Peugeot 207 Dag 2007 Owner's Manual

PRACTICAL INFORMATION
143
Changing the third brake light bulbs (4 bulbs W 5 W)
 Press on the fixing pins on each side of the light.
 Take out the light from the outside.
 Turn the bulb holder which corre-sponds to the faulty bulb one quarter of a turn and remove it.
 Pull the bulb and change it.
To refit, carry out these operations in re-verse order.
Changing the number plate light bulbs (W 5 W)
 Insert a thin screwdriver in one of the exterior holes of the lens.
 Push it towards the outside to unclip it.
 Remove the lens.
 Pull the bulb and change it.

i
PRACTICAL INFORMATION
144
Rear lights (SW)
1. Brake lights (P 21 W).
2. Side lights (R 5 W).
3. Direction indicators (PY 21 W amber).
4. Fog lamps (P 21 W).
5. Reversing lights (P 21 W).
Changing bulbs
These five bulbs are changed from out-side the boot:
 remove the access flap,
 disconnect the light connector,
 remove the light fixing bolt,
 take out the light from the outside,
 press on the four tabs and remove the bulb holder,
 turn the bulb a quarter of a turn and change it.
To refit, carry out these operations in re-verse order.
Take care to engage the light in its guides keeping it in the centreline of the vehicle.

PRACTICAL INFORMATION
145
Changing the third brake light bulbs (4 bulbs W 5 W)
 Remove the two light fixing nuts.
 Take out the light from the outside.
 Press on the two tabs and remove the bulb holder.
 Pull the bulb and change it.
To refit, carry out these operations in re-verse order.
Changing the number plate bulbs (W 5 W)
 Insert a thin screwdriver into one of the exterior holes of the lens.
 Push it towards the outside to unclip it.
 Remove the lens.
 Pull the bulb and change it.

!
i
PRACTICAL INFORMATION
146
CHANGING A FUSE
Procedure for the replacement of a faulty fuse with a new fuse in order to rectify a failure of the corresponding function.
Access to the tools
The extraction pliers are installed on the back of the fascia fuse box cover.
To gain access to them:
 unclip the cover pulling at the top,
 remove the cover completely,
 remove the pliers.
Replacing a fuse
Before replacing a fuse, the cause of the failure must be identified and recti-fied.
 Identify the faulty fuse by examining the condition of its filament.
 Use the special pliers to extract the fuse from its housing.
 Always replace the faulty fuse with a fuse of the same rating.
 Check that the number engraved on the box and the rating engraved on the top correspond to the tables which follow.
CorrectIncorrect

PRACTICAL INFORMATION
147
Fascia fuses
The fuse box is placed in the lower part of the fascia (left-hand side).
Access to the fuses
 refer to the "Access to the tools"paragraph.
Fuse tables
Fuse N°RatingFunctions
G3920 AHi-Fi amplifier.
G4020 ADriver and passenger heated seats.
Fuse N°RatingFunctions
F115 ARear wiper.
F2-Not used.
F35 AAir bags and pre-tensioners control unit.
F410 A
Clutch pedal switch, diagnostic socket, electrochromatic interior mirror, air conditioning, steering wheel angle sensor, particle emission filter pump (Diesel).
F530 AElectric windows, rear one-touch electricwindows, sunroof, panoramic roof shutter (SW).
F630 AFront one-touch electric windows, folding mirrors supply.
F75 AFront and rear courtesy lights, map readinglights, sun visor lighting, glove box lighting, clock.

PRACTICAL INFORMATION
Fuse N°RatingFunctions
F820 AAudio equipment, audio/telephone, CD changer, multifunction display, clock, steering wheel controls, tyre under-inflation detection, trailer fuse box.
F930 AFront 12 V socket.
F1015 AAlarm siren, alarm control unit, directionalheadlamps.
F1115 ADiagnostic socket, low current ignition switch,automatic gearbox control unit.
F1215 ARain/brightness sensor, amplifier, trailer fuse box, driving school module.
F135 AEngine fuse box, ABS relay, "2 Tronic" gearbox selector lever, dual-function brake switch.
F1415 AInstrument panel, seat belt warning lights bar, headlamp adjustment, air conditioning, hands-free kit, rear parking assistance control unit, air bags.
F1530 ALocking and deadlocking.
F1740 ARear screen and exterior mirrors de-icing.
SH-PARC shunt.

PRACTICAL INFORMATION
149
Engine compartment fuses
The fuse box is placed in the engine compartment, near the battery (left-hand side).
Access to the fuses
 Unclip the cover.
 Replace the fuse (refer to the corre-sponding paragraph).
 When you have finished, close the cover carefully to guarantee the sealing of the fuse box.
Fuse table
Fuse N°RatingFunctions
F120 A
Engine control unit and fan assembly control relay supply, timing and canister solenoid valves (1.6 l 16V THP), air flow sensor (Diesel), injection pump (Diesel), water in diesel sensor (Diesel), EGR solenoid valves, air heating (Diesel).
F215 AHorn.
F310 AFront and rear wash-wipe.
F420 AHeadlamp wash.
F515 AFuel pump (petrol), Turbo solenoid valves (1.6 l 16V THP).
F610 AVehicle speed sensor, automatic gearbox.
F710 AElectric power steering, directional headlamps, directional headlamps control relay, switching and protection unit (Diesel).
F820 AStarter control.
F910 AABS/ESP control unit, brake pedal switch.
F1030 A
Engine control unit actuators (petrol: ignition coils, solenoid valves, oxygen sensors, injectors, heaters, controlled thermostat) (Diesel: solenoid valves, heaters).
F1140 AAir conditioning blower.
F1230 AWindscreen wipers Low/High speed.

PRACTICAL INFORMATION
150
Fuse N°RatingFunctions
F1340 ABuilt-in systems interface supply (ignition positive).
F1430 ADiesel heater (Diesel).
F1510 ALeft main beam headlamp.
F1610 ARight main beam headlamp.
F1715 ALeft dipped beam headlamp.
F1815 ARight dipped beam headlamp.
Maxi-fuse table
* The maxi-fuses provide additional protection for the electrical systems. All work on the maxi-fuses must be carried out by a PEUGEOT dealer.
Fuse N°RatingFunctions
Box 1
MF1*70 AFan assembly.
MF2*20 A/30 AABS/ESP pump.
MF3*20 A/30 AABS/ESP solenoid valves.
MF4*60 ABuilt-in systems interface supply.
MF5*60 ABuilt-in systems interface supply.
MF6*30 AAdditional fan assembly (1.6 l 16V THP).
MF7*80 APassenger compartment fuse box.
MF8*30 A"2 Tronic" gearbox control unit.
Box 2
MF9*80 AHeating unit (Diesel).
MF10*80 AElectric power steering.
MF11*40 AValvetronic electric motor (1.6 l 16V THP).

PRACTICAL INFORMATION
151
BATTERY
Procedure for charging your battery when it is flat or for starting the engine using another battery.
Access to the battery
Starting using another battery
 Connect the red cable to the positive terminal (+) of the flat battery A, then to the positive terminal (+) of the slave battery B.
 Connect one end of the green or black cable to the negative terminal (-) of the slave battery B. Connect the other end of the green or black cable to an earth point C on the broken down vehicle, as far as possible from the battery (for exam-ple, right-hand engine mounting).
 Operate the starter, let the engine run. Wait until the engine returns to idle and disconnect the cables.
The battery is located under the bonnet on the left.
To gain access to it: open the bonnet using the interior lever, then the exterior lever,
 secure the bonnet strut, remove the plastic cover to gain access to the two terminals.

!
!
i
PRACTICAL INFORMATION
152
Charging the battery using a battery charger
Disconnect the battery from the vehicle.
 Follow the instructions for use pro-vided by the manufacturer of the charger.
 Reconnect starting with the negative terminal (-).
 Check that the terminals and con-nectors are clean. If they are cov-ered with sulphate (whitish or green-ish deposit), remove them and clean them.
LOAD REDUCTION MODE
System which manages the use of cer-tain functions in relation to the level of charge remaining in the battery.
When the vehicle is being driven, the load reduction function temporarily deactivates certain functions, such as the air conditioning, the rear screen de-icing...
The deactivated functions are reactivat-ed automatically as soon as conditions permit.