instrument panel DODGE VIPER 2015 VX / 3.G Owners Manual

HAZARD WARNING FLASHER
The Hazard Warning flasher switch is located in the
center of the instrument panel above the climate controls.
Push the switch to turn on the Hazard Warning
flasher. When the switch is activated, all direc-
tional turn signals will flash on and off to warn oncoming
traffic of an emergency. Push the switch a second time to
turn off the Hazard Warning flasher.
This is an emergency warning system and it should not
be used when the vehicle is in motion. Use it when your
vehicle is disabled and it is creating a safety hazard for
other motorists.
When you must leave the vehicle to seek assistance, the
Hazard Warning flasher will continue to operate even
though the ignition is placed in the OFF position.
NOTE:With extended use the Hazard Warning flasher
may wear down your battery.
IF YOUR ENGINE OVERHEATS
In any of the following situations, you can reduce the
potential for overheating by taking the appropriate ac-
tion.
•On the highways —Slow down and use the highest
gear possible.
•In city traffic —While stopped, put the transmission
in NEUTRAL, but do not increase engine idle speed.
•In city traffic —While moving, shift into the highest
gear possible to reduce engine RPM.
NOTE:There are steps that you can take to slow down
an impending overheat condition:
290 WHAT TO DO IN EMERGENCIES

If the tire pressure is 19 psi (1.3 Bar) or higher:
1. Push the Power Button (4) to turn on Tire Service Kit
and inflate the tire to the pressure indicated on the tire
and loading information label on the driver-side door
opening.
NOTE:If the tire becomes over-inflated, push the Defla-
tion Button to reduce the tire pressure to the recom-
mended inflation pressure before continuing.
2. Disconnect the Tire Service Kit from the valve stem,
reinstall the cap on the valve stem and unplug from 12
Volt outlet.
3. Place the Tire Service Kit in its proper storage area in
the vehicle.
4. Have the tire inspected and repaired or replaced at the
earliest opportunity at an authorized dealer or tire
service center.
5. Remove the Speed Limit sticker from the instrument
panel after the tire has been repaired.
6. Replace the Sealant Bottle (1) and Sealant Hose (6)
assembly at your authorized dealer as soon as pos-
sible. Refer to (F) “Sealant Bottle and Hose Replace-
ment”.
NOTE:When having the tire serviced, advise the autho-
rized dealer or service center that the tire has been sealed
using the Tire Service Kit.
(F) Sealant Bottle And Hose Replacement:
1. Uncoil the Sealant Hose (6) (clear in color).
2. Locate the round Sealant Bottle release button in the
recessed area under the sealant bottle.
3. Push the Sealant Bottle release button. The Sealant
Bottle (1) will pop up. Remove the bottle and dispose
of it accordingly.
302 WHAT TO DO IN EMERGENCIES

Ground Clearance.........................288
Hazard
Driving Through Flowing, Rising, Or Shallow
Standing Water.........................233
Hazard Warning Flasher....................290
Headlights
Automatic............................103
Delay................................103
High Beam/Low Beam Select Switch.........106
Lights On Reminder.....................104
On With Wipers........................103
Passing..............................106
Switch...............................102
Time Delay............................103
Head Restraints...........................99
High Beam/Low Beam Select (Dimmer) Switch . . . .106
Holder, Cup.............................134
HomeLink® (Garage Door Opener)............120
Hood Release............................100
Hydraulic Clutch Fluid.....................335
Illuminated Entry..........................19
Immobilizer (Sentry Key)....................14
Inside Rearview Mirror......................90
Instrument Cluster........................144
Instrument Panel And Controls...............142
Instrument Panel Lens Cleaning...............340
Interior Appearance Care....................338
Interior Lights...........................106
Intermittent Wipers (Delay Wipers).............108
Introduction..............................4
Jump Starting............................303
Key Fob . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11
Programming Additional Key Fobs...........16
Programming Additional Transmitters.........16
386 INDEX