CADILLAC ESCALADE EXT 2002 2.G Owners Manual

2-75
All-Weather Cargo Area
Your vehicle has the ability to operate in many different
configurations (cargo panels on or off, Midgate up or
down, rear glass in or out), allowing the cargo and
passenger area to be open to the environment. To allow
the vehicle to operate in these configurations, it is
equipped with many different features to help it resist
the elements and protect cargo inside the cargo area.
Some of the features that help with this are the
following: top drain grates, side rail channels, catch
cups, Midgate drain, cargo area floor drains and the
rubber cargo mat. These are all part of the water
management system, which is designed to quickly direct
water out of the cargo box.
Even when the water management system is working
properly and the cover system is on, there may be some
instances (heavy rains, automated car washes etc.) when
water may be present in the following areas:
A. Top drain grates
B. Removable front
drain grate (Midgate
drain grate)
C. Side rail channels
and catch cups
D. Front drainsE. Water drainage area
(around both sides
of the cargo box and
tailgate side)
F. Rear Drains
G. Cargo floor
H. Cargo mat (central
area of mat is
intended to be dry)

2-76
Maintenance and Cleaning
To ensure that the water management system performs
properly, be sure that the Midgate, tailgate and cover
system are fully closed and that each element of the
water management system is clean and not blocked with
debris. Follow the instructions given next in this section
for the proper procedures on cleaning each item of the
water management system.
Top Drain Grates
-- Removal and Cleaning
The top drain grates are located near the rear glass on
both sides of the vehicle. You may need to clean the
grates and drains if there seems to be blockage. But first
you will have to remove the drain grates by pulling them
off of the vehicle. To remove each drain grate, do the
following:
1. Start with the cargo panels off. See ªCargo Panel
Coversº in the Index for more information.
2. Grasp the edges of the grate and pull it out from the
vehicle. Flush the drain with clean water.

2-77
To replace the drain grate do the following:
1. Line up the clips on the vehicle with the slots in
the grate.
2. When you are sure that the clips are aligned with the
slots, push the grate down firmly.
The grate should clip into place. Don't force the grate
if it won't clip into place; realign the clips with the holes
and try again.Side Rail Channels
The side rail channels are located on top of both sides of
the cargo area. You may want to flush them out with
clean water if you notice any debris collecting inside
of them.
When loading cargo into the cargo area, be careful not to
damage the rails.

2-78
Midgate Drain Grate Removal and Cleaning
The Midgate drain grate is located near the base of
the Midgate (the Midgate side facing outside). You will
find a removable drain grate covering the drain. After
hauling dirt, wood chips, pebbles etc. you will need
to flush the Midgate drain with water. But first you
will have to remove the drain grate by using the
following steps:
1. Lower the Midgate. See ªMidgateº in the Index for
more information.
2. Pull up on the rear (side opposite the Midgate) of
the drain grate.
3. Tilt the drain grate away from you and pull it
straight out.
Reverse the procedure to reinstall the drain grate.

2-79
Cargo Area Floor Drains
Your vehicle also has four cargo-area floor drains
located under the cargo mat near the sides of the cargo
area. These drains should be cleaned periodically to
allow water to exit the cargo area.
The cargo mat has cutouts for the drains. You can flush
the drains through the cutouts, but if the cargo area is
extremely dirty you can lift up the edges of the cargo
floor mat (or take the whole mat out) and flush the
drains with water.
Cargo Tie Downs
There are eight cargo tie downs in the rear cargo area.
You can use these to strap cargo in. The tie downs are
also used to secure the cargo cover panel storage bag.
For more information see ªCargo Cover Panelsº in
the Index.

2-80
Luggage Carrier
You can load things on top of your vehicle with
this feature.
The luggage carrier has slats and siderails attached to
the roof and crossrails which can be moved back and
forth to help secure cargo. Tie the load to the siderails or
siderail supports.
NOTICE:
Loading cargo that weighs more than 200 lbs.
(90.6 kg) on the luggage carrier may damage
your vehicle. When you carry large things, never
let them hang over the rear or the sides of your
vehicle. Load your cargo so that it rests on the
slats and does not scratch or damage the vehicle.
Put the cargo against the siderails and fasten it
securely to the luggage carrier.
Don't exceed the maximum vehicle capacity when
loading your vehicle. For more information on vehicle
capacity and loading, see ªLoading Your Vehicleº in
the Index.To prevent damage or loss of cargo as you're leaving,
check now and then to make sure the luggage and cargo
are still securely fastened.
Be sure the cargo is properly loaded.

If small heavy objects are placed on the roof cut a
piece of 3/8 inch plywood to fit inside the crossrails
and siderails to spread the load. If plywood is used,
tie it to the siderail supports.

Tie the load to the crossrails or the siderail supports.
Use the crossrails only to keep the load from sliding.
To move a crossrail, turn the release knobs, on both
sides of the rail, counterclockwise to loosen it. Slide
the crossrail to the desired position balancing the
force side to side. Turn the release knobs, on both
sides of the rail, clockwise to tighten it and try to
slide the crossrail back and forth slightly to be sure
it is tight

If you need to carry long items, move the crossrails
as far apart as they will go. Tie the load to the
crossrails and the siderails or siderail supports. Also
tie the load to the bumpers. Do not tie the load so
tightly that the crossrails or siderails are damaged.

After moving a crossrail, be sure it is securely locked
into the siderail.

2-81
Your vehicle has a Center High-Mounted Stoplamp
(CHMSL) located above the rear glass.
If items are loaded on the roof of the vehicle, care should
be taken not to block or damage the CHMSL unit.
Ashtray and Cigarette Lighter
The ashtray is located in the center console. Press the
raised area on the access door to use the ashtray.
NOTICE:
If you store paper or other things that burn in
your ashtray, they could be set on fire by
cigarettes or other smoking materials. That could
cause a fire and possibly damage your vehicle.
Do not store papers and other things that burn
in your ashtray.
To remove the ashtray, first locate the indentation on the
right side of the ashtray. Then place your fingertip in the
indentation and pry the ashtray out.
To use the cigarette lighter, push it in all the way, and let
go. When it's ready, it will pop back out by itself.
NOTICE:
Holding a cigarette lighter in with your hand
while it's heating can make it overload, damaging
the lighter and the heating element. Just push the
lighter all the way in and let go. When it's done,
it will pop back by itself.

2-82
Sun Visors
To block out glare, you can swing down the visors. You
can also swing them out to help block glare at the front
and side windows.
Illuminated Visor Vanity Mirrors
Pull the sunvisor down and lift the mirror cover to turn
on the lamps. There is a slide switch to adjust the
intensity of the lamps.
Accessory Power Outlets
With accessory power outlets you can power auxiliary
electrical equipment such as a cellular telephone or
CB radio.
Your vehicle is equipped with many accessory
power outlets.
One outlet is located on the instrument panel near the
analog clock. Lift up the door to access the power outlet.
There are also two power outlets located on the back of
the center console. Lift up the door to access the outlets.
NOTICE:
Adding some electrical equipment to your vehicle
can damage it or keep other things from working
as they should. This wouldn't be covered by your
warranty. Check with your dealer before adding
anything that exceeds the amperage rating.

2-83
When adding an electrical accessory or an electrical
component to your vehicle, be sure to follow the
instructions included with it.
Certain power accessory plugs may not be compatible to
the accessory power outlets and could result in blown
vehicle or adapter fuses. If you experience a problem,
see your dealer for additional information on the
accessory power plugs.
NOTICE:
Power outlets are designed for accessory plugs
only. Do not hang any type of accessory or
accessory bracket from the plug. Improper use of
the power outlet can cause damage not covered
by your warranty.
Analog Clock
To adjust the clock,
do the following:
1. Locate the adjustment button to the lower left corner
of the clock.
2. Push and hold the adjustment button to spin the
clock hands. Release the button before you get to
the desired time.
3. Push and release the button to increase the time
by one minute increments until the desired time
is reached.

2-84
OnStar
System (If Equipped)
OnStar is a vehicle communications system that offers a
variety of services and provides a one
-touch hands-free
communication link between you and the OnStar Center.
To receive OnStar services, a service subscription
agreement is required and an additional fee may be
required. Services are available 24 hours a day, 7 days a
week. For more information, call 1
-888-ONSTAR-7
(1
-888-667-8277).
OnStar Services Button: Press this button once
to contact an advisor who will be able to assist you with
these services. If you are not quickly connected, the
system will automatically reset and redial. This ensures
connection to the center; there is no additional action
required. Press the Communication button to cancel the
automatic redial.
Emergency Button: In an emergency situation,
press the emergency service button. Upon receiving the
call, an advisor at the center will locate your vehicle and
assess the situation. If necessary, the advisor will alert
the nearest emergency service provider.
Communication Button: Press this button at
the end of a call. Also press this button to answer a call
from the center, or cancel a call if one of the other
buttons is accidentally pressed. This button is also used
to access OnStar Personal Calling and Virtual Advisor
services. See the OnStar owner package for more
information.
Volume Control: You can control the volume of the
OnStar System using either the volume knob on the
radio or using the steering wheel controls.
Telltale Light: This light will indicate the status of
the system. A solid green light will come on when you
start the vehicle to let you know that the system is on
and is ready to make or receive calls.
If the light blinks green it means that an incoming or
outgoing call is in progress. Press the Communication
button if you notice the light blinking and you are not
on a call.