ABS CHEVROLET COLORADO 2021 Duramax Diesel Supplement

Chevrolet/GMC 2.8L Duramax Diesel Engine Supplement (GMNA-Localizing-
U.S./Canada-14465442) - 2021 - CRC - 2/3/20
Vehicle Care 63
Caution
Do not run the engine if there is a leak
in the engine cooling system. This can
cause a loss of all coolant and can
damage the system and vehicle. Have
any leaks fixed right away.
If No Steam Is Coming from the Engine
Compartment
A Driver Information Center (DIC) message,
along with a low coolant condition, can
indicate a serious problem.
If there is an engine overheat warning and
the vehicle does not have a low coolant
condition, and no steam is heard or seen,
the problem may not be too serious.
Sometimes the engine can get a little too
hot when the vehicle:
.Climbs a long hill on a hot day.
.Stops after high-speed driving.
.Idles for long periods in traffic.
.Tows a trailer. See“Driving on Grades”
under “Driving Characteristics and Towing
Tips” in the owner’s manual. If the DIC message comes on with no sign
of steam, try this for a minute or so:
1. In heavy traffic, let the engine idle in N (Neutral) while stopped. If it is safe to
do so, pull off the road, shift to P (Park)
or N (Neutral), and let the engine idle.
2. Turn on the heater to full hot at the highest fan speed and open the window
as necessary.
If the vehicle no longer has the overheat
warning, the vehicle can be driven. Just to
be safe, drive slower for about 10 minutes.
If the warning does not come back on, drive
normally and have the cooling system
checked for proper fill and function.
If the warning continues, pull over, stop, and
park the vehicle right away.
If there is still no sign of steam and the
vehicle is equipped with an engine driven
cooling fan, push down the accelerator until
the engine speed is about twice as fast as
normal idle speed for at least five minutes
while the vehicle is parked. If the warning is
still there, turn off the engine and get
everyone out of the vehicle until it
cools down.
Battery (4-Cylinder Pickup Only)
Pickups with a 4-cylinder diesel engine are
equipped with an AGM (Absorbing Glass
Mat) 12-volt battery. Installation of a
standard 12-volt battery will result in
reduced cold cranking performance. When
using a battery charger on the AGM battery,
use the AGM setting on the charger,
if available, to limit charge voltage to
14.8 volts. Follow the charger manufacturer's
instructions. See “Battery - North America”
in the owner’s manual.