BUICK ROADMASTER 1993 Owners Manual

1
I
11 parts, can be very hot. Don’t 1 Ich them. I
do, you can be burned.
Don’t
run the engine if ther I leak. If yo
the engine,
it could lose all coolant. That could
cause an engine Pire, and you could be burned.
Get any leak fixed before you drive the vehicle.
If there seems to be no leaK, start tne engine again to see
if the fan runs when the engine does. If it doesn’t,, your
vehicle needs service. Turn
off the engine.
How to Add Coolant to the Coolant
Recovery Tank
If you,haven’t found a problem yet, but the coolant level
isn’t at or above
“FULL COLD,” add-a 50/50 mixture of
clean water (preferably distilled) and a proper antifreeze
at the coolant recovery tank. (See “Engine Coolant’’ i\
n
the Index for more information about the proper coolant
mix.)
can be dangerous. Plain water, or some other I
liquid like alcohol, can boil before the, proper
coolant mix will. Your vehicle’s coolant warning
system
is set for the proper coolant mix. With
plain water
or the wrong mix, your engine could
get too hot but you wouldn’t get the overheat
warning. Your engine could catch fire.and you
or others could be burned. Use a 50/50 mix of
clean
---- s-- -1 a proper antifr ze.
5
219 1 i

m
m
II
L, CAUTIOP
You can be bu 3d if you spill coolant on hot
engine parts. Coolant contains ethylene
glycc
and it will burn if the engine parts are hot
enough. Don’t
spill coolant on a hot engine.
When the Luolant in the coolant recovery ~~IMC is “1 or
above
“FULL COLD,” start your vehicle.
If the overheat warning continues, there’s one more
thing
you can try. You can add the proper coolantmix
directly to the radiator, but be sure the cooling system is
cool before
you do it.
220

I :I

How to Add Coolant to the Radiator
..
i= :.
i i
i t
.. : :.c, - , -, I. .
I
-" I
-c
2. Then keep turning the
pressure
cap, but now
push down
as you turn
it. Remove the.
pressure cap.
. -..- '. . . . ., 3. Fill the. radiator with
the proper mix, up to
the base of the filler
neck.
1. You can remove the radiator pressure cap when the
cooling system, including the radiator pressure cap
and upper radiator
hose, is no longer hot. Turn the
pressure cap slowly
to the left until it first stops.
(Don't press down while turning the pressure cap.)
If you hear a hiss, wait for that to stop. A hiss means
there is still some pressure left.

4. Then fill the coolant
recovery tank to
e “FULL COLD.”
5. Put the cap back on the
coolant recovery tank,
but leave the radiator
pressure cap off.
7. By this time the coolant ,level inside the radiator
filler neck may be lower.
If the level is lower, add
more
of the proper mix through the filler neck until
the level .reaches the base
of the filler neck.
6. Start the engine and let
it run until you can feel
the upper radiator hose
getting hot. Watch out for the engine fan.
8. Then replace the
pressure cap. Be
sure the arrows on
the pressure cap
line up like this.
223

If a Tire Goes Flat Changing .a Flat Tire
I! CAUTIO1
can slip off the jack and roll over you or othe-
people. You and they could be badly injured.
Find a level place to change your
=
prevent the vehicle from moving:
1. Set the parking brake firmly.
2. Put the shift lever in
3. Turn off the engine. Park),
To be even
more certain the vehicle won't move.
you can put chocks at the front and rear of the
tire farthest away from the one being changed.
That would be the tire on the other side
of the
vehicle. at the otmosite end.

The equipment you’ll need is in the trunk.
..
-. .. . .. .. . , , , , . . . ..,LL ,. , .. i , ., . ,I , ,. . r , . . . , -.. .”: _,,,/ .. . , . ..~ .. I ..
The followin,g steps will tell you,ho.w.to use ihe jack afid
change a tire. , , .. ,.

Or, the equipment for the wagon is in the rear storage
compartment.
..
a
To access the equipmentin your wagon, turn the slotted
release
button located on the rear,edge of thk cover.
Rempve the
covef by pulliing, it away fkom the window
and then sliding it toward the rear, Ming it up and out
of thelower track. The wagon tire changing equipmen1
can
now be removed.

To remove the spare tire, unscrew and remove the wing
nut from the retaining bolt. Using
the tire lift
strap, pull the tire out of the storage
well.
To remove the jack, unscrew the wing -bolt from the jack
retainer. Remove the jack by sliding it forward.
227

Your Buick has a wheel. cover that .must be'removed to
access the wheel nuts; Refer to the picture for the correct
wheel cover removal.
If your vehicle 'has .either of -the:.two following wheel.
covers, they :must be removed &-carefully prying 'at the
outside ,[email protected] the
Bat . end . 1. 'of @e wheel wrench. , . . ,
j.
.. ,. ..
.. . ,. ,
..
,. ..