ignition CADILLAC CATERA 1997 1.G Owner's Manual

Downloaded from www.Manualslib.com manuals search engine Using Cruise Control on Hills
How well the cruise control will work on hills depends
upon your speed, load and the steepness
of the hills.
When going up steep hills, you may have
to step on the
accelerator pedal to maintain your speed. When going
downhill, you may have to brake or shift to a lower gear
to keep your speed down. Of course, applying the brake
takes
you out of cruise control. Many drivers find this to
be too much trouble and don't use cruise control on
steep hills.
Ending Cruise Controls
There are two ways to end cruise control:
0 Step lightly on the brake pedal.
0 Press the OFF button at the end of the cruise lever.
Erasing Speed Memory
The cruise control set speed memory is erased only
when you turn
off the ignition. (Keep in mind that the
set speed memory is not erased when you press
the OFF
button at the end of the cruise lever.)
Exterior Lamps
These controls on the left side of the instrument panel
operate the following lamp systems:
a Lamp control dial (operates all lamps except
twilight sentinel,
fog lamps and brightness control). Pull
this dial toward you to
turn on the interior lamps and
push the dial back
in to turn the lamps off.
2-38

Downloaded from www.Manualslib.com manuals search engine -4
700< Parking lamps, front and rear sidemarker
lamps, taillamps, license plate lamps, ashtray lamps,
backlighting to the radio controls and instrument
panel lights.
so Headlamps .
$0 Fog lamps.
TWILIGHT Twilight sentinel.
OFF Turns the twilight sentinel system off.
@ Instrument panel brightness control.
Turn the lamp control dial clockwise to the first position
to turn on the parking lamps, front and rear sidemarker
lamps, taillamps, license plate lamps, ashtray lamps,
instrument panel lights and backlighting to the center
console controls.
Rotate the lamp control dial counterclockwise to turn
the lamps
off.
Headlamps
Rotate the lamp control dial clockwise to turn on the
low-beam headlamps.
To turn on the high-beam headlamps, the low-beam
headlamps must already be on. Push the turn signal lever
on the left side of the steering wheel away from you to
engage the high-beam headlamps. Pull the lever toward you to return
to the low-beam headlamps. For more
information, see “Headlamp High/Low Changer” earlier
in this section.
Rotate the lamp control dial counterclockwise
to turn
the headlamps off.
Note that if the headlamps are activated while driving
and then you turn your vehicle’s ignition off while the
lamp dial is still turned on, the headlamps will turn
off.
Turn the lamp control dial counterclockwise to turn the
headlamps off and to stop the reminder chime from
sounding. (If you want the headlamps to remain on, you
must manually turn the lamp control dial off and then
back on to the headlamp position. The headlamps will
stay
on until manually turned off again.)
2-39

Downloaded from www.Manualslib.com manuals search engine Wiper Activated Headlamps
This feature activates the low-beam headlamps, parking
lamps, sidemarker lamps and taillamps after the
windshield wipers have been in use for about
20 seconds.
The wiper activated headlamps light the way in poor
weather and also make your vehicle more visible to
other drivers.
If the wipers are on and the ignition switch
is turned off, the headlamps will immediately turn off.
The headlamps will also deactivate if the windshield
wipers have been turned
off for about 20 seconds.
Lamps On Reminder
You will hear a warning buzzer if you open the door
while leaving the lamps
on, if the manual headlamp
control is activated. An exception to this is when you’re
using the twilight sentinel.
Daytime Running Lamps
Daytime Running Lamps (DRL) can make it easier for
others
to see the front of your vehicle during the day.
DRL can be helpful in many different driving
conditions, but they can be especially helpful in the
short periods after dawn and before sunset.
The DRL system will make the high-beam headlamps
come
on at reduced brightness when:
0 your vehicle’s ignition is in RUN or START,
0 the low-beam headlamps are off (the manual lamp
switch is in the
off or park lamp position) and
0 your vehicle’s transmission is shifted out of
PARK (P).
2-40

Downloaded from www.Manualslib.com manuals search engine When DRL are on, only the high-beam headlamps (at
reduced brightness) will be on.
No other exterior lamps
such as the parking lamps, taillamps, etc. will be on
when the
DRL are being used. The instrument panel
won’t be lit up either.
When the twilight sentinel is on and it’s dark enough
outside, the high-beam headlamps (at reduced intensity)
will change to low-beam headlamps. When it’s bright
enough outside, the regular lamps will go off, and the
high-beam headlamps change to the reduced brightness
of DRL.
To idle your vehicle with the headlamps off, turn off the
twilight sentinel switch and shift the transmission into
PARK (P). Placing your vehicle in PARK
(P) disables
the DRL. The DRL will stay
off until you shift out of
PARK
(P).
If you’re not in PARK (P)
and the twilight sentinel
system
is turned off (and it’s
dark enough outside), the
DRL will remain active and
this light on the instrument
panel will appear as a
reminder that headlamps
are required.
The following conditions will override the DRL:
your vehicle’s transmission is shifted back into
PARK
(P) with the ignition in RUN or START,
the low-beam headlamps are turned on (using the
manual lamp control dial),
the wiper activated headlamps are in use (DRL will
come back on
20 seconds after wipers have turned off),
using the flash-to pass feature and
turning on twilight sentinel.
As with any vehicle, you should turn on the regular
headlamp system when you need it.
2-41

Downloaded from www.Manualslib.com manuals search engine Twilight Sentinel
This feature is below the
lamp control dial on the left
side
of the instrument panel.
It automatically switches
the parking lamps and
low-beam headlamps on
and
off by sensing how dark
it is outside.
To operate the twilight sentinel, the ignition must be in
the
RUN or START position and the twilight sentinel
must be turned
on by pressing the OFF button (an
indicator light
in the button will be off when the twilight
sentinel
is activated). If the system senses it is dark
outside, the lamps will turn on. The lamps turn off when
the system detects that it is bright outside.
If you rotate the control dial all the way up, the lamps
will remain
on for about three minutes after the ignition
has been turned to the
OFF or LOCK position. If you
rotate the control dial all the way down, the lamps will
go off quickly. You can adjust the delay time from a few
seconds up to three minutes.
To turn twilight sentinel off, press the OFF button again.
The indicator light
in the button will be on. This lets the
driver know that the system has been turned
off.
Twilight sentinel also turns off if the ignition is turned to
OFF or to LOCK.
1
This light in the instrument
panel will come on if the
-
ignition is on and:
the headlamps have not b een manually turned 1
the twilight sentinel senses it is dark outside,
the twilight sentinel is off and
the transmission is not in PARK (P).
2-43

Downloaded from www.Manualslib.com manuals search engine Light Sensor Interior Lamps
The light sensor for the twilight sentinel is located in the
center of the front defogger grille. If
you cover the
sensor, it will read “dark” and the parking lamps and
low-beam headlamps will come on.
Instrument Panel Brightness Control
This control dial is located to the right of the fog lamp
button.
As you rotate the control dial up, the instrument
panel lights will brighten.
Illuminated Entry
This system turns on the courtesy lamps (dome lamps
and door entry lamps) for about
20 seconds when any of
the following occur:
0 if you manually unlock your vehicle with the key,
if any door is opened or closed or
if you press the unlock button on the
RKE transmitter.
Illuminated entry immediately ends when your vehicle’s
ignition is turned to the RUN or START position.
2-44

Downloaded from www.Manualslib.com manuals search engine Reading Lamps Map Lamps
The
reading lamps are located in the roof. These lamps
and the interior courtesy lamps come on when any door
is opened and it is dark outside.
Placing the button in the center position enables the lamps to come on when any door is opened. Pressing the button
toward the rear of your vehicle disables the lamps when
any door is opened. With the button set toward
the front of
the vehicle, the lamps will always be on.
If the reading lamps are left on, they automatically shut
off 10 minutes after the ignition has been turned off.
This lamp assembly is located in the overhead console
near the optional
sunroo.f control. Press either button to
turn the driver’s or passenger’s side lamp on and press
the button again to turn the lamp
off.
2-45

Downloaded from www.Manualslib.com manuals search engine Cellular Telephone (Option)
Your vehicle has been prewired for dealer installation of
a Catera dual-mode (analog/digital) cellular portable
telephone. Voice activation and hands-free operation
are standard features. For more information, contact
your Catera dealer.
A user’s guide is provided with
the telephone.
Assist Handles
A handle above each door can be used when getting out
of your vehicle.
Garment Hooks
Sunroof (Option)
The express-open sunroof-
provides an airy, spacious
feel to your vehicle’s
interior and can also
increase ventilation. It
includes a sliding glass
panel and a sliding
sunshade. Power is supplied
to the sunroof when the
ignition key is turned to the
RUN position.
For convenience, you will find garment
hooks attached
to each assist handle.
Floor Mats
Your Catera is equipped with rubber-backed front and
rear floor mats. Keep them clean by vacuuming and
using a spot cleaner,
if necessary. Do not machine wash. When you
stop your vehicle and turn the ignition key to
LOCK, you can still use the sunroof. The electrical
power to operate the sunroof will not shut
off until a
door is opened
-- there is no time limit to this feature.
As soon as a door is opened, sunroof movement will
stop immediately.
2-51

Downloaded from www.Manualslib.com manuals search engine Manual Operation
If a failure in the power supply system occurs, the
sunroof can, be manually closed by inserting a screw
driver into the slot
as shown. Turning the screwdriver
counterclockwise will close the sunroof.
The screwdriver
is provided in the tool kit in the trunk
(with the jack).
Programming the Sunroof
If the battery on your vehicle has been disconnected or
is not working, you will need to reprogram the sunroof
following these steps.
With your vehicle’s ignition on:
1. If the sunroof is closed, rotate the control dial to
position
E. Press the dial for about five seconds.
If the sunroof
is open, rotate the control dial to E and
press
until the glass panel has closed. Now continue
pressing the dial for approximately five more seconds.
2. Rotate the control dial to position G and press until
3. Now rotate the control dial to position E and keep
the sunroof is
fully tilted.
pressing
until the sunroof is fully closed.
2-53

Downloaded from www.Manualslib.com manuals search engine Air Bag Readiness Light
There is an air bag readiness light on the instrument
panel, which shows the air bag symbol. The system
checks the air bag’s electrical system for malfunctions.
The light tells you if there is an electrical problem. The
system check includes the air bag sensors, the air bag
modules, the wiring and the diagnostic module. For
more information on the air bag system, see “Air Bag”
in the Index.
This light will come on for
a few seconds when you
i start your engine. Then the
light should go out. This
means the system is ready. The
air bag readiness light should come on for a few
seconds when you turn the ignition key to
RUN. If the
light doesn’t come on then, have it fixed
so it will be
ready
to warn you if there is a problem.
Charging System Indicator Light
When you turn the key to
START, this light will
come on briefly to show
that the generator and
battery charging systems
are working.
If this light stays on, you need service and you should
take your Catera to the dealer at once.
To save the
battery until you get there, turn
off all accessories.
If the air bag readiness light stays on after you start the
engine
or comes on when you are driving, your air bag
system may not work properly. Have your vehicle
serviced right away.
2-63