warning CHRYSLER CONCORDE 2004 2.G Workshop Manual

CHRYSLER CONCORDE 2004 2.G Workshop Manual CONCORDE 2004 2.G CHRYSLER CHRYSLER https://www.carmanualsonline.info/img/25/8484/w960_8484-0.png CHRYSLER CONCORDE 2004 2.G Workshop Manual

Page 171 of 273

CHRYSLER CONCORDE 2004 2.G Workshop Manual Fuel Filler Cap (Gas Cap)
The gas cap is behind the fuel filler door, on the driver’s
side of the vehicle. If the gas cap is lost or damaged, be
sure the replacement cap is for use with this vehicle

Page 173 of 273

CHRYSLER CONCORDE 2004 2.G Workshop Manual WARNING!
Connecting trailer brakes to your vehicle’s hydraulic
brake lines can overload your brake system and
cause it to fail. You might not have brakes when you
need them and could have an acciden

Page 175 of 273

CHRYSLER CONCORDE 2004 2.G Workshop Manual WHAT TO DO IN EMERGENCIES
CONTENTS
Hazard Warning Flasher.................176
If Your Engine Overheats................176
Jacking And Tire Changing...............177
▫Preparations For Jacking....

Page 176 of 273

CHRYSLER CONCORDE 2004 2.G Workshop Manual HAZARD WARNING FLASHER
The flasher switch is on the steering column, just
behind the steering wheel. Push in the flasher
switch and all front and rear directional signals
will flash. Press the flasher

Page 177 of 273

CHRYSLER CONCORDE 2004 2.G Workshop Manual the fan control to High. This allows the heater core to act
as a supplement to the radiator and aids in removing heat
from the engine cooling system.
CAUTION!
Driving with a hot cooling system could d

Page 178 of 273

CHRYSLER CONCORDE 2004 2.G Workshop Manual Preparations For Jacking
•
Turn on the Hazard Warning Flashers and park the
vehicle on a firm level surface, avoiding ice or slippery
areas.
•Put the gear shift in PARK (Automatic transmission)
or

Page 181 of 273

CHRYSLER CONCORDE 2004 2.G Workshop Manual 9. Lower the vehicle to the ground by turning the jack
handle counterclockwise.
10. Fully tighten the lug nuts. Torque the wheel lug nuts
to 100 ft/lb. (135N. m).
11. Store the flat tire, jack and too

Page 182 of 273

CHRYSLER CONCORDE 2004 2.G Workshop Manual Wheel Cover Installation (If Required)
1. Tighten the two lug nuts on the mounting studs on
each side of the stud which is in alignment with the valve
stem.
2. Align the valve notch in the wheel cover

Page 183 of 273

CHRYSLER CONCORDE 2004 2.G Workshop Manual WARNING!
Battery fluid is a corrosive acid solution; do not
allow battery fluid to contact eyes, skin or clothing.
Don’t lean over battery when attaching clamps or
allow the clamps to touch each oth

Page 185 of 273

CHRYSLER CONCORDE 2004 2.G Workshop Manual 6. Start the engine in the vehicle which has the booster
battery, let the engine idle a few minutes, then start the
engine in the vehicle with the discharged battery.
7. When removing the jumper cable