brake light AUDI A6 2000 C5 / 2.G Changing Clutch 5Speed Manual Gearbox
[x] Cancel search | Manufacturer: AUDI, Model Year: 2000, Model line: A6, Model: AUDI A6 2000 C5 / 2.GPages: 71, PDF Size: 1.82 MB
Page 11 of 71
12.Slave cylinder ◆ With plug
connection
pipe/hose
◆ Detach from
hose/pipe
assembly =>
Fig.1
◆ Brake fluid must not come into
contact with the
gearbox
◆ Removing and
installing
=>Page 30-34
◆ Do not operate
clutch pedal
after slave
cylinder has
been removed.
◆ Grease lightly
before installing=>Page 30-34.
◆ When installing, push on until the securing bolt Page 2 of 45-Speed Manual Gearbox 01A 4WD4.3.2014vw-wi://rl/A.en-GB.4B-S-S01AA.wi::21141311.xml?xsl=2
Page 14 of 71
Servicing clutch mechanism Removing and installing master cylinder Special tools and workshop equipment required
◆ Hose clamps 3094
Removing
Notes: ◆ Make sure that no brake fluid escapes into the plenum chamber or onto the gearbox below. If this does
happen, clean the affected areas
thoroughly.
◆ When performing work in the
footwell, put cloths on the carpet to
protect it from possible brake fluid
spills.
‒ → Remove cover -1- above plenum
chamber where fitted. ‒ → Clamp off supply hose -A- leading to brake fluid reservoir using special
tool 3094. Detach hose at master
cylinder and plug it.
‒ Remove rubber grommet from cross
panel above connection pipe for
supply hose.
‒ Lever out retaining clip -C- with a
screwdriver and then pull out pipe -
B- slightly.
Old version with internal torx socket-
head bolts: Page 1 of 65-Speed Manual Gearbox 01A 4WD4.3.2014vw-wi://rl/A.en-GB.4B-S-S01AA.wi::21141312.xml?xsl=2
Page 16 of 71
◆ For the sake of clarity, the brake fluid reservoir is not shown here.
◆ To remove the upper torx bolt, the
brake fluid reservoir must be
swivelled slightly to one side.
‒ → Remove the two torx bolts -
arrows-. All models: ‒ Remove driver's storage
compartment: => General Body Assembly, Interior; Repair group 68; Storage compartments, covers; Removing driver's storage compartment
‒ → Detach clutch pedal from master
cylinder. For this purpose, unclip pin
using a screwdriver -arrow 1- and
pull out pin -arrow 2-.
Note: ◆ → During the following steps ensure
that the clutch pedal does not press
the clutch pedal switch -1- out of the
retaining clip, as this would damage
the thread of the switch, as a result of which the switch would have to be replaced.
◆ The switch may only be fitted once
to ensure that it is sufficiently tight.
‒ Unscrew retaining bolts for master
cylinder -arrow 2- and mounting
bracket -arrow 3-.
‒ Pull the complete pedal cluster
slightly towards the passenger compartment and take out the clutch master cylinder -4-. Installing Page 3 of 65-Speed Manual Gearbox 01A 4WD4.3.2014vw-wi://rl/A.en-GB.4B-S-S01AA.wi::21141312.xml?xsl=2