Peugeot 407 2009 Workshop Manual

Page 51 of 250

3COMFORT
49
Operation
Switch on the ignition and press switch 1 : - indicator light 2 lit (switch pressed):
automatic operation.
- indicator light 2 off: automatic
system off. The mirror remains at
its most clear.
Manual interior mirror
The interior mirror has two positions:
- day (normal),
- night (anti-dazzle).
To change from one to the other, push
or pull the lever on the lower edge of
the mirror. Special feature
To ensure maximum visibility
during manoeuvres, the mirror
clears automatically when re-
verse gear is engaged.
MANUAL STEERING WHEEL HEIGHT AND DEPTH ADJUSTMENT
When the vehicle is stationary, unlock
the steering wheel by pushing the
control forwards.
Adjust the height and depth of the
steering wheel then lock by pulling the
control fully.

Page 52 of 250

3COMFORT
50
FRONT SEATS

Manual mode
Longitudinal adjustment
Lift the control bar and slide the seat
forwards or backwards. Driver's seat cushion height and
angle adjustment
Pump up or down to the required
position. Seat back angle adjustment
Operate the lever for your comfort.

Page 53 of 250

3COMFORT
51
Electric mode
Longitudinal adjustment
Push the control forwards or back-
wards to slide the seat. Driver's seat cushion height and
angle adjustment

Height: tilt the rear of the control up
or down.

Tilt: tilt the front of the control up or
down. Seat back angle adjustment
Tilt the control forwards or backwards
for your comfort.
The electrical functions of the driver's seat are deactivated o ne minute after the ignition is switched off.
To reactivate them, open the door or switch on the ignitio n.

Page 54 of 250

3COMFORT
52
Head restraint height and angle
adjustment Front seat active head restraint
This system prevents "whiplash".
In the event of a rear impact, the action
of the body on the seat back moves
the head restraint forwards and up-
wards preventing the head from being
thrown back.
Front armrest Driver's seat lumbar adjustment
Heated seats adjustment


0
: Off.

1
: Low.
2
: Medium.

3
: High.
The adjustment is correct when
the top of the head restraint is
aligned with the top of the head
of the occupant of the seat.


Never drive with the head re-
straints removed and stored in
the vehicle. This is dangerous
and they may be thrown in the
event of sharp braking. They must be
in place and adjusted correctly.

To change the position of the armrest:

 Lift the handle 1 .
The armrest folds forwards and up-
wards.
To return to the initial position, push
the armrest backwards and press it to
engage.
Operate the lever to obtain the correct
position. To raise or lower the head restraint,
pull it forwards then slide it.
To tilt the head restraint, tilt the lower
part forwards or backwards.
To remove the head restraint, move it
almost to the highest position, lift the
tab using a coin and pull it forwards
and upwards at the same time.
To refi t the head restraint, engage the
stalks in the holes keeping in line with
the seat back.


With the engine running, turn the dial.
The temperature of the seat is regulated
automatically.

Page 55 of 250

3COMFORT
53
REAR SEATS (SALOON)

Note: the seat cushion 1 can be
removed with care to increase the
vo-lume of the load space.
Squeeze the seat cushion fi xings to
detach them from their fastenings.
When repositioning:

 fold up the seat back 2 and lock it
(the red marker of control 3 should
no longer be visible),

 fold up the seat 1 ,

 refi t the head restraints if they were
removed. Locking/unlocking the access
to the boot via the rear seats
Your vehicle's boot can be isolated
from the passenger compartment.
The red indicator on the control
3
should no longer be visible. If it is,
push the seat fully.
Insert the ignition key in the lock 4 .
Take care not to trap the seat
belt and to position the buckle
of each strap correctly in its
respective clasp before folding
down the seat back. This will enable
you to reposition the seat backs with
their seat belts and clasps ready to ac-
commodate your rear passengers.
To fold down the rear left seat or the
rear right seat, always start with the
seat, never with the seat back (risk of
damage):

 move the front seat(s) forward if
necessary,

 place the head restraints in the low
position or remove them if neces-
sary,
Check that the seat belt strap is
positioned correctly at the side of the
seat back,
Ensure that the side seat belt straps
are fastened in their clasp (the centre
seat belt must not be fastened),

 lift the front of the seat cushion 1 ,

 tilt the seat cushion 1 against the
front seat(s),

 pull control 3 forwards to unlock
the seat back 2 ,

 fold down the seat back 2 .

Page 56 of 250

3COMFORT
54
REAR SEATS (407 SW)

Note: the seat cushion 1 can be
removed with care to increase the
volume of the load space.
Squeeze the seat cushion fi xings to
detach them from their fastenings.
When repositioning:

 fold up the seat back 2 and lock it
(the red marker of control 3 should
no longer be visible),

 fold up the seat 1 ,

 refi t the head restraints if they were
removed. Take care not to trap the seat
belt and to position the buckle
of each strap correctly in its
respective clasp before folding
down the seat back. This will enable
you to reposition the seat backs with
their seat belts and clasps ready to ac-
commodate your rear passengers.
To fold down the rear left seat or the
rear right seat, always start with the
seat, never with the seat back (risk of
damage):

 move the front seat(s) forward if
necessary,

 place the head restraints in the low
position or remove them if neces-
sary,
Check that the seat belt strap is
positioned correctly at the side of the
seat back.
Ensure that the side seat belt straps
are fastened in their clasp (the centre
seat belt must not be fastened),

 lift the front of the seat cushion 1 ,

 tilt the seat cushion 1 against the
front seat(s),

 pull control 3 forwards to unlock
the seat back 2 ,

 fold down the seat back 2 .

Page 57 of 250

3COMFORT
55
TRANSPORTING LONG OBJECTS * (407 SW)
Rear seat (see corresponding
paragraph):

 Tilt the seat cushion,

 Remove the head restraints,

 Tilt the seat back.
Note: when repositioning,
ensure that the front and
rear seat backs are secured
correctly.
Precautions
- The long object must be placed on the end of the
front seat back and on the
rear seat cushion.
- Do not place a load in excess of 30 kg on the front of the seat
back.
- Do not load blunt objects, this could damage the rear of the front
seat back (storage pocket).
Front passenger seat:

 Tilt the seat back approximately
25° towards the rear (in relation to
the vertical position) using the seat
back angle adjustment control (see
corresponding paragraph).

 Lift control A upwards to release
the seat back.

 Without releasing control A , press
on the top of the seat back and
move with it until it is folded.
* According to version.

Page 58 of 250

3COMFORT
56
"Forwards-facing"
INSTALLING A CHILD SEAT USING A THREE POINT SEAT BELT
GENERAL POINTS RELATING TO CHILD SEATS
* The rules for transporting children are
specifi c to each country. Refer to the
current legislation in your country. Intermediate longitudinal
position
When a "rearwards-facing"
child seat is installed on the

front passenger seat , it is
essential that the passenger
airbag is deactivated. Otherwise, the
child would risk being seriously
injured or killed if the airbag were
to infl ate. When a "forwards-facing" child seat
is installed on the
front passenger
seat , adjust the vehicle's seat to the
intermediate longitudinal position with
the seat back upright and leave the
passenger airbag activated.
"Rearwards-facing"
Although one of PEUGEOT's main cri-
teria when designing your vehicle, the
safety of your children also depends
on you.
For maximum safety, please
follow these precautions:
- in accordance with European reg- ulations, all children under the
age of 12 or less than one and
a half metres tall must travel in
approved child seats suited to
their weight , on seats fi tted with a
seat belt or ISOFIX mountings * ,
- statistically, the safest seats in
your vehicle for the transpor-
tation of children are the rear
seats,
- a child weighing less than 9 kg
must travel in the "rearwards-
facing" position both in the front
and in the rear.

PEUGEOT recommends that chil-
dren should travel in the rear seats of
your vehicle:
- "rearwards-facing" up to the age
of 2,
- "forwards-facing" over the age
of 2.

Page 59 of 250

3COMFORT
57

Group 0: from birth to 10 kg
Group 0+: from birth to 13 kg

L1
"ROMER Baby-Safe Plus"
Installed in the rear-facing position.

Groups 1, 2 and 3: from 9 to 36 kg

L2
"KIDDY Life"
The use of the restraining cushion is compulsory for transporting young children (from 9 to 18 kg).

Groups 2 and 3: from 15 to 36 kg

L3
"RECARO Start''.
L4
"KLIPPAN Optima"
From the age of 6 years
(approximately 22 kg), the
booster is used on its own.
CHILD SEATS RECOMMENDED BY PEUGEOT
PEUGEOT offers a complete range of recommended child seats which a
re

secured using a three point seat belt :
Passenger air bag OFF

Page 60 of 250

3COMFORT
58
LOCATION OF CHILD SEATS SECURED USING THE SEAT BELT
In accordance with European regulations, this table indicates the options for the installation of child seats secured using the
seat belt and universally approved (a) depending on the weig ht of the child and the seat in the vehicle.

Weight of the child/ indicative age

Seat
Below 13 kg
(groups 0 (b) and 0+)
Up to approx 1 year
9 to 18 kg
(group 1)
1 to 3 years approx
15 to 25 kg
(group 2)
3 to 6 years
22 to 36 kg
(group 3)
6 to 10 years approx
Front passenger
Seat (c)
- fi xed
U U U U
- height adjustable (R)
U (R) U (R) U (R) U (R)
Rear side seats
U U U U
Rear centre seat
X X X X

a: Universal child seat: child seat which can be installed in all vehicles using the seat belt.

b: Group 0: from birth to 10 kg.

c: Consult the current legislation in your country before instal ling your child on this seat.

U: seat suitable for the installation of a child seat secure d using the seat belt and universally approved, "rear facing" an d/or
"forwards facing".

U (R): identical to U , but the vehicle seat must be adjusted to the highest po sition.

X: seat which is not suitable for the installation of a chi ld seat.

Page:   < prev 1-10 ... 11-20 21-30 31-40 41-50 51-60 61-70 71-80 81-90 91-100 ... 250 next >