warning FIAT 500L LIVING 2014 2.G Owner's Guide
[x] Cancel search | Manufacturer: FIAT, Model Year: 2014, Model line: 500L LIVING, Model: FIAT 500L LIVING 2014 2.GPages: 420, PDF Size: 9.77 MB
Page 35 of 420
FRONT SEATS
Lengthwise adjustment
Lift lever A fig. 19 (on the inner side of the seat) and
push the seat forwards or backwards: in driving
position your arms should rest on the rim of the
steering wheel.
WARNING
Once you have released the adjustment
lever, always check that the seat is
locked on the guides by trying to move it back
and for th. If the seat is not locked into place,
it may unexpectedly slide and cause the driver
to lose control of the car.Height adjustment
(for versions/markets, where provided)
Move lever B fig. 20 upwards or downwards to
achieve the required height.
IMPORTANT Carry out the adjustment while sitting
on the seat involved (driver side or passenger side).
fig. 19
F0Y0218
fig. 20
F0Y0216
31GETTING TO
KNOW YOUR CARSAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
Page 36 of 420
Backrest angle adjustment
Operate lever C fig. 21 to adjust the backrest angle,
accompanying it with the movement of the torso
(operate the lever until the desired position is
reached, then release it).
Positioning the passenger seat as a table.
(for versions/markets, where provided)
Move the seat fully backwards by operating lever A
(see "Lengthwise adjustment"), operate lever C, fold
the backrest down to the cushion then release
lever C.
It is advisable to carry out this procedure from the
outside, with the left hand.
Before tilting the front passenger seat
table fully, remove any objects laid on it .
WARNING
Do not move the front passenger seat
table if a child is seated on the same or
sitting in the suitable child restraint system.
fig. 21
F0Y0217
32GETTING TO
KNOW YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
Page 37 of 420
Electric lumbar adjustment
(for versions/markets, where provided)
With key at MAR-ON press button A fig. 22 to
operate the lumbar area supporting device for
regulating comfort level when driving.
Release the button when you reach the desired
position.
Electric seat heating
(for versions/markets, where provided)
With the key turned to MAR-ON, press button B to
switch the function on/off.
When the function is enabled, the LED on the
button switches on.
IMPORTANT If this function is activated with engine
off the battery may run down.Driver's side seat armrest
(for versions/markets, where provided)
On some versions the driver's side seat is equipped
with an armrest.
The armrest can be raised/lowered by acting in the
direction shown by the arrows (see fig. 23).
fig. 22
F0Y0215
fig. 23
F0Y0159
33GETTING TO
KNOW YOUR CARSAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
Page 38 of 420
Storage compartment
Behind the front seat backrest there is a storage
compartment fig. 24.
fig. 24
F0Y0270
fig. 25
F0Y0271
34GETTING TO
KNOW YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
Ta b l e
(for versions/markets, where provided)
On some versions, behind the front seat backrest
there is a folding support surface A fig. 25 equipped
with cup/can holders. To fold the support surface
operate point B.
Page 39 of 420
In the rear of the backrests there is also an object
retaining net C.
IMPORTANT Do not place objects heavier than 3 kg
on the supporting surface: for safety reasons the
supporting surface is detached from its housing when
subject to higher loads.
WARNING
Do not travel with the supporting
surface open: always make sure it is
correctly closed.SLIDING AND FOLDING REAR SEATS
Lengthwise adjustment
Raise lever A fig. 26, gripping it in the central area
and push the seat forwards or backwards.
The two parts of the seat can be adjusted
individually.
fig. 26
F0Y0074
35GETTING TO
KNOW YOUR CARSAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
Page 40 of 420
Backrest angle adjustment
Raise lever B fig. 27 and adjust the backrest angle,
accompanying it with the movement of the torso.
The backrest can be further folded to improve
driving comfort.
To increase the room between seat and parcel shelf
grab tab C fig. 28 on the parcel shelf and secure it on
the magnetic device D, then operate lever B to
bring the backrest in the desired position.Rear armrest
(for versions/markets, where provided)
To use the armrest fig. 29, lower it as shown in the
figure.
fig. 27
F0Y0259
fig. 28
F0Y0066
fig. 29
F0Y0163
36GETTING TO
KNOW YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
Page 41 of 420
HEAD RESTRAINTSFRONT
They are height-adjustable: to adjust them, operate
as follows.
Upwards adjustment: raise the head restraint until it
clicks into place.
Downwards adjustment: press button A fig. 30 and
lower the head restraint.
Proceed as follows to remove the head restraints:
❒raise the head restraints to their maximum height;
❒press buttons A and B (at the side of the two
head restraint supports), then remove the head
restraints by pulling them upwards.REAR
(for versions/markets, where provided)
Two height-adjustable head restraints are provided
for the rear seats. On some versions a head restraint
is also provided for the central seat.
Upwards adjustment: raise the head restraint until it
clicks into place.
Downwards adjustment: press button A fig. 31 and
lower the head restraint.
Proceed as follows to remove the head restraints:
❒raise the head restraints to their maximum height;
❒press buttons A and B fig. 31 at the side of the
two supports, then remove the head restraints
by pulling them upwards.
IMPORTANT If the rear seats are used, always set
the head restraints in the "completely raised"
position.
fig. 30
F0Y0060
fig. 31
F0Y0061
37GETTING TO
KNOW YOUR CARSAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
Page 42 of 420
STEERING WHEELThe steering wheel can be adjusted both axially and
vertically.
To adjust, move lever A fig. 32 downwards to
position 1, then adjust the steering wheel to the
most suitable position and lock it in position by
moving lever A to position 2.
WARNING
All adjustments must be carried out only
with the car stationary and engine off.
WARNING
It is absolutely forbidden to carr y out
any after-market operation involving
steering system or steering column
modifications (e.g. installation of anti-theft
device) that could badly affect performance and
safety, invalidate the warranty and also result
in the car not meeting type-approval
requirements.
fig. 32
F0Y0043
38GETTING TO
KNOW YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
Page 43 of 420
REAR VIEW MIRRORSINTERIOR MIRROR
The mirror is fitted with a safety device that causes
its release in the event of a violent impact with
the passenger.
Operate lever A fig. 33 to adjust the mirror into two
different positions: normal or anti-glare.
ELECTROCHROMIC INTERIOR MIRROR
(for versions/markets, where provided)
Some versions feature an electrochromic mirror
fig. 34 with an ON/OFF switch to activate/deactivate
the electrochromic function.
When reverse gear is engaged, the mirror is
automatically set for daytime use.DOOR MIRRORS
Manual adjustment
From the inside of the car, operate lever A fig. 35 to
adjust the mirror.
fig. 33
F0Y0223
fig. 34
F0Y0225
fig. 35
F0Y0275
39GETTING TO
KNOW YOUR CARSAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
Page 44 of 420
Electrical adjustment
(for versions/markets, where provided)
The mirrors can be adjusted only if the ignition key is
in MAR position.
To adjust proceed as follows:
❒use device A fig. 36 to select the required mirror
(right or left);
❒move device A to position B and manipulate it to
adjust the left door mirror;
❒move device A to position D and manipulate it to
adjust the right door mirror.
Once you have finished the adjustment, return device
A to intermediate locking position C.Manual folding
If necessary, fold the mirrors by moving them from
position 1 (open) to position 2 (closed) fig. 37.
IMPORTANT When driving the mirrors should
always be in position 1 (open).
fig. 36
F0Y0250
fig. 37
F0Y0226
40GETTING TO
KNOW YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX