display Citroen C5 2007.5 (DC/DE) / 1.G Owner's Guide
[x] Cancel search | Manufacturer: CITROEN, Model Year: 2007.5, Model line: C5, Model: Citroen C5 2007.5 (DC/DE) / 1.GPages: 231, PDF Size: 7.63 MB
Page 79 of 231
83
II
If any of these instances arises, contact a CITROËN dealer as soon as possible.
E L E C T R I C P A R K I N G B R A K E
O P E R A T I N G A N O M A L I E S
SITUATIONCONSEQUENCES
5Display of message « Parking brake control faulty – automatic mode activated » and the following warning lamps:
Only the functions for automatic application on switching off the engine and automatic release on acceleration are available.MANUAL application/release of the electronic parking brake and d ynamic emergency braking are unavailable.
Page 80 of 231
84
II
H I L L S T A R T A S S I S T
To aid starting on a gradient, your vehicle is equipped with a system which keeps it immobilised for a short time (about 2 seconds), the approximate time it takes to move your foot from the brake pedal to the accelerator pedal.
This function is only active when:The vehicle is completely sta-tionary, with your foot on the brake pedal.
In particular conditions on a slope.With the driver's door closed.Note:The hill start assist function cannot be deactivated.
The display of the message “Hill start assist fault” indicates a mal-function of the hill start assist func-tion.
Page 83 of 231
87
II
A
“ H Y D R A C T I V E I I I + ” S U S P E N S I O N
Normal mode, for maximum comfort
A message is displayed on the instrument panel.
“Hydractive III +” suspension auto-matically adjusts to road surface conditions and driving style.
It allows you to alternate between s o f t a n d fi r m s u s p e n s i o n s e t t i n g s , maximising comfort at the same time as permanently guaranteeing the highest level of safety. It also automatically corrects road hold-ing, according to the vehicle load and driving conditions.
Also, the “Hydractive III +” suspen-sion gives you the possibility of choosing between two modes of suspension.
A change of suspension mode can be made either when the vehicle is moving or when stationary, by pressing on button A.
Signalling
Sport mode, more suited for a sporty style of driving
A message is displayed on the instrument panel and the warning lamp on button A comes on.
Note: Sport mode is retained when you switch off the engine.
Note: If the speed authorised for a particular position is exceeded, the vehi-cle reverts automatically to the normal road position.
Note: Automatic variation of ground clearanceIf your speed exceeds 110 km/h (approx. 70 mph), on a good road surface, ground clearance is lowered. The vehicle returns to its normal position if the road sur-face deteriorates or if your speed is lower than 90 km/h (approx. 55 mph).
At low or medium speed, if the road surface is deteriorated, ground clearance is increased. The vehi-cle returns to its normal position once one of these two conditions is no longer observed.
Page 84 of 231
88
II
“ H Y D R A C T I V E I I I + ” S U S P E N S I O N
Position changes may only be made when the engine is run-ning.
Adjustable ground clearance responds to all types of situation. A p a r t f r o m a f e w s p e c i fi c s i t u a -tions, driving in the normal road position is imperative.
To change the position
Press once on one of the adjust-ment controls. The change in posi-tion is indicated by a message on the instrument panel screen:
Maximum height
Changing a wheel (Not possible if speed > 10 km/h).
Intermediate position
For an increased ground clearance (Not possible if speed > 40 km/h).
F o r u s e o n d i f fi c u l t r o a d s w h e n t r a v e l l i n g at reduced speed, as well as on carpark ramps.
Normal road position
Note: If the speed authorised for a par-ticular position is exceeded, the vehicle reverts automatically to the normal road position.
Minimum height
To facilitate loading or unloading the vehicle.
For workshop inspections.
Not to be used in normal driving (Not possible if speed > 10 km/h).
For your safety if you are operating underneath the vehicle, it is obligatory to support the vehicle with axle stands.
Viewing of the position of the vehicle
Once the adjustment has been made, a message is displayed on t he instru-ment panel screen.
Page 86 of 231
90
II
P A R K I N G A S S I S T A N C E
As the vehicle approaches the obstacle, the sound signal becomes more and more urgent and the shaded areas are displayed closer and closer to the vehicle.
Proximity sensors are located in the front and rear bumpers of your vehi-cle.
When manoeuvring whether forwards or in reverse, at a speed below approximately 10 km/h (6 mph), they warn you of the presence of any obstacle located within their detection zone, by means of:A sound signal emitted by the front or rear loudspeakers.
Display of the outline of your vehicle with shading corresponding to the area where an obstacle is detected.
As the vehicle approaches the obstacle, the sound signal tells you the posi-tion of the obstacle according to whether the sound is coming from the front LH or RH or the rear LH or RH loudspeakers.Note: The sound volume of your audio equipment reduces automatically when a signal is being emitted.
Page 87 of 231
91
II
A
P A R K I N G A S S I S T A N C E
Activation/Deactivation
You can activate/deactivate the parking assistance by pressing button A. When the parking assist-ance is inactive, the warning lamp on button A is lit up.
Activation/deactivation of the park-ing assistance is memorised when you stop the vehicle.
Remark: If you are towing with a towing device not approvedby CITROËN, it is necessary to a towing device ing denot approved
deactivate parking assistance by pressing on button A. The warn-ing lamp on the button lights up.
Operation
When you engage reverse gear, a s o u n d s i g n a l c o n fi r m s t o y o u that the system is active. The out-line of your vehicle appears on the screen. Any obstacles located to the rear or to the front of the vehi-cle can be detected.
When going forward and at a speed below approx. 10 km/h (6 mph), whether in neutral or in gear, the outline of the vehicle appears on the display as soon as an obstacle is detected in front of the vehicle. Obstacles located in front of the vehicle will be detected.
Remarks:The proximity sensors cannot detect objects that are immedi-ately under or over the bump-ers.
A thin object such as a spike, a bollard or similar, can only be detected at the start of the manœuvre but not when the vehicle arrives close up to it.In poor weather or in winter, you need to ensure that the sensors are not covered with mud or with ice or snow.
Page 93 of 231
97
III
A U T O M A T I C A I R C O N D I T I O N I N G
G E N E R A L
You are advised to use the automatic air conditioning regulation. This automatically regulates the following f u n c t i o n s f o r m a x i m u m c o m f o r t : a i r fl o w , p a s s e n g e r compartment temperature, and air distribution, using different sensors (external temperature, sunlight). This avoids the need to alter any of the settings, with the exception of the temperature displayed.
Take care not to obstruct the sunlight sensor A.
Provided you retain automatic mode (by pressing button “AUTO”) and all the air vents are open, you will main-tain an optimum comfort level, also removing humidity and misting, whatever the ambient climatic conditions.
The temperature inside the cabin cannot be lower than the temperature outside if the air conditioning is not operating.
To be effective, the air conditioning should only be used with the windows closed. If after a lengthy stop in bright sunlight the interior temperature is excessive, air the passenger compartment by opening the windows for a few moments, then close them again.
To ensure the correct operation of the air conditioning system, it is essential to operate the air conditioning at least once a month.
The air conditioning operates by using power from the engine. This results in a slight increase in fuel con-sumption.
In certain extreme operating conditions (e.g. carrying a full load up a steep gradient in high temperatures), the switching off of the air conditioning allows more power to be transferred to the engine, thereby increasing the towing capacity.
Air inlet
Check that the exterior grille for the air inlet, at the bot-tom of the windscreen, is clean and free of dead leaves, snow, etc.
If washing the vehicle with a high pressure jet, avoid targeting the air inlet zone.
Air circulation
For your comfort we advise you to maintain a proper distribution of air within the cabin, both at the front and at the rear.
To obtain an even distribution of air, ensure that you do obstruct the external air inlet grille located at the base of the windscreen, the air vents, the air outlets on the fl o o r u n d e r n e a t h t h e f r o n t s e a t s , a n d t h e a i r e x t r a c t o r l o c a t e d b e h i n d t h e fl a p s i n t h e b o o t .
T h e f r o n t a n d r e a r a i r v e n t s a r e fi t t e d w i t h c o n t r o l k n o b s w h i c h a l l o w y o u t o c o n t r o l a n d d i r e c t t h e a i r fl o w . I t i s recommended to keep all the air vents open.
D u s t / p o l l e n fi l t e r
T h e r e i s a fi l t e r f o r e x c l u d i n g p o l l e n a n d d u s t .
T h i s fi l t e r h a s t o b e c h a n g e d a c c o r d i n g t o t h e v e h i c l e maintenance schedule. See “Maintenance Guide”.
Page 94 of 231
98
III8285
789
838184
6
81a2a3a4a858684b4b4b81b1b3b3b2b2b
978
A U T O M A T I C A I R C O N D I T I O N I N G
G E N E R A L
1 Automatic operation2 Temperature adjustment3 Adjusting the air distribution4 Activation/deactivation of air conditioning5 A d j u s t i n g t h e a i r fl o w6 Front demisting - deicing7 Rear demisting - deicing8 Air recirculation – Entry of air from outside9 Display
1a Driver's side automatic operation1b Passenger's side automatic operation2a Adjustment of temperature on driver's side2b Adjustment of temperature on passenger's side3a Adjustment of air distribution on driver's side3b Adjustment of air distribution on passenger's side
4a Driver's side display4b Passenger's side display5 A d j u s t i n g t h e a i r fl o w6 Activation/deactivation of air conditioning7 Air recirculation – Entry of air from outside8 Rear demisting - deicing9 Front demisting - deicing
DUAL-ZONE control panel
MONOZONE control panel
Page 95 of 231
99
III8285838184
7896
A
A
A U T O M A T I C A I R C O N D I T I O N I N G
M O N O Z O N E
T h e m o n o z o n e s y s t e m r e g u l a t e s t h e t e m p e r a t u r e , a i r d i s t r i b u t i o n a n d a i r fl o w f o r t h e w h o l e o f t h e p a s s e n g e r c o m -partment.
2. Temperature adjustment
Turn control 2 to change the temperature:Clockwise to increase the temperature.
Anti-clockwise to reduce the temperature.
The chosen temperature is displayed.
An adjustment around 21 will give you the optimum comfort level. However, depending on your preferences anywhere between 18 and 24 is quite usual.
Operating the air conditioning system on “AUTO” guar-antees good ventilation inside the cabin.Note: The value indicated on the display corresponds to a comfort level and not to a temperature in Celsius or Fahrenheit.
Manual mode
One or more functions can be adjusted manually, while still retaining the other functions in automatic mode.
Press one of the buttons, except the temperature adjustment 2. The light A goes out.
Changing to manual mode may result in a decrease in comfort level (temperature, humidity, smell, misting) and is not advised for optimum comfort.
To return to “AUTO” mode, press button 1. Light Acomes on.
Page 97 of 231
101
III
A U T O M A T I C A I R C O N D I T I O N I N G
M O N O Z O N E
7. Rear demisting - deicing
Press button 7, with the engine running, to start a rapid deicing or demisting of the rear screen and rear view mirrors. The warning lamp comes on.
This mode automatically stops depending on the out-side temperature. It can be interrupted by a further press on button 7 or by stopping the engine.
In the latter case, demisting will resume when the engine is switched on again.Note: The heated rear screen operates independently of the automatic air conditioning.
This button activates the recirculation of air in the pas-senger compartment.
Press button 8 to switch off the entry of air from outside. The warning lamp comes on.
Whilst retaining the other settings, this position allows the driver at any moment to exclude unpleasant smells or smoke/emissions coming from outside.
This mode should be cancelled as soon as possible to allow the redistribution of air in the passenger compartment.
8. Air recirculation – Entry of air from outside
Remarks:When starting from cold, in order to prevent unwanted c o l d a i r , t h e a i r fl o w w i l l i n c r e a s e o n l y g r a d u a l l y t o i t s optimum level.
If you enter the vehicle after a fairly prolonged stop and the temperature inside the vehicle is far from comfortable, it serves no purpose to modify the tem-perature that is displayed as an attempt to go imme-diately to the desired comfort level. The system automatically uses all of its power to compensate the temperature gap as quickly as possible.Water arising from the condensation in the air con-ditioning drains out through a hole provided for this purpose ; a pool of water may thus form underneath the vehicle when stationary.
Whatever the time of year, even in cool weather the air conditioning is useful in removing humidity and misting. Avoid driving for too long with air condition-ing deactivated.