light CHEVROLET KODIAK 2007 Manual Online

If Your Vehicle is Stuck in Sand,
Mud, Ice, or Snow
In order to free your vehicle when it is stuck,
you will need to spin the wheels, but you do not
want to spin your wheels too fast. The method
known as rocking can help you get out when you
are stuck, but you must use caution.
{CAUTION:
If you let your vehicle’s tires spin at high
speed, they can explode, and you or others
could be injured. And, the transmission or
other parts of the vehicle can overheat.
That could cause an engine compartment
re or other damage. When you are stuck,
spin the wheels as little as possible. Do not
spin the wheels above 35 mph (55 km/h)
as shown on the speedometer.
Notice:Spinning the wheels can destroy
parts of your vehicle as well as the tires. If you
spin the wheels too fast while shifting the
transmission back and forth, you can destroy
the transmission.
Rocking Your Vehicle to Get It Out
First, turn the steering wheel left and right.
That will clear the area around the front wheels.
If you have a four-wheel-drive vehicle, shift
into 4HI. SeeFour-Wheel Drive on page 119.
If your vehicle has traction control, you should turn
the traction control system off. SeeTraction
Control System (TCS) on page 216. Then shift
back and forth between REVERSE (R) and
a forward gear, or with a manual transmission,
between FIRST (1) or SECOND (2) and
REVERSE (R), spinning the wheels as little as
possible. Release the accelerator pedal while you
shift, and press lightly on the accelerator pedal
when the transmission is in gear. By slowly
spinning the wheels in the forward and reverse
directions, you will cause a rocking motion
that may free your vehicle. If that does not get
your vehicle out after a few tries, it may need to
be towed out. If your vehicle does need to be
towed out, seeTowing Your Vehicle on page 241.
236

Trailer Connections
Heavy-Duty Trailer Wiring Package
Your vehicle may be equipped with an eight-wire
trailer towing harness. This harness, with a
seven-pin universal heavy-duty trailer connector,
is attached to a bracket on the platform hitch.
The Center High-Mounted Stoplamp (CHMSL)
wire is tied next to the trailer wiring harness for
use with a trailer.
The eight-wire harness contains the following
trailer circuits:
•Yellow: Left Stop/Turn Signal
•Dark Green: Right Stop/Turn Signal
•Brown: Taillamps
•White: Ground
•Light Green: Back-up Lamps
•Light Blue: CHMSL
•Red: Battery Feed
•Dark Blue: Trailer Brake
Trailer Connections
(C7/C8 Models Only)
If your vehicle has these trailer connections, they
are located at the rear of the cab for a tractor
and at the rear of the chassis when towing
a trailer. There will be an air connection and an
electrical connection.
Be sure that the couplings to the trailer are
made correctly.
Air Connections
If you are not connecting the trailer air line
connections to another piece of equipment,
be sure to replace their protective caps.
Electrical Connections
This system is a seven-wire cable that will
connect to the trailer, supplying power to the
trailer’s lighting system. When not in use, it
is stored in the trailer air-hose storage bracket.
243

Very Cold Weather Operation
Follow the instructions listed previously under the
heading “What Fuel to Use.”
Notice:Never use home heating oil or
gasoline in your diesel engine. They can cause
engine damage.
In cold weather, your fuel filter may become
clogged (waxed). To unclog it, move the vehicle to
a warm garage area and warm the filter to
between 32°F and 50°F (0°C to 10°C). You will
not need to replace it. Additional information on the
fuel filter follows.
Water in Fuel
{CAUTION:
Diesel fuel containing water is still
ammable. You could be burned. If you
ever try to drain water from your fuel,
keep sparks, ames and smoking
materials away from the mixture.Notice:If there is water in your diesel fuel
and the weather is warm or humid, fungus and
bacteria can grow in the fuel. They can
damage your fuel system. A diesel fuel biocide
can be used to sterilize your fuel system.
However, your fuel system may still need to be
cleaned. Your dealer can advise you of the
appropriate solution.
If your fuel tank needs to be purged to remove
water, see your dealer or a qualied technician.
Improper purging can damage your fuel system.
Sometimes, water can be pumped into your fuel
tank along with your diesel fuel. This can happen if
a service station does not regularly inspect and
clean its fuel tanks, or if it gets contaminated fuel
from its suppliers.
If this happens, the
water-in-fuel light, if
equipped, will come on
in the instrument panel.
If it does, the water must
be drained. Your dealer
can show you how to
do this.
256

If the light comes on, use this chart to determine
what action to take.
Water In Fuel Light
Problem Recommended Action
Light comes on
intermittently.Drain water from the
fuel filter.
Light stays on at
temperatures above
freezing.Drain the fuel filter
immediately. If no water
can be drained and the
light stays on, see your
dealer for assistance.
Light stays on at
temperatures below
freezing.Drain the fuel filter
immediately. If no water
can be drained, water
may be frozen in the
water drain system, or in
the fuel lines. Move the
vehicle to a warm location
to thaw out, and then
drain the filter system.
Light stays on
immediately after
refueling, and a large
amount of water was
possibly pumped into the
fuel tank.Fuel tank purging is
required. See your dealer
for assistance.
Notice:If you drive when this warning
indicator is on, you can damage your fuel
injection system and your engine. If the
indicator comes on right after you refuel, it
means water was pumped into your fuel tank.
Turn off your engine immediately. Then,
have the water drained at once.
To drain water, do the following:
1. Stop and park the vehicle in a safe place. Turn
off the engine and apply the parking brake.
2. Remove the fuel cap.
3. Place a fuel-resistant container under the fuel
filter. The filter drain valve is located on the
bottom of the fuel filter.
If your vehicle has the 6.6L engine, the fuel
filter is located in the engine compartment on
the driver’s side of the vehicle. If your
vehicle has either the 7.2L or 7.8L engine, the
fuel filters are located in the engine
compartment on the driver’s side of the
vehicle, and on the driver’s side frame rail in
front of the fuel tank.
257

4. Open the drain
valve by turning
two to three turns.
When fuel empties
from the valve,
all the water
has been drained.
Close the valve
hand-tight.
5. Remove the fuel-resistant container and
properly dispose of the contaminated fuel.
To find out how to properly dispose of
contaminated diesel fuel, seeEngine Oil
(Caterpillar
®Diesel Engine) on page 268or
Engine Oil (Gasoline Engine) on page 268or
Engine Oil (DURAMAX
®/Isuzu Diesel
Engine) on page 272.6. Install the fuel cap.
7. Start the engine and let it run for a few
minutes. If the engine stalls, the fuel system
may need to be primed. While draining
the water from the fuel filter, air may enter the
fuel system. If air has entered the fuel
system the fuel system will need to be primed.
If the water-in-fuel light comes on again after
driving a short distance or the engine runs rough
or stalls, a large amount of water has probably
been pumped into the fuel tank. The fuel
tank should be purged.
Fuel Priming
If your vehicle has a Caterpillar®diesel engine,
see the Caterpillar®Diesel Engine Operation and
Maintenance Manual provided with your vehicle.
If your vehicle has a DURAMAX
®/Isuzu diesel
engine, in order for the fuel system to work
properly, the fuel lines must be full of fuel and
contain no air. If air gets into the fuel lines, it will
be necessary to prime the fuel lines to eliminate air
before operating the vehicle.
258

Running Out of Fuel
If the diesel engine stalls and you think that you
have run out of fuel, do this to restart your engine:
{CAUTION:
Diesel fuel is ammable. It could start a
re if it gets on hot engine parts. You
could be burned. Do not let too much fuel
ow from the air bleed valve, and wipe up
any spilled fuel with a cloth.
1. If you are parked on a level surface, add at
least 2 gallons (7.6 liters) of fuel. However, if
you are parked on a slope, you may need
to add up to 5 gallons (18.9 liters) of fuel.
2. Follow the fuel priming procedure earlier in
this section to prime the fuel filter.3. Close the air bleed valve.
4. Turn the ignition key to START for 10 to
15 seconds at a time until your engine
starts. If the engine tries to run, but does not
run smoothly, increase the rpm a little
using the accelerator pedal. This will help
force air through the system.
Your check engine light may come on if the
vehicle has run out of fuel. This light may stay on
for a few drive cycles after the condition is
corrected, but will eventually clear itself.
262

{CAUTION:
If you get fuel on yourself and then
something ignites it, you could be badly
burned. Fuel can spray out on you if you
open the fuel cap too quickly. This spray
can happen if your tank is nearly full, and is
more likely in hot weather. Open the fuel
cap slowly and wait for any “hiss” noise to
stop. Then unscrew the cap all the way.
When you put the cap back on, turn it clockwise
until it is tight.
Notice:If you need a new fuel cap, be sure to
get the right type. Your dealer can get one
for you. If you get the wrong type, it may not
t properly. This may cause your malfunction
indicator lamp to light and may damage
your fuel tank and emissions system. See
Malfunction Indicator Lamp on page 174.If you have dual tanks, fill the driver’s side tank, or
forward tank, first. The fuel gage will give better
readings this way. Your gage will show the
total fuel left in both tanks.
If your vehicle is a C4/C5 model and you have
dual tanks, the engine must be off when refueling
or the fuel transfer system may become
inoperable.
If you have a single tank with dual fillers, where
there is a filler on each side of the vehicle, do not
attempt to fill the tank through both fillers at the
same time. Also, do not fill the tank with both caps
removed, as this may result in over-filling the
tank and fuel spillage.
265

When you tilt the hood far enough, the cables will
support it. When you close the hood, make
sure both latches are secured.
Engine Oil (Caterpillar®Diesel
Engine)
See your Caterpillar®Operation & Maintenance
Manual for information on oil quality and viscosities
as well as the temperature range chart.
Engine Oil (Gasoline Engine)
If the low oil light
appears on the
instrument cluster, it
means you need
to check the engine oil
level right away.
For more information, seeLow Oil Level Light on
page 176.
You should check the engine oil level regularly;
this is an added reminder.
268

GM Goodwrench®oil of the recommended
viscosity grades meets all the requirements for
your vehicle.
Engine Oil Additives
Do not add anything to the oil. The recommended
oils with the API service symbol are all you will
need for good performance and engine protection.
When to Change Engine Oil (Vehicles
Without the Engine Oil Life System)
If you have the 6.6L V8 DURAMAX®Engine:
Change engine oil and filter every 15,000 miles
(24 000 km), or every 12 months, or every
750 hours of engine operation, whichever occurs
first. If you have the Isuzu 6H Engine: Change
engine oil and filter every 12,000 miles
(20 000 km), or every 12 months, or every
600 hours of engine operation, whichever occurs
first. SeeScheduled Maintenance on page 363.
Engine Oil Life System
(Gasoline Engine)
When to Change Engine Oil
Your vehicle has a computer system that lets you
know when to change the engine oil and filter.
This is based on engine revolutions and engine
temperature, and not on mileage. Based on driving
conditions, the mileage at which an oil change
will be indicated can vary considerably. For the oil
life system to work properly, you must reset the
system every time the oil is changed.
When the system has calculated that oil life has
been diminished, it will indicate that an oil change is
necessary. A change engine oil light will come on.
SeeChange Engine Oil Light on page 176. Change
your oil as soon as possible within the next
600 miles (1 000 km). It is possible that, if you are
driving under the best conditions, the oil life system
may not indicate that an oil change is necessary for
over a year. However, your engine oil and filter
must be changed at least once a year and at this
time the system must be reset. Your dealer has
GM-trained service people who will perform this
work using genuine GM parts and reset the system.
It is also important to check your oil regularly and
keep it at the proper level.
276

If the system is ever reset accidentally, you must
change your oil at 3,000 miles (5 000 km)
since your last oil change. Remember to reset the
oil life system whenever the oil is changed.
How to Reset the Engine Oil Life
System
The Engine Oil Life System calculates when to
change your engine oil and filter based on vehicle
use. Anytime your oil is changed, reset the
system so it can calculate when the next oil
change is required. If a situation occurs where you
change your oil prior to a change engine oil light
being turned on, reset the system.
To reset the change engine oil light, do the
following:
1. Turn the ignition key to RUN with the
engine off.
2. Fully press and release the accelerator pedal
slowly three times within 10 seconds.
If the change engine oil light flashes for
five seconds, the system is resetting.
3. Turn the key to OFF.
If the change engine oil light comes back on when
you start your vehicle, the engine oil life system
has not reset. Repeat the procedure.
What to Do with Used Oil
Used engine oil contains certain elements that may
be unhealthy for your skin and could even cause
cancer. Do not let used oil stay on your skin for very
long. Clean your skin and nails with soap and
water, or a good hand cleaner. Wash or properly
dispose of clothing or rags containing used engine
oil. See the manufacturer’s warnings about the use
and disposal of oil products.
Used oil can be a threat to the environment. If you
change your own oil, be sure to drain all the oil from
the filter before disposal. Never dispose of oil by
putting it in the trash, pouring it on the ground, into
sewers, or into streams or bodies of water. Instead,
recycle it by taking it to a place that collects used
oil. If you have a problem properly disposing of your
used oil, ask your dealer, a service station or a local
recycling center for help.
277