RENAULT KANGOO 2013 X61 / 2.G Mechanism And Accessories Service Manual

EXTERIOR ACCESSORIES
Rear view mirror
Use tool Car. 1363 to remove the mirror.
56
REMOVING
PRB5602
13107S
56-2

EXTERIOR ACCESSORIES
Rear screen washer jet
First remove the third stop light and then
disconnect the pipe at the union.
56
REMOVING
PRB5605
13110R
56-3

EXTERIOR ACCESSORIES
Number plate light
Unclip the part of the unit which is on the outside
of the vehicle.
Disconnect wiring harness.
Remove mounting bolts.
56
REMOVING
PRB5604
13111-1R
56-4

LOWER INTERIOR ACCESSORIES
Dashboard
Remove the two bolts behind the steering wheel.
Disconnect the connectors (air bag, horn).
Remove:
- the air bag,
- the steering wheel bolt (when refitting, use a
new bolt with adhesive applied and tightened
to a torque of 4.5 daN.m),
- the steering wheel (with the wheels in the
straight ahead position).
Removing steering wheel (without air bag).
Remove:
- the centre boss,
- the steering wheel bolt (when refitting, use a
new bolt with adhesive applied and tightened
to a torque of 4.5 daN.m),
- the steering wheel (with the wheels in
straight ahead position).
57
REMOVING
Disconnect the battery.
Remove steering wheel (with air bag).
PRB5702
12973S
57-1

LOWER INTERIOR ACCESSORIES
Dashboard
- the instrument panel (four screws).
57
Remove :
- the half cowling (three bolts),
12969-1R12971R
12970-1R
- the instrument panel binnacle (six screws) and
the dashboard cowling (two screws),Disconnect the connectors.
12968S
57-2

LOWER INTERIOR ACCESSORIES
Dashboard
- lower section of dashboard (four screws, two
clips).
57
Special instructions for vehicles with air bags
Before removing the assembly, it is essential to
mark the position of the rotating switch under the
steering wheel :
- Make sure the wheels are in the straight ahead
position when the assembly is removed so that
the length of the the ribbon can be positioned
in the centre,
- By immobilising the rotating switch rotor, using
adhesive tape .
Undo the screw and then give the screwdriver a
sharp tap to release the cone.
Disconnect the connectors.
12966R12967-1R
Remove:
- lower protector (four screws).
12971-1R
57-3

LOWER INTERIOR ACCESSORIES
Dashboard
- the ashtray and its bracket (two screws).
Disconnect connectors.
57
Remove fuse holder (five screws).
Unclip diagnostic socket.
12963R12965-1R
12965-1R1
Remove :
- fittings securing steering column (two nuts,
two bolts),Remove :
- heating control panel (two screws).
12963R1
57-4

LOWER INTERIOR ACCESSORIES
Dashboard
Unclip gear lever gaiter.
Remove the four mounting bolts.
Disconnect connectors.
57
Take out speaker grilles.
Remove fittings securing dashboard.
Pull dashboard gently.
Detach clips holding wiring harness.
Disconnect:
- connectors for headlight height adjustment
and hazard warning lights,
- remaining connectors (e.g. decoder).
Remove dashboard.
12964R
PRB5701
CONSOLE
57-5

UPPER INTERIOR ACCESSORIES
Upper storage compartment in cab
REMOVING
58
PRB5801
Remove fasteners securing storage compartment
(1) and sun visors.
Remove unit (A).
Take unit (B) off its bracket (C).
13249R1
58-1

INTERIOR SAFETY ACCESSORIES
Front seat belts
59
PRB5903
TIGHTENING TORQUES (in N.m)
Seat belt mounting bolts 37
Pretensioner bolts 25
59-1