Peugeot 207 Dag 2010 Service Manual

!
i
53
Folding the seat (Saloon)
To avoid damaging a seat when folding
it, always start with the seat cushion,
never the seat back :

 move the corresponding front seat
forward if necessary,

 raise the front of the seat cushion 1 ,

 tilt the seat cushion 1 against the
front seat,

 check that the seat belt is positioned
correctly on the side of the seat
back,
Repositioning the seat (Saloon)
When repositioning the rear seat:

 straighten the seat back 3 and se-
cure it,

 fold back the seat cushion 1 .

 pull control 2 upwards to release the
seat back 3 ,

 place the head restraints in the low
position or remove them if neces-
sary,

 tilt the seat back 3 .
When repositioning the rear seat,
take care not to trap the seat belts. The seat cushion
1 can be removed
to increase the loading volume.
Squeeze the seat cushion fi xings
to detach them from their attach-
ments.

!
i
52
REAR SEATS
Bench seat the left-hand part (2/3) or
right-hand part (1/3) of which can be
folded to adapt the load space in the
boot. Never drive with the head restraints
removed; they must be in place and
correctly adjusted.
As the head restraints are not inter-
changeable, take care to put them
back in their original position when
refi tting.
Rear head restraints
These have a high position (comfort)
and a low position (rear visibility).
The command for activation of
heating of the seat(s) remains
memorised for two minutes after
the ignition has been switched off.
7. Heated seats switch
With the engine running, the front seats
can be heated separately.

 Use the adjustment dial, placed on
the side of each front seat, to switch
on and select the level of heating re-
quired:

0
: Off.

1
: Low.

2
: Medium.

3
: High.
They can also be removed; to remove them:

 pull the head restraint upwards to
the stop,

 then, press the lug.
6. Armrests (except 3 door)
These can be folded down and are
removable.

 To remove an armrest, press the
button located between the armrest
and the side of the seat and pull it
off.

!
i
54

Folding the seat (SW)
This operation can be carried out at the
rear seats or through the opening rear
screen.
To avoid damaging a seat when folding it:

 move the corresponding front seat
forward if necessary,

 place the head restraints in the low
position, Check that no object could hinder
the movement of the bench seat,
either above or below.
Repositioning the seat (SW) The seat cushion lowers in order to
be covered by the seat back; this
quickly gives you a fl at boot fl oor.

 pull the control 1 forward to release
the seat back 2 which folds easily
onto the seat cushion 3 .

 When repositioning the rear seat,
straighten the seat back 2 and lock it.

 Check that the red indicator, located
at control 1 , is no longer visible.

i
!
55
MIRRORS
Door mirrors
Adjustable mirror providing the lateral
rearward vision necessary for overtak-
ing or parking. Folding

 from outside: lock the vehicle using
the remote control or the key.

 from inside: with the ignition on, pull
switch A rearwards.
Manual model Adjustment

 Move the lever in all four directions
to adjust the mirror.
The folding and unfolding of the
door mirrors can be deactivated by
a PEUGEOT dealer.
Folding

 When parked, fold the mirror manu-
ally to protect it.
Unfolding

 Before starting, unfold the mirror.
Electric model
Adjustment

 Slide switch A to the right or to the left
to select the corresponding mirror.

 Move knob B in all four directions to
adjust.

 Return switch A to the centre position. Unfolding

 from outside: unlock the vehicle us-
ing the remote control or the key.

 from inside: with the ignition on, pull
switch A rearwards.
The objects observed are, in reality,
closer than they appear.
Take this into account to correctly
judge the distance of vehicles ap-
proaching from behind.

!
i
56
Rear view mirror
Adjustable mirror providing a central
rearward view.
Equipped with an anti-dazzle system,
useful in poor light.
Adjustment

 Adjust the mirror so that the glass is di-
rected correctly in the "day" position.
As a safety precaution, the mirrors
must be adjusted to reduce the
"blind spot".
Automatic day/night model
By means of a sensor, which measures
the light from the rear of the vehicle, this
system automatically and progressively
changes between the day and night
uses.
It has an anti-dazzle system which dark-
ens the mirror glass: this reduces any
driver discomfort caused by the light
beam of following vehicles, the sun...
Manual day/night model
Day/night position

 Pull the lever to change to the "night"
anti-dazzle position.

 Push the lever to change to the normal
"day" position. In order to guarantee optimum visi-
bility during your manoeuvres, the
mirror lightens automatically when
reverse gear is engaged.

!
i
57
STEERING WHEEL
ADJUSTMENT

 When stationary , pull the control
lever to release the steering wheel.

 Adjust the height and reach to suit
your driving position.

 Push the control lever to lock the
steering wheel.
As a safety precaution, these ope-
rations should only be carried out
while the vehicle is stationary.
Component which protects against
sunlight from the front or the side, also
equipped with an illuminated courtesy
mirror.

 With the ignition on, raise the con-
cealing fl ap; the mirror is lit automati-
cally.
This sun visor is also equipped with a
ticket holder.
TOLL CARD/CAR PARK TICKET
WINDOWS
Facility for affi xing toll cards and/or car
park tickets.
These windows are located on each
side of the base of the rear view mirror.
They are two non-refl ective areas of the
athermic windscreen.
The athermic windscreen limits
heating of the passenger compart-
ment by reducing the effects of the
sun's rays (ultra-violet). It consists
of a refl ective layer, which also
blocks certain radio-electric signals
(toll card payments, ...).

!
!
58
To avoid any risk of jamming of the
pedals:
- only use mats which are suited to the fi xings already present in
the vehicle; it is imperative that
these are used,
- never fi t one mat on top of an- other.
MATS
Removable carpet protection. Refitting
To refi t the mat on the driver's side:

 position the mat correctly,

 refi t the fi xings by pressing,

 check that the mat is secured cor-
rectly.
Fitting
When fi tting the mat for the fi rst time,
on the driver's side use only the fi xings
provided in the wallet attached.
The other mats are simply placed on
the carpet.
Removal
To remove the mat on the driver's side:

 move the seat as far back as pos-
sible,

 unclip the fi xings,

 remove the mat.
PEUGEOT CONNECT USB
This connection box, consisting of an
auxiliary JACK socket and a USB port,
is located on the centre console.
It permits the connection of portable
equipment, such as a digital audio player
of the iPod ®
or USB memory stick type.
It reads the audio fi le formats (mp3,
ogg, wma, wav...) which are transmitted
to your audio equipment and played via
the vehicle's speakers.
You can manage these fi les using the
steering wheel controls or the audio
equipment control panel and display
them on the multifunction screen.
When it is in use, the portable equip-
ment charges automatically.
For more information on the use
of this equipment, refer to the PC
Sound part of the "Audio and Tele-
matics" section.

59
INTERIOR FITTINGS

1. Illuminated glove box
(see details on following page)

2. Storage compartment with
non-slip mat

3. Card
/ticket
holder

4. Door tray

5. Storage compartment with non-
slip mat

6. USB port
(see details on previous page)

7. 12 V accessories socket
(see details on following page)

8. Storage compartments

9. Cup holder

60
Illuminated glove box *
This has an upper open storage com-
partment, a recess and locations for
storing a bottle of water, the vehicle's
handbook, ...
Its lid has locations for storing a pen,
a pair of spectacles, tokens, cards, a
can, ...

 To open the glove box, raise the
handle.
It is illuminated when the lid is opened.
It houses the front passenger's airbag
deactivation switch A .
 To connect a 12 V accessory (max
power: 120 Watts), lift the cover and
connect a suitable adaptor.
12 V accessories socket
If the vehicle is fi tted with digital air con-
ditioning, it provides access to the ven-
tilation nozzle B , which can be opened
or closed, distributing the same condi-
tioned air as the vents in the passenger
compartment.
* According to version.

61
BOOT FITTINGS (SALOON)

1. Rear parcel shelf
(see details on following page)

2. Hooks
(see details on following page)