ignition CADILLAC FLEETWOOD 1994 User Guide

NOTICE:
Your modern Cadillac doesn’t need .an elaborate “break-in.” But
it will perform better in the long run if you follow these
guidelines:
Keep your speed at 55 mph (88 km/h) or less for the first
1000 miles (160 km).
Don’t drive at any one speed -- fast.or slow -- for the first
1000 miles (160 km). Don’t make full-throttle starts.
Avoid making hard stops for the first 200 miles (322 km) or
so. During this time your new brake linings aren’t yet broken
in. Hard stops with new linings can mean premature wear
and earlier replacement. Follow this “breaking-in’’ guideline
every time
you get new brake linings.
IGNITIQN KEY POSITIONS
This lock
different : gives you
positions. five
‘Before you put the-key in, your ignition will
be in the Lock position. This
position locks your ignition, steering wheel and transmission. It’s an
anti-:theft ,feature.

I
The other positions let you perform these functions:
ACC: Accessory lets you use things like the radio and the windshield
wipers when the engine is
off. To get into “ACC”, push in the key and turn
it toward
you. Yoursteeringwheel will remain locked, just as it was
before you inserted the key.
OFF: This position lets you turn off the engine but still turn the steering
wheel. It doesn’t lock the steering wheel like “Lock.” Use “Off”
if you
must have your car in motion while the engine is
off (for example, if your
car is being pushed).
RUN This is the position for driving.
START This starts your engine.
NOTICE:
If your key seems stuck in “Lock” and you can’t turn it, be sure
it
is all the way in. If it is, then turn the steering wheel left and
right while. you turn the key hard. But turn the key only with
your hand. Using
a tool to force it could break the key or the
ignition switch.
If none of this works, then your vehicle needs
service.
STARTING YOUR ENGINE
Move your shift lever to “P” (Park) or “N” (Neutral). Your,,engine won’t
start in
any other position -- that’s a safety feature. To restart when you’re
already moving, use “N” (Neutral) only.
NOTICE:
Don’t try to shift to “P” (Park).. if your Cadillae is moving. If you
do, you could .damage the transmission. Shift to “P” (Park) only
when your vehicle
is stopped. ”. .
1
W I
D
I
I
-

To start vour V8 engine:
1. Without pushing the accelerator pedal, turn your ignition key to
“Start.” When the engine starts, let
go of the key. The idle speed will
go down as your engine gets warm.
NOTICE:
Holding your key in “Start” for longer than 15 seconds at a time
will cause your battery to be drained much sooner.
And the
excessive heat can damage your starter motor.
2. If it doesn’t start within 3 seconds, push the accelerator pedal about
one-third of the way down, while you hold the ignition key
in “Start.”
When the engine starts, let go of the
key and let up on the accelerator
pedal. Wait about
15 seconds between each try to help avoid draining
your battery.
When starting your engine in very cold weather (below
O°F or -18 C), do
this:
1. With your foot off the accelerator pedal, turn the ignition key to
“Start” and hold it there. After two seconds, push the accelerator
pedal about one-third of the way down. When the engine starts, let go
of the key. Use the accelerator pedal to maintain engine speed, if you
have to, until your engine has run for a while.
2. If your engine still won’t start (or starts but then stops), it could be
flooded with too much gasoline. Try pushing your a,ccelerator pedal all
the way to the floor and holding it there as you hold the key in “Start”
for about three seconds.
If the vehicle starts briefly but then stops
again, do the same thing, but this time keep the pedal down for five or
six seconds. This clears the extra gasoline from the engine.
87

Ensure the shift lever is fully in “P” (Park) range before starting the engine.
Your Cadillac has a brake-transmission shift interlock. You have to fully
apply your regular brakes before you can shift from “P” (Park) when the
ignition key is in the “Run” position.
If you cannot shift out of “P” (Park),
ease pressure on the shift lever
-- push the shift lever all the way into “P77
(Park) as you maintain brake application. Then move the shift lever into the
gear you wish. See “Shifting Out of ‘P’ (Park)” in this part.
R (Reverse)
Use this gear to back up.
NOTICE:
Shifting to “R” (Reverse) while your vehicle is moving forward
could damage your transmission. Shift to “R” only after your
vehicle
is stopped.
To rock your vehicle back and forth to get out of snow, ice or sand
without damaging your transmission, see
“If You’re Stuck: In Sand, Mud,
Ice
or Snow” in the Index.
91

TMLER TOWING PACMGE (OPTION)
If your Fleetwood is equipped with either V92 or V4P package, you can
increase your vehicle's trailer towing capability to
5,000 pounds (2270 kg)
or 7000 lbs. (3178 kg). To determine which package you have, see the
Service Parts Label located on the underside
of the trunk lid. These
packages include a trailering harness located
in the trunk, heavy-duty
engine and transmission cooling.
Also included are heavy-duty front and
rear springs, 2.93:l rear axle ratio and Eagle
GA P235/70R15 tires.
3
a,
I
I
P-NG BRAKE
The parking brake uses the brakes on the rear wheels.
To set the parking brake:
Hold the regular brake pedal down with your right foot. Push down the
parking brake pedal with your left foot.
If the ignition is on, the brake
system warning light will come
on.
I
94

2. Move the shift lever into “P” (Park) position like this:
0 Pull the lever
toward you.
3. With your right foot still holding the brake pedal down, set the
4. Move the ignition key to “Lock.”
parking brake.
5. Remove
the key and take it with you. If you can walk away from your
vehicle with the ignition key in your hand, your vehicle is in
“P”
(Park).
97

having Your Vehicle With the Engine Running
Torque Lock (Automatic Transmission)
If you are parking on a hill and you don’t shift your transmission into “P”
(Park) properly, the weight of the vehicle may put too much force
on the
parking pawl in the transmission.
You may find it difficult to pull the shift
lever out
of “P” (Park). This is called “torque lock.” To prevent torque
lock, always be sure to shift into “P” (Park) properly before you leave the
driver’s seat.
To find out how, see “Shifting Into ‘P’ (Park)” in the Index.
If “torque lock” does occur, you may need to have another vehicle push
yours a little uphill to take some of the pressure from the transmission,
so
you can pull the shift lever out of “P” (Park).
SHIFTING OUT OF “P” (PARK)
Your Cadillac has a brake-transmission shift interlock. You have to fully
apply your regular brake before you can shift from
“P” (Park) when the
ignition is in the “Run” position. See “Automatic Transmission”
in the
Index.
If you cannot shift out of “P” (Park), ease pressure on the shift lever --
push the shift lever all the way into “P” (Park) as you maintain brake
application. Then move the shift lever into the gear you want.
If you ever
hold the brake pedal down but still can’t shift out of “P” (Park), try this:
1. Turn the key to “Off.” Open and close the driver’s door to turn off the
Retained Accessory Power feature.
3
r
b 4
Ir
Eli
I
98

r
r_
c-
POWER WTNDOWS
The controls are near each window. Here’s how the master control works.
0 Push the switch
0 Push the switch
forward to
close.
rearward to open.
Express Down Window (Driver’s Side)
Just press the switch once -- for half a second or more -- and then let go.
The window will go all the way down.
If you want to stop the window as it
is going down, press the switch again.
Your vehicle has Retained Accessory Power
(RAP). When you stop your
vehicle and turn the ignition key to
“OFF”, you can still use your power
windows.
The electrical power to the power windows will not shut off
until you open a door or
10 minutes has passed. If you want this power
for another
10 minutes, just turn the,key to “RUN” and then back.to
‘60~~73.
103

0 Move the Cruise
switch to
"OFF."
To Erase Speed Memory
When you turn off the Cruise Control or the ignition, your Cruise
Control set speed memory is erased.
LIGHTS
You'll find the control here.
It controls these light
systems:
Headlights
Taillights
Parking Lights
0 License Lights
0 Sidemarker Lights
Instrument Panel
I Lights
I 0 Interior Courtesy
Lights
115

Here’s how your light systems work:
Pull the switch out to the first stop to turn on your parking and
Pull the switch out all the way to turn on the headlights.
You can brighten or dim your instrument cluster by rotating the
Push the switch all the way in to turn them off.
Headlight “On” Warning
taillights, side
marker lights, and instrument panel lights.
headlight switch.
If the manual light switch is left on (as when someone has parked your
car), you’ll hear a warning tone when you turn
off the ignition and open
the driver’s door.
Retained Accessory Power
When you stop your Cadillac and turn the ignition to “OFF”, you can use
these accessories for
10 more minutes.
Radio
Power windows
Astroroof (If equipped)
Windshield wipers
Trunk release
When you open
a door, everything will go off. And, after 10 minutes
everything will go off also.
If you want power for another 10 minutes, just turn the key to “RUN”
and back to “OFF”.
Power Drain Protection
When the ignition is off and the interior lights or underhood lights are
accidentally left on, they will automatically shut
off after 10 minutes. This
protects you from a possible dead battery.
To turn power back on, lift up
on the outside door handle or turn the ignition to the “RUN” position.
116
C‘
!
I
El
I
E
ci
e