TOYOTA LAND CRUISER 2003 J100 Navigation Manual

11 3
2003 Land Cruiser 100 Navigation (OM60A00U)
I17070
The center vents may be opened or
closed as shown.
I17028
The side vents may be opened or closed
as shown.
I17029
The lower vent may be opened or closed
as shown.
For removing frost or fog, it is recommend
that you close the lower vent when you use
the “Floor”, the “Floor/Windshield” or the
“Windshield” mode.
Center ventsSide ventsLower vent

11 4
2003 Land Cruiser 100 Navigation (OM60A00U)

SECTION VI
11 5
2003 Land Cruiser 100 Navigation (OM60A00U)
AUDIO SYSTEM
Audio system 11 6
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . . . . . . . . . .

11 6
2003 Land Cruiser 100 Navigation (OM60A00U)
Audio System
Quick reference for your audio system
Page
1. Audio operation screen display button 117
. . . . . . . . . . . . . . . . . . . . . . .
2. Function switch display screen 118
. . . . . . . . . . . . . . . . . . . . . .
3. Cassette tape slot 125 . . . . . . . . . . . .
4. Frequency turning knob 122 . . . . . . .
5. [Radio mode] Preset tuning 122 . . .
[Tape mode] Side change of
cassette tape 127 . . . . . . . . . . . . . . . .
[DISC mode] Disc selection 131 . . .
6. Traffic function button 123 . . . . . . . . .
7. Mode selectors 118 . . . . . . . . . . . . . . .
8. Stopping and ejecting a cassette tape 125 . . . . . . . . . . . . . . . .
9. [Radio mode] Seek tuning 123 . . . . .
[Tape/DISC mode] Direct access
to a desired program 127/131 . . . . .
10. Turning the system on and adjusting the volume 117 . . . . . . . . .

11 7
2003 Land Cruiser 100 Navigation (OM60A00U)
This section describes some of the basic fea-
tures of the audio system. Some information
may not pertain to your system.
Your audio system works when the ignition
key is in the ”ACC” or ”ON” position.
NOTICE
To prevent the battery from being
discharged, do not leave the car audio
on longer than necessary when the
engine is not running.
ocu002
Speech command system
Some descriptions in this manual are
marked with the above indicator. This
means that this function can be activated
using the speech command system.
For the operation of the speech command
system and the command list, see page 98
and 151.
POWERVOL: Push this knob to turn the
audio system on and off. Turn this knob to
adjust the volume. The system turns on in
the last mode used.
AUDIO: Push this button to display switches
for audio system.
Using your audio system:
s
ome basics
(a) Turning the system on and
off

11 8
2003 Land Cruiser 100 Navigation (OM60A00U)
Push the ”AM”, ”FM”, ”TAPE” or ”DISC”
button to turn on that mode. The selected
mode turns on directly.
Push these buttons if you want to switch from
one mode to another.
If the tape or disc is not set, the cassette play-
er or compact disc player does not turn on.
You can turn off the cassette player by eject-
ing the cassette tape. If the audio system
was previously off, then the entire audio sys-
tem will be turned off when you eject the cas-
sette tape. If another function was previously
playing, it will come on again.
UNG604
UNG605
The switches for radio, cassette tape and
disc player operation are displayed on
the liquid crystal display. Touch them
lightly and directly on the screen.

11 9
2003 Land Cruiser 100 Navigation (OM60A00U)
When the audio sound becomes difficult to
be heard due to road noise, wind noise, etc.
during driving, touch the ”ASL” switch. The
system adjusts to the optimum volume and
tone quality according to the noise level. How good an audio program sounds to you
is largely determined by the mix of the treble,
mid−
range, and bass levels. In fact, dif ferent
kinds of music and vocal programs usually
sound better with different mixes of treble,
mid−range, and bass.
A good balance of the left and right stereo
channels and of the front and rear sound lev-
els is also important.
Keep in mind that if you are listening to a ste-
reo recording or broadcast, changing the
right/left balance will increase the volume of
one group of sounds while decreasing the
volume of another.
UNG607
Touching the ”SOUND” switch on the
screen displays the sound adjustment
screen.
(b) Automatic sound levelizer(c) Tone and balance

120
2003 Land Cruiser 100 Navigation (OM60A00U)
UNG608
BASS ”+” or ””: Adjusts low−pitched
tones.
MID ”+” or ””: Adjusts mid −pitched tones.
TREB ”+” or ””: Adjusts high−pitched
tones.
”Front” or ”Rear”: Adjusts sound balance
between the front and rear speakers.
”L” or ”R”: Adjusts sound balance between
the left and right speakers.
”OK”: The previous screen returns. The antenna automatically extends when
the radio is on or the radio RDS system is on,
and retracts when the radio mode is off.
I17003
To adjust the height of the antenna manu-
ally, push the switch.
Clean the antenna mast periodically with a
clean dry cloth.
CAUTION
Before extending the antenna,
confirm
that no one is close enough to get
injured.
NOTICE
 To prevent damage to the antenna,
make sure it is retracted before
driving your vehicle through an
automatic car wash.
 Antenna mast have to be extended
higher than 100 mm (3.94 in) length
when the audio is on. Extend the an-
tenna mast when the radio signal is
weak.
(d) Your radio antenna

121
2003 Land Cruiser 100 Navigation (OM60A00U)
When you insert a cassette, the exposed
tape should be to the right.
NOTICE
Do not oil any part of the cassette
player, and do not insert anything
except a cassette tape into the slot.unc601
If your vehicle is equipped with an automatic
changer, it can play selected discs or contin-
uously play all the discs set in the magazine.
When you set discs into the magazine, make
sure they face the correct way. If not, the
player will display ”DISC CHECK” and the
disc number.
NOTICE
Never try to disassemble or oil any part
of the automatic changer. Do not insert
anything except a compact disc or DVD
video disc into the magazine.
The player is intended for use with 12 cm (4.7
in.) discs only.
(e) Your cassette player(f) Your automatic changer

122
2003 Land Cruiser 100 Navigation (OM60A00U)
UNG610
Push these buttons to choose either an
AM or FM station.
”AM”, ”FM1”, ”FM2” or ”FM TYPE” appears
on the display.
Turn this knob to step up the station band
or to step down.
Your radio automatically changes to stereo
reception when a stereo broadcast is re-
ceived. ”ST” appears on the display. If the
signal becomes weak, the radio reduces the
amount of channel separation to prevent the
weak signal from creating noise. If the signal
becomes extremely weak, the radio
switches from stereo to mono reception. In
this case, ”ST” disappears from the display.
UNG604
1. Tune in the desired station.
2. Touch one of the station selector
switches (16) and hold it until a beep is
heard. This sets the station to the switch
and the frequency appears on the switch.
Each switch can store FM1, FM2 and AM. To
change the preset station to a different one,
follow the same procedure.
The preset station memory is cancelled
when the power source is interrupted by bat-
tery disconnection or a blown fuse.
Radio operation
(a) Listening to the radio(b) Presetting a station