lock CHEVROLET CAMARO 1993 Repair Manual
[x] Cancel search | Manufacturer: CHEVROLET, Model Year: 1993, Model line: CAMARO, Model: CHEVROLET CAMARO 1993Pages: 358, PDF Size: 15.6 MB
Page 214 of 358

Problems on the Road
Raising your vehicle with the jack improperly positioned
will damage
the
vehicle or may allow the vehicIe
to fall
off the jack. Be sure to fit
the jack lift head into the proper
location before raising your vehicle.
I
- 210
Raise the vehicle by rotating the wheel
wrench clockwise. Raise the vehicle far
mough off the ground
so there is enough
room for the spare tire to
fit.
Remove all the wheel nuts and take off
the flat tire.
ProCarManuals.com
Page 216 of 358

Problems on the Road
Lower the vehicle by rotating the wheel
wrench counterclockwise. Lower the jack
completely.
, .:
il
Tighten the wheel nuts firmly in a
criss-cross sequence as shown.
CAUTION:
,A improperly tightened wheel
nuts can cause the wheel to become
loose and even come off. This could
lead to an accident. Be sure to use
the correct wheel nuts. If you have
to replace them, be sure to get the
right kind.
Stop somewhere as soon as you can
and have the nuts tightened with a
torque wrench to 100 pound-feet
( 140 Nmm).
I I Ill
Don't try to put a wheel cover on your
compact spare tire.
It won't fit. Store the
wheel cover
in the rear area until you
have the flat tire repaired or replaced.
NOTICE:
-elcovers won't fit on your
:ompact spare.
If you try to put a
wheel cover on your compact si re,
you
could damage the wer the
spare.
ProCarManuals.com
Page 227 of 358

To take off the cap, turn it slowly to the
left (counterclockwise). When you put the
cap back on, turn it to
the right until
you hear a clicking noise.
I A If you get gasoline on you and
L then something ignites it, you
could be badly
burned. Gasoline can
spray out on you if you open the
fuel filler
cap too quickly. This
spray
can happen if your tank is
nearly full, and is more likely in
hot ~
weather. Open the fuel filler cap
slowly
and wait for any “hiss” noise
to stop. Then unscrew the cap all the
way.
I
1
If you _____1 need a new cap, be sure to get
the right type. Your dealer can get
one for you. If you get the wrong
type, it may not fit and your fuel
tank and emissions system might be -
I damaged.
Checking Things under
the Hood
Hood Release
To open the hood, first pull the handle
inside the vehicle.
223 9 9 9
ProCarManuals.com
Page 233 of 358

You should look for this on the oil
container, and use
only those oils that
display the logo.
GM Goodwrench@
oil (in Canada, GM
Engine Oil) meets all
the requirements for
your vehicle.
Engine Oil Additives:
Don’t add anything to your oil. Your
Chevrolet dealer is ready
to advise if you
think something should be added.
When to Change Engine Oil:
See if any one of these is true for you:
0 Most trips are less than 4 miles (6
km).
It’s below freezing outside and most
trips are less than
10 miles (16 km).
The engine is at low speed most of the
time (as
in door-to-door delivery, or in
stop-and-go traffic).
0 You tow a trailer often.
0 Most trips are through dusty places.
If any one of these is true for your
vehicle, then you need to change your
oil
and filter every 3,000 miles (5 000 km)
or 3 months - whichever comes first. If none
of them is true, change the oil
every
7,500 miles (12 500 km) or 12
months - whichever comes first. Change
the filter at the first oil change and at
every other
oil change after that.
Engine Block Heater:
An engine block heater can be a big help
if you have to park outside in very cold
weather,
0 OF (- 1 8 O C) or colder. If your
vehicle has this option, see “Engine Block
Heater’’
in the Index.
ProCarManuals.com
Page 255 of 358

I
r 1
3.
4.
5.
Pull the headlight out of the assembly.
Remove
the wiring connector from the
headlight socket by lifting the plastic
locking tabs on the connector and
pulling it from the socket.
Check
the new headlight again. The
number on
the light must match the
number on
the headlight being
replaced. The letter,
“U” or “L,”
must also match.
Plug the wiring connector into the
headlight socket. Snap the locking
tabs onto the socket.
6.
7.
8.
Place the new headlight in the
headlight assembly. The socket must
be pointing
in the same direction the
socket on the burned out bulb was.
Insert the tabs on the aiming ring into
the slots in the headlight assembly.
Hold the aiming ring closed, insert the
screws at the end of the ring. Tighten
the screws
until the aiming ring
touches the plastic nuts on both the
top and bottom.
Do not overtighten.
Do not damage the vertical aiming
bubble.
. ..
9. Check the headlight aim indicators.
The horizontal indicator (A) should be
on
0 (zero). If the vehicle is level, the
vertical indicator
(B) should also be
on 0 (zero). If the vehicle isn’t level,
check the vertical aim on a level
surface as soon as you can. If either
indicator doesn’t read
“0,” adjust the
headlight aim. See “Adjusting
Headlight Aim”
in the Index.
If your vehicle
is damaged in an accident
and the headlight aim seems to be
affected, see your Chevrolet dealer.
Headlights on damaged vehicles may
require recalibration
of the horizontal aim
by your Chevrolet dealer.
251
ProCarManuals.com
Page 258 of 358

Service Station Information
L
h
U
4. Pull the assembly off from the outside.
5. To remove a socket with a tab,
press the tab and turn the socket
counterclockwise.
To remove a
socket without a tab, turn the socket
counterclockwise.
6. To remove the bulb, push in and turn
7. Reverse the steps with a new bulb.
it
counterclockwise, then pull it out.
Rear Sidemarker
To replace a rear sidemarker bulb:
1, Remove the screw from the
sidemarker assembly.
2. To pull out the bulb housing, tilt the
housing
to remove the tabbed end.
3. Turn counterclockwise and pull out
4. Pull out the bulb.
5. Reverse the steps with a new bulb.
the
socket and the bulb.
ProCarManuals.com
Page 278 of 358

Service Station Information
Appearance Care and Maintenance Muterials
~
PART NUMBER
USAGE DESCRIPTION SIZE
1051 51 6
Removes rust and corrosion on chrome and steel
Chrome Cleaner
and Polish 16 oz. (0.473 L) 10501 73
Also old waxes, polishes
Tar and Road Oil Remover 16 oz. (0.473 L) 1 0501 72
Windshield washing system and gas line
Washer Solvent and Gas Line De-lcer 32 02. (0.946 L)
lo501 74 Cleans white and black tires
White Sidewall Tire Cleaner 16 02. (0.473 L)
105021 4
Vinyl, cloth, door trims, seats, carpet, tires, mats
Multi-Purpose Powdered Cleaner 6 Ib. (2.72 kg) 1050429
Glass cleaning and
spot cleaning on vinyls
Glass Cleaner 24 oz. (0.680 L) 1050427
Power
steering
Power Steering Fluid 16 oz. (0.473 L) 1052884
Spot and stain removal on cloth and fabric
Fabric Cleaner' 16 02. (0.473 L) 1050244
Spot and stain removal on leather and vinyl
VinyVLeather Cleaner' 32 02. (0.946 L)
lo501 09 Spray lubricant for hood, hatchback, door hinges, latches
Lubriplate 12 02. (0.340 kg)
1052870
Weatherstrips
Dielectric
Silicone Grease 1 oz. (0.028 kg) 12345579
Exterior wash
Wash-Wax (Concentrated) 16 02. (0.473 L)
1 051 398 Spot and stain removal on cloth and fabric
Spot Lifter' 8 02. (0.237 L)
1050201 16 oz. (0.473 L)
Key-lock cylinders
Multi-Purpose Lubricant
9 02. (0.262 L) 123451 20
Automatic and manual transmission
fluid DEXRON@-IIE 32 02. (0.946 L ) 12345881
Exterior cleaner and polish
Magic Mirror Cleaner-Polish
1051 51 5 Windshield washer solvent and antifreeze
GM Optikleen" 32 oz. (0.946 L)
1052753
Brake fluid Delco-Supreme 11 @ Brake Fluid 16 02. (0.473 L) 1052535
Chassis
Lubricant 14 02. (0.397 kg) 1052497
Year-round coolant and antifreeze
Permanent Type Anti-Freeze Coolant 1 gal. (3.785 L)
105001 1 Windshield cleaner Eon-Ami Powder@ 12 02. (0.340 kg)
12345347
1052271 Hydraulic clutch system
Hydraulic Clutch
Fluid 16 oz. (0.473 L)
Rear axle SAE 80W-9O-GLb 24 02. (0.680 L) J
*Not recommended for pigskin suede leather.
See your General Motors Dealers for these products. See your Maintenance Schedule for other products.
ProCarManuals.com
Page 281 of 358

Power Windows and Other Power
Options
Circuit breakers protect the power
windows and other power accessories.
When the current load is
too heavy, the
circuit breaker opens and closes,
protecting the circuit
until the problem is
fixed or goes away.
Main Fuse Block
(15 Amp.)
Lights Module (Canada); Turn Flasher
(20 Amp.)
3 - HVAC Selector Switch (Heater/Air
Conditioner); Rear Defogger
(25 Amp.)
4 - Engine Control Module; Instrument Cluster; PASS-Key IP Decoder
Module
( 10 Amp.)
1 - Air Bag: SIR Components
2 - Backup Lights; Daytime Running
I
5 - Engine Control Module; PASS-Key
II@ Decoder Module;
Fuel Pump Relay
(1 5 Amp.)
6 - Brake LighVCruise Release
Switch; Hazard Flasher
(20 Amp.)
7 - Power Door Locks; Power Mirrors; Hatch Release (15 Amp.)
8 - Audio Alarm Module; Base@
Relay; Courtesy Lights: Console
Compartment, Glove Box, Dome,
Rearview Mirror and Radio
(15 Amp.)
9 - Audio Alarm Module; Daytime
Running Lights Module (Canada); Diagnostic Energy Reserve
Module; Instrument Cluster
(10 Amp.)
10 - Exterior Lighting (20 Amp.)
11 - Cigarette Lighter; Horn Relay
12 - Power Seats; Rear Defogger
13 - Brightness Control (5 Amp.)
14 - Windshield Wipermasher
15 - Power Windows (35 Amp. Circuit
(25 Amp.)
(35 Amp. Circuit Breaker)
(25 Amp.)
Breaker)
16 - Diagnostic Energy Reserve Module
(3 Amp.)
17 - Radio (15 Amp.)
ProCarManuals.com
Page 282 of 358

Service & Appearance Care
278
Underhood Electrical Center
Fuses
1 - Electronic Brake Control Module
(5 Amp.)
2 - Fog Lamps (20 Amp.)
3 - Not Used
4 - Not Used
5 - Anti-Lock Brake System (5 Amp.)
6 - Coolant Fan Relays; EVAP
Canister Purge Solenoid; Exhaust
Gas Recirculation; Low Coolant
Relay; Reverse Lockout Solenoid
(10 Amp.)
7 - Air Injection Pump Assembly;
8 - Not Used
9 - Fuel Injectors (7.5 Amp.)
10 - Fuel Injectors (7.5 Amp.)
11 - VIN Engine Code S: Camshaft
Air
Pump Relay
(20 Amp.)
Position Sensor; Crankshaft
Position Sensor; Electronic
Ignition Module
(10 Amp.)
VIN Engine Code P: Ignition
Coil; Ignition Coil Driver
(10 Amp.)
12 - Air Conditioning Compressor
Relay; Cruise Control Switches
and Module
(20 Amp.)
Relays
B - Air Conditioning Compressor
C - Anti-Lock Brake System
D - Primary Coolant Fan (Driver Side)
E - Air Pump
F - Secondary Coolant Fan
(Passenger Side)
G - Low Coolant
H - Fog Lamps
J - High Blower
ProCarManuals.com
Page 304 of 358

Maintenance Schedule
Section B: Owner Checks and Services (Cont.)
At lead Once a Year
CHECK
OR SERVICE WHAT TO DO
Lubricate the key lock cylinders with the lubricant specified in Section D.
Lubricate all body door hinges, including the hatchback lid. Al\
so lubricate all hinges and latches,
including those for the hood, rear compartment, console doors a\
nd
any folding seat hardware.
Section
D tells you what to use.
’.
1. Before you start, be sure you have enough room around tne vehicle.
2. Firmly apply both the parking brake (see “Parking Brake” \
in the Index if necessary) and
NOTE: Do not use the accelerator pedal, and be ready to turn off the engin\
e immediately if it
starts.
3. On automatic transmission vehicles, try to start the engine in each gear. The starter should
the regular brake.
work
only in P (Park) or N (Neutral). If the starter works in any other position, your
vehicle needs service.
On manual transmission vehicles, put the shift lever
in Neutral, push the clutch down
halfway and try to start
the engine. The starter should work only when the clutch is pushed
down all
the way to the floor. If the starter works when the clutch isn’t pushed all the way
down. your vehicle needs service.
... 300
ProCarManuals.com