wheel DACIA SUPERNOVA 2004 Repair Manual

82A
HORN - ENGINE IMMOBILISER
82A - 8
If further to the diagnostic, it is established
the necessity of the replacement of the anti starting
bushing, proceed as follows: -dismount the attachment screws of the steering wheel casing ;
- unlock the steering wheel and bring it in low position;
-r emove the steering wheel upper casing;
- disconnect the anti starting bushing connector from the front wiring;
-r emove the bushing;
- mount the new bushing outside the starting contact (anti theft) system;
- connect the bushing connector to the front wiring;
- mount the steering wheel casing;
- check the operation of the indicator and the anti starting system when the contact is off,
then with the contact on and the engine started. ANTI STARTING BUSHING REPLACEMENT
vnx.su

83
INSTRUMENT PANEL
DISMOUNTING
Disconnecting battery.
Dismounting flexible shaft( speedometer cable) from the gearbox.
Dismounting control cable from the recyclin g flap.
Dismounting steering wheel and the steering wheel casing.
Dismountin g dashboard lower fairing.
Dismountin g documents compartment.
Disconnect documents compartment lamp.
Dismountin g central console.
Dismounting flaps control cables from the climate control unit.
Discon necting: cigarette lighter, climate control lighting, ashtray lighting, climate control switch .
Dismounting headlamps adjustment control from the dashboard.
Dismounting dashboard from the windscreen lower cross bar.
Disconnecting flexible shaft (speedometer cable) from the instrument panel.
Disconnecting air conducting ducts to aerators.
Disconnecting front wiring from the instrument panel and from the dashboard wiring.
Dismounting instrument panel attachmen t clamps from the dashboard.
Dismountin g clamps from the instrument panel.
Mounting clamps on the new instrument panel.
Mounting instrument panel with clamps on dashboard.
Connecting flexible shaft to the instrument panel.
Connecting front wiring to the instrument panel and to the dashboard wiring.
Positioning and fixing air conducting ducts.
IN
STRUMENT PANEL REPLACEMENT
83-5
vnx.su

83
INSTRUMENT PANEL
Positioning and fixing flaps control cables to the climate control unit.
Connecting dashboard wirin g to: cigarette lighter, climate contro l lighting, climate control switch,
ashtray lighting.
Connecting documents compartment lamp.
Mounting documents compartment.
Mounting central console.
Mounting dashboard lower fairing.
Mounting steering wheel casing and steering wheel.
Mounting flexible shaft to the gearbox.
Mounting control cable to the recycling flap.
Connecting battery.
Functional tests.
REMOUNTING
Perform the dismounting operations in the reverse order.
83-6
IN
STRUMENT PANEL REPLACEMENT
vnx.su

84
CONTROLS - SIGNALLING
84 -1
(STARTING – IGNITION SWITCH)
The anti theft mechanism is placed on the right part of the steering column and has the purpose
to starter control when electric system is connected, being provided in the same time also with a
steering locking device, with anti theft lock.
NOTE
At the anti theft mechanism there is not any more marked G position (garage) because
it does not allow the taking out of the key in this position but helps in pi n unblocking
for removing the mechanism from the steering column.
Disconnect the battery.
Dismount the steering wheel casings.
Disconnect the anti-starting bushing.
Remove the bushing off the steering column.
Disconnect the switch connection wires.
B ring the key in the interme diary position (ex G).
Dismount the attachment screw (1).
P ush the mobile pin ( 2) and pull backwards
the switch.
REMOUNTING
Mount the switch in its place.
Tighten the attachment screw(1).
Connect :
- the switch
- the battery.
Position and mount the anti-star ting bushing.
Connect the anti-starting bushing to the ve-
h icle wirin g.
Check the switch operation.
Mount the steering wheel casings. DISMOUNTING
ANTI THEFT MECHANISM
vnx.su

84
CONTROLS - SIGNALLING
84-3
SI
GNALIZING AND LIGHTING CONTROL SWITCH
DISMOUNTING-REMOUNTING
The lighting control switch e quipping the SupeRNova vehicles includes also the turning-
signalizing switch .
NOTE
The lighting control switch is not to be repaired.
DISMOUNTING
Disconnect the battery.
Dismount the lower steering wheel casing.
Cut the plastic collar which is attaching the wiring on the steering column.
Disconnect the switch connector from the front wiring.
Dismount the switch attachment screw from the steering column.
Dismount the switch.
REMOUNTING
Tighten the switch attachment screws.
Connect the switch connector to the front wiring.
Position the plugs and fix with a new plastic collar.
Connect the battery.
Check the switch operation.
Mount the steering wheel lower casing.
UNDER WHEEL CONTROL MODULE
vnx.su

84
CONTROLS - SIGNALLING
84-4
DISMOUNTING-REMOUNTING OF TH E WINDSCREEN
WIPER-WASHING SWITCH
DISMOUNTING
Disconnect the battery.
Dismount the steering wheel casings.
Disconnect the switch connector.
Dismount the windscreen wiper switch attachment screws (2).
Detach the switch.
REMOUNTING
Fix the switch by tightening its attachment screws (2).
Connect the switch connector to the front wiring.
Mount the steering wheels casings.
Connect the battery.
Check the switch operation.
The SupeRNova vehicles are equipped with TAKOSAN type switches.
2
1
UNDER WHEEL CONTROL MODULE
vnx.su