TOYOTA AVENSIS 2003 Service Repair Manual

B70683
LH Visor Assy
Visor Holder
w/ Sliding Roof
Roof Headlining Assy
RH Visor Assy
Map Lamp AssyRoom Lamp Assy No. 2
Lens Cover
Assist Grip
Sub±assy
Lens Cover Assist Grip Sub±assy
Assist Grip Sub±assy
Assist Grip Sub±assy
Sun Roof Opening
Trim Moulding
±
EXTERIOR/INTERIOR TRIM ROOF HEADLINING ASSY (LIFTBACK MODELS)
76±43
AVENSIS REPAIR MANUAL (RM1018E)
http://vnx.su

B66566
w/o Sliding RoofLH Visor Assy
Visor Holder Roof Headlining Assy
RH Visor Assy
Map Lamp Assy
Room Lamp Assy No. 2
Lens Cover
Assist Grip Sub±assy
Lens Cover Assist Grip Sub±assy
Assist Grip Sub±assy
Assist Grip Sub±assy
76±44
±
EXTERIOR/INTERIOR TRIM ROOF HEADLINING ASSY (LIFTBACK MODELS)
AVENSIS REPAIR MANUAL (RM1018E)
http://vnx.su

760WW±01
B66532
Clip
Claw
B66531
Clip
Claw
B66533
Clip
Claw
±
EXTERIOR/INTERIOR TRIM ROOF HEADLINING ASSY (LIFTBACK MODELS)
76±45
AVENSIS REPAIR MANUAL (RM1018E)
REPLACEMENT
HINT:
The installation is in the reverse order of the removal. However, when there is a special point concerning
the installation, it is indicated.
1. REMOVE FRONT DOOR SCUFF PLATE RH
(a) Using a screwdriver, disengage the 5 clips and 2 claws,and remove the scuff plate.
HINT:
Tape the screwdriver tip before use.
2. REMOVE FRONT DOOR SCUFF PLATE LH
HINT:
Use the same procedures described for the RH side. 3. REMOVE REAR DOOR SCUFF PLATE RH
(a) Using a screwdriver, disengage the 3 clips and 2 claws,and remove the scuff plate.
HINT:
Tape the screwdriver tip before use.
4. REMOVE REAR DOOR SCUFF PLATE LH
HINT:
Use the same procedures described for the RH side. 5. REMOVE COWL SIDE TRIM BOARD RH
(a) Using a screwdriver, disengage the clip and 2 claws, andremove the trim board.
HINT:
Tape the screwdriver tip before use.
6. REMOVE COWL SIDE TRIM BOARD LH
HINT:
Use the same procedures described for the RH side.
http://vnx.su

B66534
B66535
Clip
B66527
Clip
76±46
±
EXTERIOR/INTERIOR TRIMROOF HEADLINING ASSY(LIFTBACK MODELS)
AVENSIS REPAIR MANUAL (RM1018E)
7.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
8.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
9.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
10.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH 11.REMOVE CENTER PILLAR GARNISH LOWER RH
(a)Remove the floor anchor cover.
(b)Remove the bolt and the outer belt on the floor anchorside.
(c)Using a screwdriver, disengage the 2 clips and remove the pillar garnish.
HINT:
Tape the screwdriver tip before use.
12.REMOVE CENTER PILLAR GARNISH LOWER LH
HINT:
Use the same procedures described for the RH side. 13.REMOVE CENTER PILLAR GARNISH UPPER RH
(a)Using a screwdriver, disengage the clip and 2 screws, andremove the pillar garnish.
HINT:
Tape the screwdriver tip before use.
14.REMOVE CENTER PILLAR GARNISH UPPER LH
HINT:
Use the same procedures described for the RH side.
15.REMOVE REAR SEAT ASSY (See page 72±21)
16. REMOVE REAR SIDE SEAT BACK ASSY RH
(a) Remove the bolt and seatback.
17. REMOVE REAR SIDE SEAT BACK ASSY LH
(a) Remove the bolt and seatback.
18. REMOVE PACKAGE TRAY TRIM PANEL ASSY
http://vnx.su

B66551
B66552
Clip
B63923
Clip
B66540
Clip
±
EXTERIOR/INTERIOR TRIM ROOF HEADLINING ASSY (LIFTBACK MODELS)
76±47
AVENSIS REPAIR MANUAL (RM1018E)
19. REMOVE REAR FLOOR FINISH PLATE
(a) Remove the 2 bolts.
(b) Using a screwdriver, disengage the 4 claws and remove
the floor finish plate.
HINT:
Tape the screwdriver tip before use.
20. REMOVE DECK TRIM SIDE PANEL ASSY RH
(a) Remove the 2 screws.
(b) Using a screwdriver, disengage the 5 clips and remove the deck trim side panel.
HINT:
Tape the screwdriver tip before use.
21. REMOVE DECK TRIM SIDE BOARD LH
HINT:
Use the same procedures described for the RH side. 22. REMOVE ROOF SIDE GARNISH INNER RH
(a) Remove the screw.
(b) Using a screwdriver, disengage the 5 clips and removethe roof side garnish.
HINT:
Tape the screwdriver tip before use.
23. REMOVE ROOF SIDE GARNISH INNER LH
HINT:
Use the same procedures described for the RH side. 24. REMOVE ROOF HEADLINING TRIM SUB±ASSYREAR
(a) Using a screwdriver, disengage the 5 clips and remove
the roof head lining trim.
HINT:
Tape the screwdriver tip before use.
http://vnx.su

B66528
Clip
B65292
700 mm120 mm
Adhesive Tape
Adhesive Tape Protective Cover
A79919
Claw
Claw
76±48
±
EXTERIOR/INTERIOR TRIM ROOF HEADLINING ASSY (LIFTBACK MODELS)
AVENSIS REPAIR MANUAL (RM1018E)
25. REMOVE FRONT PILLAR GARNISH RH
(a) Using a screwdriver, disengage the 2 clips and remove the pillar garnish.
HINT:
Tape the screwdriver tip before use.
(b) Pull the garnish upward and remove if from the instrument panel.
(c) w/ Curtain shield airbag: Protect the curtain shield airbag LH.
(1) Thoroughly cover the airbag with cloth or nylon of700 mm (27.56 in.) x 120 mm (4.72 in.) and fix the
ends of the cover in place with adhesive tape as
shown in the illustration.
NOTICE:
Cover the curtain shield airbag with a protective cover as
soon as the front pillar garnish is removed.
26. REMOVE FRONT PILLAR GARNISH LH
HINT:
Use the same procedures described for the RH side.
27. REMOVE RH VISOR ASSY
(a) Remove the 2 screws and visor.
28. REMOVE LH VISOR ASSY
(a) Remove the 2 screws and visor. 29. REMOVE MAP LAMP ASSY
(a) Using a screwdriver, disengage the 6 claws and removethe lens cover.
HINT:
Tape the screwdriver tip before use.
(b) Remove the 2 screws.
(c) Using a moulding remover, disengage the claws.
(d) Disconnect the map lamp switch connector and sliding roof switch connector, and remove the map lamp.
http://vnx.su

B66541Claw
Claw
B66529
ClawClaw
B50596
90

±
EXTERIOR/INTERIOR TRIM ROOF HEADLINING ASSY (LIFTBACK MODELS)
76±49
AVENSIS REPAIR MANUAL (RM1018E)
30. REMOVE ROOM LAMP ASSY NO.2
(a) Using a moulding remover, disengage the 8 claws and re-
move the lens cover.
HINT:
Tape the screwdriver tip before use.
(b) Using a moulding remover, disengage the claws.
(c) Disconnect the map lamp switch connector and remove the map lamp.
31. REMOVE ASSIST GRIP SUB±ASSY
(a) Using a screwdriver, disengage the 2 claws and remove the 2 assist grip covers.
HINT:
Tape the screwdriver tip before use.
(b) Remove the 2 bolts and assist grip.
32. REMOVE VISOR HOLDER
(a) Remove the holder of the sun visor by turning it counter- clockwise.
33. REMOVE SUN ROOF OPENING TRIM MOULDING (W/ SLIDING ROOF)
http://vnx.su

B66557
Clip
w/ Sliding Roof
w/o Sliding Roof
B66554
Tape
w/ Sliding Roof
w/o Sliding Roof
Tape
76±50
±
EXTERIOR/INTERIOR TRIMROOF HEADLINING ASSY(LIFTBACK MODELS)
AVENSIS REPAIR MANUAL (RM1018E)
34.REMOVE ROOF HEADLINING ASSY
(a)Using a clip remover, disengage the 2 clips and remove the roof headling.
35.INSTALL ROOF HEADLINING ASSY
(a)Align the markings, and then install the wire harness with tape.
NOTICE:
Attach the roof wire harness securely.
(b)Install the 2 clips.
36.INSTALL REAR SEAT ASSY (See page 72±21)
http://vnx.su

760WT±01
B66561
Roof Side Garnish Inner RH
Front Pillar Garnish RH
Front Door Opening Trim Weatherstrip RH
Center Pillar Garnish RH
Rear Door Opening Trim Weatherstrip RH
Front Door
Scuff Plate RH
Rear Door Scuff
Plate RH
Cowl Side Trim Board RH
41.2 (420, 30)
Center Pillar Garnish
Lower RH
Front Pillar Garnish LH
Front Door Opening Trim
Weatherstrip LH
Cowl Side Trim Board LH
Front Door Scuff Plate LH
Center Pillar Garnish Lower LH
Rear Door Scuff Plate LH
Center Pillar Garnish LH
Rear Door Opening Trim
Weatherstrip LH
Roof Side Garnish Inner LH
Package Tray
Trim Panel Assy
N
m (kgf
cm ft
lbf): Specified torque
41.2 (420, 30)
±
EXTERIOR/INTERIOR TRIM ROOF HEADLINING ASSY (SEDAN MODELS)
76±33
AVENSIS REPAIR MANUAL (RM1018E)
ROOF HEADLINING ASSY (SEDAN MODELS)
COMPONENTS
http://vnx.su

B70686
LH Visor Assy
Visor Holder Roof Headlining Assy
RH Visor Assy
Map Lamp Assy
Room Lamp Assy No. 2
Lens Cover
Assist Grip
Sub±assy
Lens Cover Assist Grip Sub±assy
Assist Grip Sub±assy
Assist Grip Sub±assy
w/ Sliding Roof
Sun Roof Opening
Trim Moulding
76±34
±
EXTERIOR/INTERIOR TRIM ROOF HEADLINING ASSY (SEDAN MODELS)
AVENSIS REPAIR MANUAL (RM1018E)
http://vnx.su