ABS DODGE SPRINTER 2008 2.G Owners Manual

23 At a glance
Instrument cluster
1
Brake fluid level too
low
463
EBV malfunction
462
Malfunction in trailer's
brake booster
464
N
Engine oil level warning
as47
1
±
Engine diagnostic
indicator lamp
477
q
Pre-glow system, die-
sel engine only
186
476
Turn signal, left
135
Indicator and Warning Lamps
Page
Indicator and warning lamps
Page
X
Combination low tire
pressure/TPMS mal-
function telltale, USA
only
478
Low tire pressure tell-
tale, Canada only
478
J
Windshield washer/
headlamp cleaning sys-
tem* washer fluid level
too low
482
Door open
483
2
Brake pads / linings
worn
470
Turn signal, right
135
-
ABS malfunction
466
k
ASR malfunction
465
BAS malfunction
465
#
ESP
® malfunction
468
‰
Air cleaner dirty
477
A
Reserve fuel
475
Fuel filler flap open
476
Indicator and warning lamps
Page
nf_BA.book Page 23 Friday, January 25, 2008 3:53 PM

69 Safety
Driving safety systems
2
\3 Driving safety systemsIn this section, you will find information
about the following driving safety sys-
tems: \4
ABS (A
ntilock B
rake S
ystem)
\4
BAS (B
rake As
sist)
\4
ESP
® (E
lectronic S
tability P
rogram)
\4
ASR (acceleration skid control)
\4
EBV (electronic brake force distribu-
tion)
iThe maximum effect of ABS, BAS,
ESP
®, ASR and EBV can only be
achieved if you:
\4
always drive with the correct tire
pressures adjusted according to
the load (
\2
page 361)
\4
use winter tires (M+S tires) in
wintry conditions, with snow
chains if necessary
Warning
G
There is an increased risk of an accident if
you:\4
drive too fast, in particular when corner-
ing and on a wet or slippery road surface
\4drive too close to the vehicle in front
The driving safety systems described in
this section cannot reduce this risk and
are unable to override the laws of physics.
Always adapt your driving style to the pre-
vailing road and weather conditions, and
maintain an adequately safe distance
from other road users as well as any ob-
stacles on the road.
nf_BA.book Page 69 Friday, January 25, 2008 3:53 PM

70 SafetyDriving safety systems
2
ABS regulates the brake pressure in
such a way that the wheels do not lock
when you brake. This allows you to con-
tinue steering when braking.
ABS works from a speed of about 3 mph
(5 km/h) upwards, regardless of road
surface conditions.
ABS works on slippery surfaces, even
when you only brake gently.There is a malfunction if the
-
indica-
tor lamp is permanently lit while the en-
gine is running (
\2
page 466).
Despite this, the normal driving and
braking functions remain available.
iOnly use wheels with the recom-
mended tire sizes (
\2
page 623), oth-
erwise the driving safety systems will
not work correctly.
Antilock Brake System (ABS)
Warning
G
Do not depress the brake pedal several
times in quick succession (pumping). De-
press the brake firmly and evenly. Pump-
ing the brake pedal may reduce the
braking effect.
nf_BA.book Page 70 Friday, January 25, 2008 3:53 PM

71 Safety
Driving safety systems
2
BrakingIf ABS intervenes during braking, you will
feel the steering wheel vibrate gently
and the brake pedal pulsate.
If ABS intervenes: \1
Continue to depress the brake pedal
firmly until the braking situation is
over.
For full brake application:
\1
Depress the brake pedal with maxi-
mum force.Brake Assist operates in emergency
braking situations. If you depress the
brake pedal quickly, BAS automatically
increases the brake pressure, thereby
reducing the stopping distance.
\1
Keep the brake pedal firmly de-
pressed until the emergency braking
situation is over.
ABS prevents the wheels from lock-
ing.
When you release the brake pedal, the
brakes will work as normal again. BAS is
deactivated.
Warning
G
Always adapt your driving style to the pre-
vailing road and weather conditions, and
maintain an adequately safe distance
from other road users as well as any ob-
stacles on the road.
If ABS malfunctions, the wheels could
lock when you brake. This means that the
steerability of the vehicle is restricted
during braking and the stopping distance
may increase. If ABS is deactivated due to
a malfunction, BAS is also deactivated.
Brake Assist (BAS)
nf_BA.book Page 71 Friday, January 25, 2008 3:53 PM

75 Safety
Driving safety systems
2
The ASR switch is located on the center
console.1To deactivate/activate ASR
\1To switch off:
press upper
section
1
of the switch.
The
v
warning lamp in the speed-
ometer lights up.
\1To switch on:
press upper
section
1
of the switch again.
The
v
warning lamp in the speed-
ometer goes out.
Warning
G
ESP
® remains active despite ASR having
been deactivated and carries out braking
interventions if this is necessary to im-
prove driving stability. Thev warning
lamp flashes.
If ASR is deactivated, there is an in-
creased risk that the brake system of your
vehicle could overheat and be damaged
when subjected to high loads for a long
period of time. A hot brake system also in-
creases the stopping distance.
For this reason, only deactivate ASR when
it is absolutely necessary.
N54.25-2916-31
nf_BA.book Page 75 Friday, January 25, 2008 3:53 PM

248 Controls in detailDriving systems
3
\3 Driving systemsDriving systems which may form part of
your vehicle are described on the follow-
ing pages:\4
Cruise control* (
\2
page 248), which
you can use to control the speed of
your vehicle
\4
Parktronic system*, which is an aid
for parking and maneuvering
(\2
page 253)
\4
Rear view camera*, which is an aid
for parking and maneuvering
(\2
page 258)
\4
Reverse warning feature*, which
helps you ensure the safety of other
road users (
\2
page 271)The ABS, BAS, ESP
®, ASR and EBV driv-
ing safety systems are described in the
"Driving Safety Systems" section
(
\2
page 33).
Cruise control maintains the speed of
the vehicle for you.
Use cruise control if road and traffic con-
ditions make it appropriate to maintain a
steady speed for a prolonged period.
You can set any speed above 20 mph
(30 km/h) in 1-mph increments (1-km/
h increments).Cruise control*
iThe increments for setting speed and
the threshold values for switching on
or automatically switching off cruise
control depend on the digital speed-
ometer setting, mph or km/h
(\2
page 165).
nf_BA.book Page 248 Friday, January 25, 2008 3:53 PM

253 Controls in detail
Driving systems
3 i
Cruise control is automatically deac-
tivated if:\4
you are braking
\4
you apply the handbrake and
the
7
indicator lamp in the in-
strument cluster is lit
\4
you are driving under 20 mph
(30 km/h)
\4
ESP
® or ASR is intervening and
the yellow ASR/ESP
® warning
lamp flashes in the instrument
cluster
\4
you move the selector lever to po-
sition
N while driving
\4
ESP
®, ASR or ABS has malfunc-
tioned
Parktronic system (PTS)
*
Warning
G
Parktronic is only an aid and may not de-
tect all obstacles. This system does not
relieve you of the need to pay attention.
You are always responsible for safety and
must continue to pay attention to your im-
mediate surroundings when parking and
maneuvering. Otherwise, you could en-
danger yourself and others.
Warning
G
Make sure that no persons or animals are
in the maneuvering range of the vehicle.
They could otherwise be injured.
nf_BA.book Page 253 Friday, January 25, 2008 3:53 PM

282 Controls in detailTransporting
3
\1
Always attach the lashing net or
tarps to all available lashing points.
While doing so, make sure that the
mounting hooks cannot open unin-
tentionally.
Warning
G
Do not carry out any modifications or repairs
to the lashing points, the lashing eyes or the
lashing materials. The load or the lashing
points could accidentally come loose and
cause serious injury to you or others as well
as damage to property.Distribute loads evenly between the lash-
ing points or lashing eyes.
Observe the loading guidelines.iLoose loads should be secured with
an approved lashing net or tarp.
!
CAUTION
Observe the data on the maximum
load-bearing capacity of the individu-
al lashing points
(\2
page 629).
During full-braking applications, for
example, forces can be involved that
are much greater than the weight
force of the load.
Always use several lashing points in
order to distribute force absorption,
and make sure that the lashing
points have an equal load.
iIf your vehicle has load rails in the
floor, you should position locking
rods immediately in front of and be-
hind the load. The locking rods ab-
sorb possible shifting forces directly.
nf_BA.book Page 282 Friday, January 25, 2008 3:53 PM

338 OperationBattery isolating switch*
4
\3 Battery isolating switch*You can disconnect the current to all
your vehicle’s consumers using the bat-
tery isolating switch. This will prevent
uncontrolled battery discharge caused
by quiescent current consumption.
The battery isolating switch is to the
right of the accelerator pedal in the driv-
er’s footwell.
1Connector
2Slide
Warning
G
If the vehicle is equipped with an auxiliary
battery in the engine compartment, it is
necessary to disconnect both batteries
when working on the vehicle electrical
system. Only then is the electrical system
fully disconnected from the power supply.
iOnly disconnect the vehicle electrical
system from the power supply using
the battery isolating switch if the ve-
hicle is to be parked up for a long pe-
riod or when this is absolutely
necessary.
After the power supply is switched
on, you must reset the electric sliding
door (
\2
page 92).
nf_BA.book Page 338 Friday, January 25, 2008 3:53 PM

342 OperationTires and wheels
4
For more information on tire size desig-
nation, load and speed rating, see "Tire
labeling" (
\2
page 382).
See an authorized Sprinter Dealer for in-
formation on tested and recommended
rims and tires for summer and winter op-
eration. They can also offer advice con-
cerning tire service and purchase.
!
CAUTION
Only use tires which have been test-
ed and approved for your Sprinter ve-
hicle by the vehicle manufacturer.
Tires approved by the vehicle manu-
facturer are developed to provide the
best possible performance in con-
junction with the driving safety sys-
tems on your Sprinter vehicle such as
ABS, BAS, ASR or ESP
®.
Using tires other than those ap-
proved by the vehicle manufacturer
may result in damage that is not cov-
ered by the Sprinter vehicle warran-
ty.
!
CAUTION
Using tires other than those ap-
proved by the vehicle manufacturer
can have detrimental effects, such as
\4
poor handling characteristics
\4
increased noise
\4
increased fuel consumption
Tires and rims not approved by the
vehicle manufacturer may, under
load, exhibit dimensional variations
and different tire deformation char-
acteristics that could cause them to
come into contact with the vehicle
body or axle parts. Damage to the
tires or the vehicle may be the result.
nf_BA.book Page 342 Friday, January 25, 2008 3:53 PM