wheel BMW MOTORRAD R 1150 GS 2002 Rider's Manual (in English)

i
2
Introduction
12
General information and
controls
General view, left side
R 1150 GS ............................ 4
General view, right side
R 1150 GS ............................ 5
General view, left side
R 1150 GS Adventure ........... 6
General view, right side
R 1150 GS Adventure ........... 7
Cockpit ................................. 8
Telltale and warning lights ..... 9
Ignition switch and steering
lock ................................ 10-11
Hazard warning lights .......... 12
Power socket ...................... 13
Left handlebar fitting ........... 14
Right handlebar fitting ......... 15
Dualseat R 1150 GS ..... 16-18
Seat
R 1150 GS Adventure .... 19-20
System case .................. 21-23
Aluminium case .............. 24-26
Adjusting the windscreen .... 27Safety check
Checklist ........................ 28-29
Engine oil ....................... 30-31
Fuel ................................ 32-33
Handlebar levers ............ 34-35
Brake system - general .. 36-37
Brake system - without
BMW Integral ABS ......... 38-40
Brake system - with
BMW Integral ABS ......... 41-44
Clutch ................................. 45
Lights ............................. 46-49
Suspension spring
preload .......................... 50-51
Shock absorber .................. 52
Wheels ........................... 53-55
Accessories and tyres......... 56
Accessories and loads ... 56-57
Contents
10geBKg6.book Seite 2 Dienstag, 19. November 2002 1:11 13

2
29
Safety check
Checklist
For this reason, check the
details in the following sections
before you start the journey:
– Fuel level
– Positions of the handlebar-lever fittings
–Brakes
– Brake fluid level
– Clutch fluid level
– Warning lights and telltale lights
–Lights
– Shock absorber settings and spring preload
– Wheel rim and tyre condition,
tread depth and tyre
pressures
– Load, gross weight – Check regularly (every time
you stop for fuel),
on the basis of the following
section:
– Engine oil level
(every second/third stop for
fuel):
– brake pads
If you encounter any problems
or difficulties, it is always best to
contact your authorised BMW
motorcycle dealer. He will pro-
vide the necessary advice and
assistance.
10geBKg6.book Seite 29 Dienstag, 19. November 2002 1:11 13

2
39
Safety check
Checking front brake fluid
level
d Warning:
Do not permit the brake fluid
level to drop below minimum
(MIN).
 Place the motorcycle on the centre stand
– Make sure the ground is level and firm
 Handlebars in straight-ahead
position; front wheel in con-
tact with the ground  Check brake fluid level at
sight glass
MIN minimum level
(centre of sight glass)
L Note:
Gradual wear of the brake pads
causes the brake fluid level in
the reservoir to drop.
Brake system - without BMW Integral ABS
MIN
10geBKg6.book Seite 39 Dienstag, 19. November 2002 1:11 13

2
43
Safety check
Checking front brake fluid
level
d Warning:
Never permit the brake fluid
level to drop below the mini-
mum level (MIN mark)
 Place motorcycle on centre stand
– Make sure the ground is
level and firm
OEOptional extra
 Handlebars in straight-ahead position and front wheel in
contact with the ground
 Read off brake fluid level in sight glass
MIN minimum level
(centre of sight glass)
L Note:
The brake fluid level in the
brake fluid reservoir remains
constant despite wear of the
brake pads.
Brake system - with BMW Integral ABSOE
MIN
10geBKg6.book Seite 43 Dienstag, 19. November 2002 1:11 13

2
45
Safety check
Check fluid level in the
clutch fitting
e Attention:
If the fluid level drops, assume
there is a defect in the clutch
system.
Have the clutch system
checked immediately by a spe-
cialist workshop, preferably an
authorised BMW motorcycle
dealer.
d Warning:
Do not permit the fluid level to
drop below minimum (MIN).
L Note:
The fluid level in the reservoir
rises as the clutch plate wears.
 Place the motorcycle on the
centre stand
– Make sure the ground is level and firm
 Handlebars in straight-ahead
position; front wheel in con-
tact with the ground
 Check fluid level in sight glass
MIN Minimum level
(centre of sight glass)
Clutch
MIN
10geBKg6.book Seite 45 Dienstag, 19. November 2002 1:11 13

2
50
Safety check
1
S
H
d Warning:
Before riding off, always set
spring preload to suit total
weight.
For off-road riding, increase
spring preload at front and
rear by a suitable amount.
Adjusting front spring
preload
 Place motorcycle on centre stand
– Make sure the ground is level and firm
 Use hook wrench and exten- sion (wheel-stud wrench) to
adjust preload of spring 1:
Stage 1 – road ( S)
Stage 3 – loose surfaces
(stone chippings etc.)
Stage 5 – off-road ( H)
Suspension spring preload
10geBKg6.book Seite 50 Dienstag, 19. November 2002 1:11 13

2
53
Safety check
Wheels
Checking wheel rims
d Warning:
Have damaged wheel rims
checked and, if necessary,
replaced by a specialist work-
shop, preferably an author-
ised BMW motorcycle dealer.
Checking spokes
d Warning:
Before riding off, always
make sure that the spokes
are in perfect condition.
Always have damaged
spokes and irregular spoke
tension rectified immediately
by a specialist workshop,
preferably an authorised
BMW motorcycle dealer.  Place the motorcycle on its
centre stand.
– Make sure the ground is level and firm
 Tap spokes with a screw-
driver and listen for the cor-
rect ringing sound
L Note:
If the note varies, spoke tension
is uneven (some spokes too
loose or too tight).
10geBKg6.book Seite 53 Dienstag, 19. November 2002 1:11 13

2
54
Safety check
Wheels
Checking tyre pressures
d Warning:
Incorrect tyre pressures have
a considerable influence on
handling and on tyre life.
Adjust tyre pressures to suit
total weight. Never exceed ei-
ther the motorcycle’s gross
weight or the individual wheel
load limits (b 57). – When tyres are cold:
 Remove valve caps
 Check/correct tyre pressure
Tyre pressures for
road tyres and massive-bar
tyres:
front rear
one-up 2.2 bar 2.5 bar
(31.9 psi) 36 psi)
two-up 2.5 bar 2.7 bar
(36 psi) (39 psi)
two-up
and luggage 2.5 bar 2.9 bar (36 psi) (42 psi)
 Fully tighten valve caps
Screw valve caps on
tightly
d Warning:
At high road speeds, tyre
valves have a tendency to
open as a result of centrifugal
force.
Use only metal valve caps
with rubber seals.
Valve caps that are screwed
on well prevent air from es-
caping suddenly.
10geBKg6.book Seite 54 Dienstag, 19. November 2002 1:11 13

2
55
Safety check
Wheels
Checking tyre tread
Road tyres and massive-bar
tyres
d Warning:
Comply with statutory legal
requirements concerning
minimum tread depth. Worn
tyres can impair handling.
 Measure tread depth at the centre of the tyre tread
BMW's minimum tread depth
recommendation:
front................... 2 mm (0.08 in)
rear.................... 3 mm (0.12 in)
OEOptional extra
d Warning:
The maximum permissible
speed for a motorcycle fitted
with massive-bar tyres
OE is
160 km/h (100 mph): do not
exceed this limit.
A label stating the maximum
permissible speed must be
affixed in the rider’s field of vi-
sion.
e Attention:
If a motorcycle is fitted with
massive-bar tyres
OE, the rear
splash guard must be removed,
(b Maintenance Instructions,
Chapter 2)
10geBKg6.book Seite 55 Dienstag, 19. November 2002 1:11 13

2
57
Safety check
Correct loading
d Warning:
Overloading can impair the
stability of your motorcycle.
 Make sure that the weight is
uniformly distributed between
right and left
 Pack heavy items at the bot- tom of the cases
 Left and right cases
OA
max. 10 kg (22 lbs) per case
 Luggage rack and tank-top
rucksack
OA max. 5 kg (11 lbs)
each
 Check that fastenings are correctly positioned and tight
d Warning:
With cases installed, it is ad-
visable not to exceed
130 km/h (80 mph).
e Attention:
Do not exceed the gross weight
limit of 460 kg (992 lb).
Do not exceed the wheel load
limits of 180 kg (300 lbs) at the
front and 300 kg (728 lbs) at the
rear.
Reset the suspension spring
preload and the shock absorb-
ers to match the gross weight
(
b 50- 52, 54)
The gross weight consists of:
– Motorcycle with full tank
–Rider
– Passenger
– Luggage
OAOptional accessories
Accessories and loads
10geBKg6.book Seite 57 Dienstag, 19. November 2002 1:11 13