hood release CHEVROLET SILVERADO 2017 3.G Owners Manual

Chevrolet Silverado Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-9956065) - 2017 - CRC - 4/29/16
8 In Brief
Auxiliary Button (If Equipped).SeeAdd-On ElectricalEquipment0345.
17.Instrument Panel Storage011 5(If Equipped).
18.Climate Control Systems (withHeater Only)0237orClimateControl Systems (with AirConditioning)0238(IfEquipped).
Dual Automatic Climate ControlSystem0240(If Equipped).
19. Parking Brake Release(Manual Transmission Only, IfEquipped). SeeParkingBrake0293
20.Steering Wheel Controls0121(If Equipped).
Driver Information Center (DIC)Controls (If Equipped). SeeDriver Information Center (DIC)(Base Level)0145orDriverInformation Center (DIC)(Uplevel)0147.
21. Hood Release. SeeHood0353.
22.Horn0122.
23.Steering Wheel Adjustment0120(Out of View).
24.Cruise Control0298.
Forward Collision Alert (FCA)System0304(If Equipped).
25. Data Link Connector (DLC)(Out of View). SeeMalfunctionIndicator Lamp (Check EngineLight)0138.
26.Parking Brake0293.
27. Electronic Transfer CaseControl (If Equipped). SeeFour-Wheel Drive0284.
Card Holder (If Equipped). SeeInstrument PanelStorage011 5.
Initial Drive
Information
This section provides a briefoverview about some of theimportant features that may or maynot be on your specific vehicle.
For more detailed information, referto each of the features which can befound later in this owner manual.
Remote Keyless Entry
(RKE) System
The Remote Keyless Entry (RKE)transmitter functions may work fromup to 60 m (197 ft) away from thevehicle.

Chevrolet Silverado Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-9956065) - 2017 - CRC - 4/29/16
Vehicle Care 353
Vehicle Checks
Doing Your Own
Service Work
{Warning
It can be dangerous to work on
your vehicle if you do not have
the proper knowledge, service
manual, tools, or parts. Always
follow owner manual procedures
and consult the service manual
for your vehicle before doing any
service work.
If doing some of your own servicework, use the proper servicemanual. It tells you much moreabout how to service the vehiclethan this manual can. To order theproper service manual, seeServicePublications OrderingInformation0481.
This vehicle has an airbag system.Before attempting to do your ownservice work, seeServicing theAirbag-Equipped Vehicle086.
Keep a record with all parts receiptsand list the mileage and the date ofany service work performed. SeeMaintenance Records0466.
Caution
Even small amounts of
contamination can cause damage
to vehicle systems. Do not allow
contaminants to contact the fluids,
reservoir caps, or dipsticks.
Hood
To o p e n t h e h o o d :
1. Pull the handle with this symbolon it. It is inside the vehicleunder the steering wheel.
2. Go to the front of the vehicle tofind the secondary hoodrelease. The handle is underthe front edge of the hood nearthe center. Push the handle tothe right and at the same timeraise the hood.
Before closing the hood, be sure allthe filler caps are on properly. Thenbring the hood from full open towithin 15 cm (6 in) from the closedposition, pause, and push the frontcenter of the hood with a swift, firmmotion to fully close the hood.

Chevrolet Silverado Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-9956065) - 2017 - CRC - 4/29/16
Vehicle Care 387
5. Remove the bulb by pulling itstraight out of the bulb socket.
6. Install new bulb into bulbsocket.
7. Turn the bulb socket clockwiseto install it in the headlampassembly.
8. 2500/3500 Series vehiclesonly, driver side:
8.1. Reposition the auxiliarybattery (3).
8.2. Install the auxiliarybattery retainer (1) andbattery retainer bolt (3).
9. If replacing a bulb on thepassenger side, reinstall theengine air cleaner.
10. Close the hood.
Fog Lamps
To r e p l a c e t h e f r o n t f o g l a m p b u l b :
1. Locate the fog lamp under thefront bumper.
2. Disconnect the electricalconnector from the fog lampbulb assembly by pressing theconnector release.
3. Remove the bulb from thehousing by squeezing the tworelease tabs and pulling itstraight out of the assembly.
Taillamps (Chassis Cab
Models)
1. Back-Up Lamp
2. Stoplamp/Taillamp/TurnSignal Lamp
To r e p l a c e o n e o f t h e s e b u l b s :
1. Remove the four screws.
2. Lift the lens off the lampassembly.
3. Turn the old bulbcounterclockwise and pull itstraight out from the socket.
Taillamps, Turn Signal,
Stoplamps, and Back-Up
Lamps
1. Stoplamp/Taillamp/TurnSignal Lamp
2. Back-Up Lamp