differential AUDI A4 2000 B5 / 1.G 01A Transmission Differential Assembly User Guide

39-130


Fig. 8 Installing large tapered roller bearing outer race into final
drive cover

Fig. 9 Removing ring gear from differential housing
Pa
ge 11 of 14 Differential, disassemblin
g and assemblin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.15

39-131


WARNING!
Wear protective gloves. Fig. 10 Installing ring gear
- Use 2 centering pins -A- (locally available) as guides.
-
Heat ring gear to approx. 100 C (212 F) and install.

Fig. 11 Installing differential bevel gears
- If large differential bevel gears have been replaced, measure and
select new shims Fig. 12
.
- Insert large differential bevel gears with measured shims.
-
Install small differential bevel gears (turned 180 ) from their final
position, and rotate into place (arrow). - Install and align thrust washers.
- Insert threaded pieces.
- Drive differential gear shaft for bevel gears in to stop and secure with
roll pin.
Pa
ge 12 of 14 Differential, disassemblin
g and assemblin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.15

39-132


Note:
From this point on, do not interchange differential bevel gears and their
respective thrust washers. Fig. 12 Adjusting differential bevel gears
- Insert large differential bevel gears with thinnest shims (0.5 mm).
-
Insert small differential bevel gears (turned 180 ) together with thrust
washers. - Drive in differential bevelgear shaft.
- Press small differential bevel gears outward.
- Press large differential bevel gears in direction indicated (arrows), and
check play.
- Determine thickest shims for large differential bevel gears (on each
side) which still just fits.
- Shims for both sides should be of equal thickness.
- Identify shims according to table. Part numbers parts catalog
Pa
ge 13 of 14 Differential, disassemblin
g and assemblin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.15

39-133
The following shims are available:

Shim thickness (mm)
0.50 0.70 0.90
0.60 0.80 1.00

Note:

The adjustment is also correct if no further play is perceptible, as long as
the differential bevel gears can still be turned (arrow).
Pa
ge 14 of 14 Differential, disassemblin
g and assemblin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.15