key Peugeot 607 Dag 2002 Owner's Guide

Operating check
ActivationWhen this function is acti
vated, the indicator light
comes on, accompanied by
an audible signal.
The light also comes on as soon as
the driver changes the stalk position
to 0.
Neutralisation When neutralising the func
tion, the indicator light
comes on, accompanied by
an audible signal.
The indicator light also comes on as
soon as the driver uses the manual
lighting controls.
If the sunshine / brightness sen
sor does not function correctly,
the system activates the function
(the lights come on) and the dipped
beam headlamps indicator light on
the instrument panel flashes.
Contact a PEUGEOT dealer to have
the system checked.
109
Automatic switching
on of the lights
Side lights and dipped beam head
lamps switch on automatically if the
light is poor, or during continuous
operation of the windscreen wipers.
They switch off as soon as the light
becomes bright enough or the wind
screen wipers stop.
Note : in foggy weather, the bright
ness sensor can detect sufficient
light. As a consequence, the lights
will not come on automatically.
This function is active when the vehi
cle is supplied to the customer.
To switch the function on or off::
Place the key in the accessories
position (1st notch),
Change the stalk position to 0,
Press the end of the stalk for more
than two seconds.
Note : after the ignition is switched
off and depending on the brightness,
the lights remain on for approximate
ly thirty seconds or until the vehicle is
locked. Do not cover the sunshine /
brightness sensor located in the
centre of the fascia. It helps to
regulate the air conditioning,
automatic switching on of the
lights and the automatic adjust
ment of the instrument panel
brightnes.
YOUR 607 IN DETAIL

YOUR 607 IN DETAIL119
Sun visor with illuminated
courtesy mirror
With the ignition on, the mirror is
automatically illuminated when the
flap is opened.
COURTESY LIGHTS
1 Front courtesy light
2 Front map reading lights
With the key in the accesories position (1st notch) or with the ignition on,
operate the relevant switch.
3 Rear courtesy light
4 Rear map reading lights With the key in the accesories position (1st notch) or with the ignition on,
operate the relevant switch.
The front and rear courtesy lights come on when the ignition key is removed, on
unlocking the vehicle or on opening one of the doors.
They gradually go off after the ignition has been switched on or the vehicle is
locked. Pressing switch 1turns on the front and rear courtesy lights.
Note: The courtesy lights and sill lights can be neutralised by pressin g switch 1
for more than three seconds. The map reading lights are not af fected by this and
may be switched on. To reactivate the lights, press the switch. Sill illumination
The sill light is at the bottom of each
door trim.
The light comes on automatically
when the door is opened and goes
off automatically when the door is
closed.

YOUR 607 IN DETAIL
129
AIR BAGS
The air bags have been designed to
maximise the safety of the occu
pants in the event of serious colli
sions; they work in conjunction with
the force limiting seat belts.
In the event of a serious collision, the
electronic detectors record and
analyse any abrupt deceleration of
the vehicle: if the triggering threshold
is reached, the air bags inflate
instantly and protect the occupants
of the vehicle.
Immediately after the impact, the air
bags deflate rapidly, so that they do
not hinder the visibility of the occu
pants nor their possible exit from the
vehicle.
The air bags will not be deployed in
collisions which are not serious, for
which the seat belt is sufficient to
provide maximum protection. The
seriousness of the collision depends
on the nature of the obstacle and the
speed of the vehicle at the moment
of impact.
Air bags operate only when the
ignition is switched on.
Note: the gas escaping from the air
bags can be a minor irritant. FRONT AIR BAGS
These are folded in the centre of the
steering wheel for the driver and in
the fascia for the front passenger.
They are deployed simultaneously,
except in cases where the air bag is
disarmed.
Front air bag malfunction
If this warning light comes
on, accompanied by a
buzzer and the message
"Air bag fault" on the
multifunction display , con
tact a PEUGEOT dealer to
have the system checked. Disarming the passenger air
bag*
To ensure the safety of your child,
it is essential to disarm the pas-
senger air bag when you install a
rear-facing child seat on the front
passenger seat.
With the ignition switched off,
insert the key into the passenger
air bag disarming slot
1, turn it to
the "OFF" position, then remove
it keeping the slot in this position.
The air bag warning light on the
instrument panel is lit throughout
the disarming process.
* According to destination

Special features of alloy wheels*
Bolt covers
Alloy wheel bolts are covered by
chrome trims.
Use tool7to remove the trims before
slackening the bolts. Antitheft bolts*
If your wheels are fitted with an anti
theft bolt (one per wheel), the
chrome trim and then the plastic
cover must be removed using tool
7,
before unscrewing the bolt using one
of the two antitheft sockets (which
were given to you on delivery of your
vehicle along with the duplicate keys
and the confidential card) and the
wheel brace 1.
Note: make a careful note of the
code number engraved on the head
of the antitheft socket. This will
enable you to obtain duplicate anti
theft sockets from a Peugeot dealer.
* According to model and destination
PRACTICAL INFORMATION
142
7
Fitting the spare wheel
If your vehicle is fitted with a steel
spare wheel, when fitting it, it is
nor
mal to notice when tightening the
bolts that the washers do not come
into contact with the rim. The spare
wheel is secured by the coneshape
of each bolt.
Fitting snow tyres
If you fit snow tyres mounted on steel
wheels to your vehicle, it is essential
to use special bolts available from
your PEUGEOT dealer.
7