lock AUDI A4 1998 B5 / 1.G AWM Engine Crankshaft Remove And Install Workshop Manual

13-67


Crankshaft, removing and
installing Note:
When working on the engine, it should be secured
to the engine stand using the engine bracket VW
540 Page 10
-27
.
1 -
Bearing shell
For cylinder block with oil grooveDo not interchange used bearing shells
(mark). Install new bearing plates for cylinder block
with the correct color coding Fig. 2
,
Page 13
-72

2 -
Chain sprocket
For oil pump drive chainReplacing Page 13
-77
Pa
ge 1 of 12 Crankshaft, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.3

13-68


3 -
Bearing shell
For bearing cap without oil grooveDo not interchange used bearing shells
(mark). The crankshaft bearing plates in the
bearing covers are supplied as spare part
with the color coding "yellow"
4 -
Thrust washers For bearing 3Different types for cylinder block and
bearing cap Note locating arrangement
5 -
65 Nm +
1/4 turn (90 ) further
Always replaceWhen measuring radial clearance of
crankshaft, tighten to 65 Nm but do not turn
further.
Pa
ge 2 of 12 Crankshaft, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.3

13-69


6 -
Bearing cap
Bearing cap 1: Pulley endBearing cap 3 with recesses for thrust
washers Bearing shell retaining lugs (cylinder
block/bearing cap) must be on the same
side
7 -
10 Nm +
1/4 turn (90 ) further
Always replaceAfter each removal of the bolts replace
sensor wheel Fig. 1
, Page 13
-71

8 -
Needle bearing
For vehicles with manual transmissionPulling out and driving in Page 13
-73
Pa
ge 3 of 12 Crankshaft, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.3

13-72


The bearing plates with the correct thickness are allocated to the cylinder
block at the factory. Colored dots are used to mark the thickness of the
bearing plates.
Note:
Arrow points in direction of travel.
The position of each bearing thickness is marked with letters on the lower
sealing area of the cylinder block.
Note:
The crankshaft bearing cups in the bearing covers are supplied as spare
part with the color coding "yellow". Fig. 2
Allocation of crankshaft bearing plates for cylinder block
Letter on
cylinder block
Color of bearing
S = Black
R = Red
G = Yellow
Pa
ge 6 of 12 Crankshaft, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.3