlamps (H4 - 60/55 W)

 Disconnect the connector.

 Remove the rubber cap C .

 Push the side of the tongue D .

 Remove the bulb holder and
change the bulb.

 Refi t the bulb holder, the tongue
then the rubber cap.
If you encounter any diffi culties, con-
tact a PEUGEOT dealer.
Rear lamps

1. Brake/
sidelamps

(P21/5 W)

2. Direction indicators
(P21 W)

3. Reversing
lamp

(P21 W), right side These 3 bulbs are changed by remo-
ving the light unit:

 open the boot,

 unscrew the two light fi xing nuts A ,

 remove the light unit by pulling
outwards,

 unclip the harness,
Foglamp (P21 W), left side

Page 82 of 99

9
73
PRACTICAL INFORMATION Third brake lamp
(Four W 5 W bulbs)

 Unscrew the 2 fi xing bolts A .

 Release the lamp unit by pushing
the two tabs B inwards.

 Disconnect the connector and the
rear wash-wipe pipe.

 Remove the bulb holder.

 Remove the bulb and change it.
When refi tting, proceed in the reverse
order and ensure that the lamp unit
seal and the rear wash-wipe pipe have
been put back in place correctly.
Number plate lamps
(W 5 W)

 Pass your hand under the bumper.

 Remove the bulb holder turning it
one quarter of a turn.

 Remove the bulb and change it.
Do not tighten the bolts more
than is necessary at the risk
of breaking the light.

 remove the bulb holder by spread-
ing the four tongues B ,

 remove the bulb and change it.

Note: when refi tting, proceed in the
reverse order and take care to posi-
tion the bulb holder, the tongues and
the light unit correctly.

Page 83 of 99

9
74
PRACTICAL INFORMATION
DIRECTION INDICATOR SIDE REPEATERS (WY 5 W AMBER)

 Push the repeater forwards or
rearwards and detach it by pull-
ing towards you.

 Disconnect the bulb holder and
change it.
CHANGING A FUSE
The fuse boxes are located under the
instrument panel trim and next to the
battery in the engine compartment.

Correct
Removing and fitting a fuse
Before changing a fuse, the cause of
the incident must be found and recti-
fi ed.

 Use the pliers A located in the
fuse box under the bonnet.

Incorrect

Pliers A Instrument panel fuse boxes
These are located on each side of
the instrument panel under the trim.

 Turn the steering wheel to the
left, remove bolt B .

 Turn the steering wheel to the
right (do not forget to release the
steering wheel using the key),
remove bolt C .
Always replace a faulty fuse
with a fuse of the same rating
(same colour).

Page 84 of 99

9
74
PRACTICAL INFORMATION
DIRECTION INDICATOR SIDE REPEATERS (WY 5 W AMBER)

 Push the repeater forwards or
rearwards and detach it by pull-
ing towards you.

 Disconnect the bulb holder and
change it.
CHANGING A FUSE
The fuse boxes are located under the
instrument panel trim and next to the
battery in the engine compartment.

Correct
Removing and fitting a fuse
Before changing a fuse, the cause of
the incident must be found and recti-
fi ed.

 Use the pliers A located in the
fuse box under the bonnet.

Incorrect

Pliers A Instrument panel fuse boxes
These are located on each side of
the instrument panel under the trim.

 Turn the steering wheel to the
left, remove bolt B .

 Turn the steering wheel to the
right (do not forget to release the
steering wheel using the key),
remove bolt C .
Always replace a faulty fuse
with a fuse of the same rating
(same colour).

Page 85 of 99

9
74
PRACTICAL INFORMATION
DIRECTION INDICATOR SIDE REPEATERS (WY 5 W AMBER)

 Push the repeater forwards or
rearwards and detach it by pull-
ing towards you.

 Disconnect the bulb holder and
change it.
CHANGING A FUSE
The fuse boxes are located under the
instrument panel trim and next to the
battery in the engine compartment.

Correct
Removing and fitting a fuse
Before changing a fuse, the cause of
the incident must be found and recti-
fi ed.

 Use the pliers A located in the
fuse box under the bonnet.

Incorrect

Pliers A Instrument panel fuse boxes
These are located on each side of
the instrument panel under the trim.

 Turn the steering wheel to the
left, remove bolt B .

 Turn the steering wheel to the
right (do not forget to release the
steering wheel using the key),
remove bolt C .
Always replace a faulty fuse
with a fuse of the same rating
(same colour).

Page 86 of 99

9
75
PRACTICAL INFORMATION

 Raise the instrument panel trim,
and the rev counter trim if neces-
sary, to gain access to the fuses
located on the left and on the
right.

 For the rev counter, partially un-
screw bolt D located behind it.

Page 87 of 99

9
76
PRACTICAL INFORMATION
* Fuses located behind the instrument panel. To change them, contact a PEUGEOT dealer.

Fuse N° Rating
Functions

1 10 A Brake lamps - ABS - "2 Tronic" gearbox

2 25 A Central locking/unlocking

3 20 A Rear screen demisting

4 7.5 A Rear lamps - Number plate lamps - Instrument panel - Screen

5 7.5 A Diagnostic socket

6 7.5 A Rear foglamp - Instrument panel - "2 Tronic" gearbox

7 - Not used

8 7.5 A ABS - Power steering - Air conditioning - Fan assembly

9 10 A Rear lamps - Central locking/unlocking - Electric windows - Rear scree
n demisting -
Speedometer - Air conditioning - Heating - Rev counter

10 20 A Front and rear wipers

11 15 A Audio equipment - Electronic engine immobiliser - 12 V socket (120 W max)

12 7.5 A Rear screen demisting - ABS - Fan assembly - Front and rear wipers - Powe
r steering -
Central locking/unlocking - Air conditioning - Electric windows - Speedometer - Rev counter

13 15 A
Air bag - Engine control unit - Electronic engine immobiliser - "2 Tronic" gearbox - Instrument panel

14 7.5 A Air conditioning

15 * 40 A Accessories - Demisting - ABS - Fan assembly relay - Front and rear wipe rs

16 * 30 A Electric windows

17 * 40 A Heating - Air conditioning

Page 88 of 99

9
77
PRACTICAL INFORMATION
Engine compartment fuse box

 Unclip the cover, pressing on the
right on lug E , to gain access to
the fuses. Your vehicle's electrical cir-
cuit is designed to operate
with standard or optional
equipment.
Before installing other electrical
equipment or accessories on your
vehicle, contact a PEUGEOT dealer.
The pliers A and the replacement
fuses B are fi xed at the front of the
box.
When you have fi nished, close the
cover very carefully. Some electrical accessories or the
way in which they are fi tted may have
an adverse effect on the operation of
your vehicle (audio circuit, control cir-
cuit and electrical charging circuit).
PEUGEOT will not accept any respon-
sibility for the costs incurred in repairing
your vehicle or for the malfunctions re-
sulting from the installation of auxiliary
accessories which were not supplied
or recommended by PEUGEOT and
which were not installed in accordance
with its instructions, in particular in the
case of any equipment the consump-
tion of which exceeds 10 milliamps.

Page 89 of 99

9
78
PRACTICAL INFORMATION

Fuse N° Rating
Functions

1 50 A "2 Tronic" gearbox - Fan assembly (diesel)

2
10 A Headlamps

20 A Headlamps with daytime running lamps

3 30 A ABS/ESP control unit

4 30 A Ignition switch supply

5 10 A Hazard warning lamps - Instrument panel warning lamps - Direct ion indicators

6 10 A Headlamps

7 15 A Courtesy lamp - Speedometer - Audio equipment - Instrument pan el - Rev counter

8 15 A/25 A Petrol/diesel engine control unit

9 10 A Horn

10 30 A Fan assembly (petrol)

11 50 A ABS/ESP

12 50 A Power steering

Page 90 of 99

9
79
PRACTICAL INFORMATION
BATTERY
Do not push the vehicle to
start the engine if you have a
"2 Tronic" gearbox.
Before disconnecting the
battery, you must wait for
2 minutes after switching off
the ignition.
Never disconnect a terminal when
the engine is running.
Never charge a battery without fi rst
disconnecting the terminals.
Close the windows and doors before
disconnecting the battery.
After every reconnection of the bat-
tery, switch on the ignition and wait
1 minute before starting to allow the
electronic systems to be initialised. If
slight diffi culties are experienced af-
ter this, please consult a PEUGEOT
dealer.
To start the vehicle from
another battery:
- Connect the red cable to the positive
(+) terminals of the two batteries,
- Connect the green or black cable to the negative (-) terminals of the
two batteries,
- Operate the starter, let the engine run,
- Wait for the engine to return to idle, then disconnect the cables.
It is advisable to disconnect
the battery if the vehicle is
not to be used for a period of
more than one month.
The batteries contain harmful
substances such as sulphuric
acid and lead. They must be
discarded in accordance with
the provisions of the law and must not,
in any circumstances, be discarded
with household waste.
Return used batteries to a special
collection point.
To charge the battery using a
battery charger:
- Disconnect the battery,
- Follow the instructions for use
given by the battery charger man-
ufacturer,
- Reconnect starting with the nega- tive (-) terminal,
- Check that the terminals and connectors are clean. If they are
covered with sulphate (white or
greenish deposit), disconnect
them and clean them.

A. Failed battery

B. Slave battery

Page:   < prev 1-10 ... 41-50 51-60 61-70 71-80 81-90 91-100 next >