ignition Citroen C ZERO 2015 1.G Owner's Guide

100
C-zero_en_Chap08_info-pratiques_ed01-2014
2. Inflation
F Check that the compressor switch A is in
the "OFF " position.
F
Un

coil the compressor pipe B .F
Co

nnect this pipe to the valve of the
repaired wheel.
F
Co
nnect the compressor's electric plug to
the vehicle's 12
V s
ocket (ignition switch in
position "ON" or "ACC").
F
St
art the compressor by turning the switch A
to the " ON" position.
F
Us
ing the compressor, adjust the pressure
in accordance with the vehicle's tyre
pressure label (located in the driver's door
aperture).
A lo
ss of pressure indicates that the
puncture has not been fully plugged;
contact a CITROËN dealer or a qualified
workshop for assistance.
F
Re

move the compressor and stow the kit.
F
Dr

ive off straight away at reduced
speed (50
m

ph [80
k
m/h] max) limiting
the distance travelled to approximately
120
m

iles (200
k
m).As soon as possible, go to a CITROËN
dealer or a qualified workshop.
Tell the technician that you have used
the kit. After checking, the technician
will advise you whether the tyre can be
repaired or must be replaced. If after around 5 to 7 minutes the
pressure is not attained, this indicates
that the tyre is not repairable; contact
a CITROËN dealer or a qualified
workshop for assistance.
Practical information

101
C-zero_en_Chap08_info-pratiques_ed01-2014
Changing a wheel
Tools required
- A jack: for lifting the vehicle.
- A wh eelbrace: for removing and refitting
the wheel bolts.
-
A ha

ndle: for operating the jack.
These tools are not supplied with your vehicle.Parking the vehicle
Immobilise the vehicle where it does not
block traffic: the ground must be level,
stable and not slippery.
Apply the parking brake, switch off the
ignition and put the drive selector in
position P to lock the wheels.
If necessary, place a chock under the
wheel diagonally opposite the wheel to
be changed.
You must ensure that the occupants get
out of the vehicle and wait where they
are safe.
Never go underneath a vehicle raised
using a jack; use an axle stand.
Wheel with wheel trim
When removing the wheel , first
remove the wheel trim using the
wheelbrace, by pulling at the valve hole.
When fitting the wheel , refit the wheel
trim starting by aligning the valve hole
with the valve, and then press on the
edge of the trim with the palm of your
hand.
8
Practical information

114
C-zero_en_Chap08_info-pratiques_ed01-2014
Changing a fuse
The extraction tweezer is fitted to the back of
the fusebox cover in the dashboard (left hand
side).
For access:
F
Un
clip the cover and remove it completely
by pulling it towards you.
F
Re

move the tweezer.
Access to tools
Before changing a fuse, the cause of the failure
must be identified and rectified.
F
Ch
eck that the ignition switch is in the
" LOCK " position.
F
Id

entify the faulty fuse by checking the
condition of its filament.
Changing a fuse
Good Failed
F
Us

e the special tweezer to extract the fuse
from its location.
F


a
lw
ays replace the faulty fuse with a fuse
of the same rating.
F
Ch

eck that the number etched on the box,
the rating etched on the top and the tables
below all agree. CITR
oËn w

ill not accept responsibility
for the cost incurred in repairing your
vehicle or for rectifying the malfunctions
resulting from the installation of
accessories not supplied and not
recommended by CITROËN and
not installed in accordance with its
instructions, in particular when the
consumption of all of the additional
equipment connected exceeds
10
mill

iamperes.
Your vehicle's electrical system is
designed to operate with standard or
optional equipment.
Before installing other electrical
equipment or accessories in your
vehicle, contact a CITROËN dealer or a
qualified workshop.
Practical information

134
C-Zero_en_Chap11a_BTA_ed01-2014
EMERGENCY OR ASSISTANCE CALL
In an emergency, press this button for more than 2 seconds.
Flashing of the green LED and a voice message confirm
that the call has been made to the C
ITRoËn

Localised
Emergency Call centre*.
Pressing this button again immediately cancels the call. The green LED
goes off.
Pressing this button (at any time) for more than 8 seconds cancels
the
call.
When the ignition is switched on, the green
LED comes on for 3 seconds indicating that
the system is operating correctly

.
Pressing this button again immediately cancels the request.
The cancellation is confirmed by a voice message.
Press this button for more than 2 seconds to request
assistance if the vehicle breaks down.
A voice message confirms that the call has been made*.
The green LED remains on (without flashing) when communication is
established. It goes off at the end of communication.
This call is dealt with by the C
ITRoËn

Localised Emergency Call centre
which receives locating information from the vehicle and can send a
detailed alert to the appropriate emergency services. In countries in
which the team is not operational, or when the locating service has
been expressly declined, the call is dealt with directly by the emergency
services (112) without the vehicle location.
If an impact is detected by the airbag control unit, and
independently of the deployment of any airbags, an emergency call
is made automatically. If the orange LED flashes: there is a system
fault.
If the orange LED is on continuously: the
backup battery must be replaced.
In either case, contact a CITROËN dealer.
If you purchased your vehicle outside the CITROËN dealer network,
we invite you to have a dealer check the configuration of these services
and, if desired, modified to suit your wishes. In a multi-lingual country ,
configuration is possible in the official national language of your choice.
For technical reasons, particularly to improve the quality of Telematic
services to customers, the manufacturer reserves the right to carry out
updates to the vehicle's on-board telematic system.
If you benefit from the CITROËN eTouch offer, you also have available
additional services in your MyCITROËN personal space, via the CITROËN
Internet website in your country, accessible on www.citroen.com.
*
These services are subject to conditions and availability

.
Consult a CITROËN dealer.
CITROËN Localised Emergency CallCITROËN Localised Assistance Call
Operation of the system

03
142
C-Zero_en_Chap11b_RDE2_ed01-2014
CD, USB
Playing a compilationInsert an MP3 compilation in the CD player or
connect a memory stick to the USB port.
The system creates playlists (temporary memory) the creation time
for which can take from a few seconds to several minutes.
The playlists are updated every time the ignition is switched of f or a
USB memory stick is connected.
Play starts automatically after a period which depends on the
capacity of the USB memory stick.
At a first connection, the order suggested is by folder.
When connecting again, the order previously chosen is
retained. To play a disc or memory stick which
has already been inserted, press
SRC/
TEL several times in succession and
select "CD" or "USB".
Press one of the buttons to select the
next or previous track.
Press one of the buttons to select the
next or previous folder in the order
chosen.
Press and hold one of the buttons for
fast forwards or backwards.
AUDIO

04
146
C-Zero_en_Chap11b_RDE2_ed01-2014
USING THE TELEPHONE
Pairing a Bluetooth telephone / First connection
The services offered depend on the network, the SIM card and the compatibility of the Bluetooth telephone used.
Consult your telephone's manual and your operator to find out which services are available to you.
Activate the telephone's Bluetooth function and
ensure that it is set as visible to all (refer to the
telephone instructions).Press MENU then select "Bluetooth". A window is displayed with
"Searching device".
Select the telephone to be paired from
the list and confirm with "OK". Only
one telephone can be paired at a time.
Select "Search"
.
For safety reasons and because they require prolonged attention on the part of the driver
, the operations for pairing of the Bluetooth mobile
telephone with the Bluetooth hands-free system of your audio system must be carried out with the vehicle stationary and the ignition on.
It is not possible to pair more that 5 telephones. Press MENU and
select "Bluetooth". Select "BT management". If 5 telephones are
already paired, select the telephone to be deleted by pressing "OK"
and select "Delete" (refer to "Managing connections").
Visit www.citroen.co.uk for more information (compatibility, more help, ...).

04
151
C-Zero_en_Chap11b_RDE2_ed01-2014
USING THE TELEPHONE
Hang upIn the contextual menu:
-
select "Combined mode"

to
transfer the call to the telephone.
-
select "Combined mode"

to
transfer the call to the vehicle.
In the contextual menu:
-
select "Micro OFF"

to switch off
the microphone.
-
select "Micro OFF"

to switch the
microphone on again.
In certain cases, the combined mode has to activated from the
telephone.
The Bluetooth connection will be restored automatically if the ignition
has been switched off, then on again (depending on the compatibility
of the telephone).
Managing calls
A long press on SRC/TEL also ends
the call. In the contextual menu, select "Hang
up" to end the call. Secret - Mute
(so that the caller cannot hear)
Combined mode
(to leave the vehicle without ending the call)