garage door opener DODGE DURANGO 2011 3.G Owners Manual

▫Enabling And Disabling Parksense ....... 197
▫ Service The Parksense Rear Park Assist
System ............................ 198
▫ Cleaning The Parksense System......... 199
▫ Parksense System Usage Precautions ...... 199
 Parkview Rear Back Up Camera —
If Equipped .......................... 202
▫ Turning Parkview On Or Off — With
Navigation/Multimedia Radio ........... 203
▫ Turning Parkview On Or Off — Without
Navigation/Multimedia Radio ........... 204
 Overhead Console ..................... 204
▫ Front Map/Reading Lights ............. 204
▫ Sunglass Bin Door ................... 205 
Garage Door Opener — If Equipped ........ 206
▫ Programming HomeLink .............. 207
▫ Gate Operator/Canadian Programming .... 210
▫ Using HomeLink ................... 210
▫ Reprogramming A Single
HomeLink Button................... 211
▫ Security ........................... 211
▫ Troubleshooting Tips .................. 211
▫ General Information .................. 212
 Power Sunroof — If Equipped ............ 212
▫ Opening Sunroof — Express ............ 213
▫ Opening Sunroof — Manual Mode ........ 213
▫ Closing Sunroof — Express ............. 214
▫ Closing Sunroof — Manual Mode ........ 214
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 105

4. Enable or disable the rear camera feature by selecting
the “enable rear camera in reverse” soft key and pressing
the “save” soft-key.
Turning ParkViewOn Or Off — Without
Navigation/Multimedia Radio
1. Press the “menu” hard-key.
2. Select “system setup” soft-key.
3. Enable or disable the rear camera feature by selecting
“enable rear camera in reverse” soft-key.
OVERHEAD CONSOLE
The overhead console contains courtesy/reading lights
and storage for sunglasses. Universal Garage Door
Opener (HomeLink), power liftgate and power sunroof
switches may also be included, if equipped.Front Map/Reading Lights
Lights are mounted in the overhead console. Each light
can be turned on by pressing the switch on either side of
the console. These buttons are backlit for night time
visibility.
Overhead Console
204 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

GARAGE DOOR OPENER — IF EQUIPPED
HomeLinkreplaces up to three remote controls (hand-
held transmitters) that operate devices such as garage
door openers, motorized gates, lighting or home security
systems. The HomeLink unit operates off your vehicle’s
battery.
The HomeLink buttons that are located in the overhead
console designate the three different HomeLink chan-
nels.
NOTE:HomeLink is disabled when the Vehicle Secu-
rity Alarm is active.
HomeLink Buttons
206 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

WARNING!
•Your motorized door or gate will open and close
while you are training the universal transceiver.
Do not train the transceiver if people, pets or other
objects are in the path of the door or gate. Only use
this transceiver with a garage door opener that has
a “stop and reverse” feature as required by Federal
safety standards. This includes most garage door
opener models manufactured after 1982. Do not
use a garage door opener without these safety
features. Call toll-free 1–800–355–3515 or, on the
Internet at www.HomeLink.com for safety infor-
mation or assistance.
•Vehicle exhaust contains carbon monoxide, a dan-
gerous gas. Do not run your vehicle in the garage
while training the transceiver. Exhaust gas can
cause serious injury or death.
Programming HomeLink
Before You Begin
If you have not trained any of the HomeLink buttons,
erase all channels before you begin training.
To do this, press and hold the two outside buttons for up
to 20 seconds until the red indicator flashes.
It is recommended that a new battery be placed in the
handheld transmitter of the device that is being copied to
HomeLink for more efficient training and accurate
transmission of the radio-frequency signal.
Your vehicle should be parked outside of the garage
when programming.
1. Turn the ignition switch to the ON/RUN position.
2. Hold the battery side of the handheld transmitter
away from the HomeLink button you wish to program.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 207

Place the handheld transmitter 1 to 3 in (3 to 8 cm) away
from the HomeLinkbutton you wish to program while
keeping the indicator light in view.
3. Simultaneously press and hold both the chosen
HomeLink button and the handheld transmitter button
until the HomeLink indicator changes from a slow to a
rapidly blinking light, then release both the HomeLink
and handheld transmitter buttons.
Watch for the HomeLink indicator to change flash rates.
When it changes, it is programmed. It may take up to
30 seconds or longer in rare cases. The garage door may
open and close while you train.
NOTE:
•Some gate operators and garage door openers may
require you to replace Step 3 with procedures noted in
the “Gate Operator/Canadian Programming” section.
•After training a HomeLink channel, if the garage
door does not operate with HomeLink and the ga-
rage door opener was manufactured after 1995, the
garage door opener may have a rolling code. If so,
proceed to Step 5 “Programming A Rolling Code
System.”
4. Press and hold the just-trained HomeLink button
and observe the indicator light.
If the indicator light stays on constantly, programming is
complete and the garage door (or device) should activate
when the HomeLink button is pressed.
If the indicator light blinks rapidly for two seconds and
then turns to a constant light, proceed to Step 5.
5. Programming A Rolling Code System
At the garage door opener motor (in the garage), locate
the “Learn” or “Training” button.
208 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

This can usually be found where the hanging antenna
wire is attached to the garage door opener motor. It is
NOT the button normally used to open and close the
door.6. Firmly press and release the LEARN or TRAINING
button. The name and color of the button may vary by
manufacturer.
NOTE:
You have 30 seconds in which to initiate the next
step after the LEARN button has been pressed.
7. Return to the vehicle and press the programmed
HomeLink button twice (holding the button for two
seconds each time). If the device is plugged in and
activates, programming is complete.
If the device does not activate, press the button a third
time (for two seconds) to complete the training.
If you have any problems, or require assistance, please
call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.
To program the remaining two HomeLink buttons,
repeat each step for each remaining button. DO NOT
erase the channels.
Training The Garage Door Opener
1 — Door Opener
2 — Training Button
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 209

Gate Operator/Canadian Programming
Canadian radio frequency laws require transmitter sig-
nals to time-out (or quit) after several seconds of trans-
mission – which may not be long enough for HomeLink
to pick up the signal during programming. Similar to this
Canadian law, some U.S. gate operators are designed to
time-out in the same manner.
It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.
If you are having difficulties programming a garage door
opener or a gate operator, replace “Programming
HomeLink” Step 3, with the following: 3. Continue to press and hold the HomeLink
button,
while you press and release (“cycle”), your handheld
transmitter every two seconds until HomeLink has
successfully accepted the frequency signal. The indica-
tor light will flash slowly and then rapidly when fully
trained.
If you unplugged the device for training, plug it back in
at this time.
Then proceed with Step 4 under “Programming
HomeLink,” earlier in this section.
Using HomeLink
To operate, press and release the programmed
HomeLink button. Activation will now occur for the
trained device (i.e., garage door opener, gate operator,
security system, entry door lock, home/office lighting,
etc.,). The handheld transmitter of the device may also be
used at any time.
210 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Reprogramming A Single HomeLinkButton
To reprogram a channel that has been previously trained,
follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired HomeLink button until
the indicator light begins to flash after 20 seconds. Do not
release the button.
3. Without releasing the button, proceed with Program-
ming HomeLink Step 2 and follow all remaining steps.
Security
It is advised to erase all channels before you sell or turn
in your vehicle.
To do this, press and hold the two outside buttons for
20 seconds until the red indicator flashes. Note that all
channels will be erased. Individual channels cannot be
erased. The HomeLink
Universal Transceiver is disabled when
the Vehicle Security Alarm is active.
Troubleshooting Tips
If you are having trouble programming HomeLink, here
are some of the most common solutions:
•Replace the battery in the original transmitter.
•Press the LEARN button on the Garage Door Opener
to complete the training for a Rolling Code.
•Did you unplug the device for training, and remember
to plug it back in?
If you have any problems, or require assistance, please
call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 211

Disposal of Used Coolant............... 497
Drain, Flush, and Refill ................ 495
Inspection .......................... 494
Points to Remember .................. 498
Pressure Cap ........................ 497
Radiator Cap ....................... 497
Selection of Coolant (Antifreeze) .......495,524
Cruise Control (Speed Control) .............. 166
Cupholders ............................ 222
Customer Assistance ..................... 545
Data Recorder, Event ...................... 81
Daytime Running Lights ................... 149
Dealer Service .......................... 480
Defroster, Rear Window ................... 229
Defroster, Windshield ................... 98,324
Diagnostic System, Onboard ................ 477Dipsticks
Automatic Transmission ................ 505
Oil (Engine) ........................ 481
Power Steering ...................... 364
Disabled Vehicle Towing ................... 469
Disposal Engine Oil ......................... 484
Used Engine Fluids ................... 484
Door Locks ............................. 33
Door Locks, Automatic .................... 35
Door Opener, Garage ..................... 206
Driving ............................... 358
Off-Pavement ....................... 358
Off-Road .......................... 358
Driving to Achieve Maximum Fuel Economy .... 268
DVD Player (Video Entertainment System™) .... 315
E-85 Fuel ............................. 414
Electric Remote Mirrors ................... 109
10
INDEX 557

Fluids, Lubricants and Genuine Parts.......... 525
Fog Light Service ........................ 520
Fog Lights .......................... 248,520
Folding Rear Seat ........................ 136
Forward Collision Warning ...........188,261,281
Four-Way Hazard Flasher .................. 448
Front Axle (Differential) ................... 501
Fuel ................................. 410
Additives .......................... 413
Clean Air .......................... 411
Conserving ......................... 268
Ethanol ............................ 411
Filler Cap (Gas Cap) ...............418,421
Gasoline ........................... 410
Gauge ............................ 250
Light ............................. 263
Materials Added ..................... 413
Methanol .......................... 411
Requirements ....................... 524 Saver Mode
........................ 268
Tank Capacity ....................... 524
Fuel Optimizer ......................... 268
Fuel Saver ............................. 268
Fuel System Caution ..................... 420
Fuel, Flexible ........................... 414
Fuses ................................ 511
Garage Door Opener (HomeLink®) ........... 206
Gas Cap (Fuel Filler Cap) ............418,421,477
Gasoline (Fuel) ......................... 410
Conserving ......................... 268
Gasoline, Clean Air ...................... 411
Gasoline, Reformulated ................... 411
Gauges Coolant Temperature .................. 252
Fuel .............................. 250
Speedometer ........................ 249
Tachometer ......................... 244
560 INDEX