DODGE TOWN AND COUNTRY 2001 Service Manual

DODGE TOWN AND COUNTRY 2001 Service Manual TOWN AND COUNTRY 2001 DODGE DODGE https://www.carmanualsonline.info/img/12/56921/w960_56921-0.png DODGE TOWN AND COUNTRY 2001 Service Manual
Trending: oil capacities, lights, inflation pressure, recommended oil, MPG, compression ratio, engine overheat

Page 401 of 2321

DODGE TOWN AND COUNTRY 2001  Service Manual (4) Allow the battery to stabilize to open-circuit
voltage. It may take up to five minutes for the bat-
tery voltage to stabilize.
(5) Rotate the load control knob to maintain a load
equal to 50% of t

Page 402 of 2321

DODGE TOWN AND COUNTRY 2001  Service Manual ELECTRONIC MODULE IGNITION-OFF DRAW (IOD) TABLE
ModuleTime Out?
(If Yes, Interval And Wake-Up Input)IODIOD After Time
Out
Radio No1to3
milliamperesN/A
Audio Power
AmplifierNoup to 1
milliampereN/A
Bod

Page 403 of 2321

DODGE TOWN AND COUNTRY 2001  Service Manual REMOVAL - BATTERY
WARNING: A SUITABLE PAIR OF HEAVY DUTY
RUBBER GLOVES SHOULD BE WORN WHEN
REMOVING OR SERVICING A BATTERY.
WARNING: SAFETY GLASSES SHOULD BE WORN
WHEN REMOVING OR SERVICING A BATTERY.

Page 404 of 2321

DODGE TOWN AND COUNTRY 2001  Service Manual BATTERY CABLES
DESCRIPTION
The battery cables are large gauge, stranded cop-
per wires sheathed within a heavy plastic or syn-
thetic rubber insulating jacket. The wire used in the
battery cables comb

Page 405 of 2321

DODGE TOWN AND COUNTRY 2001  Service Manual ²If the vehicle is equipped with an automatic
transmission, place the gearshift selector lever in the
Park position. If the vehicle is equipped with a man-
ual transmission, place the gearshift selec

Page 406 of 2321

DODGE TOWN AND COUNTRY 2001  Service Manual (4) Connect the voltmeter to measure between the
battery negative cable terminal clamp and a good
clean ground on the engine block (Fig. 19). Rotate
and hold the ignition switch in the Start position.

Page 407 of 2321

DODGE TOWN AND COUNTRY 2001  Service Manual (4) Install the battery in the vehicle. Refer to the
procedure in this section.
(5) Connect the negative battery cable.
THERMAL GUARD
DESCRIPTION
A one-piece molded plastic clam shell-type thermal
gua

Page 408 of 2321

DODGE TOWN AND COUNTRY 2001  Service Manual CHARGING
TABLE OF CONTENTS
page page
CHARGING
DESCRIPTION...........................21
OPERATION.............................21
DIAGNOSIS AND TESTING.................22
ON-BOARD DIAGNOSTIC SYSTEM.....

Page 409 of 2321

DODGE TOWN AND COUNTRY 2001  Service Manual DIAGNOSIS AND TESTING - ON-BOARD
DIAGNOSTIC SYSTEM
The Powertrain Control Module (PCM) monitors
critical input and output circuits of the charging sys-
tem, making sure they are operational. A Diagnos

Page 410 of 2321

DODGE TOWN AND COUNTRY 2001  Service Manual SPECIAL TOOLS
SPECIAL TOOLS
BATTERY TEMPERATURE
SENSOR
DESCRIPTION
The PCM incorporates a Battery Temperature Sen-
sor (BTS) on its circuit board.
OPERATION
The PCM uses the temperature of the battery
Trending: power steering, fuel filter, coolant level, keyless, key, fuel reserve, buttons