CADILLAC ESCALADE EXT 2008 3.G Owners Manual
ESCALADE EXT 2008 3.G
CADILLAC
CADILLAC
https://www.carmanualsonline.info/img/23/7930/w960_7930-0.png
CADILLAC ESCALADE EXT 2008 3.G Owners Manual
Trending: dead battery, water pump, parking brake, automatic transmission fluid, clock setting, engine coolant, clock
Page 151 of 496
Use the following instructions for the proper storage
sequence and location for each panel:
A. Secure clip A on the secondary strap.
B. Secure clip B on the secondary strap.
C. Place the remaining primary straps on
top of the lid and tray.2. Starting with cargo panel 1, load the cargo panel
with latches up and facing away from you.
2-73
Page 152 of 496
3. Store cargo panel 2 by loading the cargo panel with
latches down and facing toward you.4. Store cargo panel 3 by loading the cargo panel with
latches up and facing away from you.
2-74
Page 153 of 496
5. Place the primary straps over the three cargo
covers (A). Fasten the four strap clips (B).6. Tighten all straps by pulling on the free end of
each strap.
2-75
Page 154 of 496
7. Close both cross locks at the center of the strap
system to secure tightly.
Panels 3, 2, 1 Loaded
2-76
Page 155 of 496
Reinstalling the Cargo Cover Panels
To reinstall a cargo panel do the following.
1. You can either leave the strap system attached
to the side of the cargo area while it is not in
use, or you can store it inside the top box
storage compartment. SeeTop-Box Storage
on page 2-86for more information.
2. Starting with cargo panel 1, place the latches in
the unlocked position. Place cargo panel 1 on
the cargo area rails while holding the back of
the cargo panel up.Push the panel forward until it is snug against
the Midgate
®and then let the back of the
panel down being sure that the pegs align with
the receivers.
Left Side Shown, Right Side Similar
2-77
Page 156 of 496
3. Push both left latches away from you to lock the
latches. Remember that there are four latches
total for panel 1. You should hear a click when
each latch locks correctly. Lock the remaining
two right latches on panel 1.
The left latch on the cargo covers must be locked
in place before you can lock the right latch. If you
do not follow this exactly, the cargo cover panels
may not lock in place correctly.4. Install cargo cover 2 next. Place the latches in
the unlocked position. Place the cargo cover
panel on the cargo area rails while holding the
back of the cargo panel up.
Push the panel forward until it is snug against the
other panel and then let the back of the panel down
being sure that the pegs align with the receivers.
Left Side Shown, Right Side Similar
2-78
Page 157 of 496
5. Push the latches away from you, starting with the
left latch, to lock the panel in place. You should
hear a click when each latch locks correctly.
6. Install cargo cover 3 next. Place the latches in
the unlocked position. Place the cargo cover
panel on the cargo area rails while holding the
back of the cargo panel up.Push the panel forward until it is snug against the
other panel and then let the back of the panel down
being sure that the pegs align with the receivers.
Left Side Shown, Right Side Similar
2-79
Page 158 of 496
7. Push the latches away from you, starting with the
left latch, to lock the panel in place. You should
hear a click when each latch locks correctly.
Folding and Storage of Straps
To store the folding straps inside the top box storage
compartment, do the following:
1. Extend the six strap ends on a at surface.
2-80
Page 159 of 496
2. Fold the four primary strap ends towards the
center as shown.
3. Take the short strap and surround the folded
webbing, forming a package.4. Take the secondary strap and wrap it around the
package. Finally, attach the hooks to the webbing
and place inside the top box storage compartment.
Cargo Tie Downs
There are cargo tie downs in the rear cargo area
that you can use to strap cargo in.
2-81
Page 160 of 496