reset FIAT BARCHETTA 2003 1.G Owners Manual
[x] Cancel search | Manufacturer: FIAT, Model Year: 2003, Model line: BARCHETTA, Model: FIAT BARCHETTA 2003 1.GPages: 170, PDF Size: 3.55 MB
Page 29 of 170
28
INSTRUMENTS
SPEEDOMETER
Speedometer kilometre
counter fig. 26
A- Kilometre counter
B- Speedometer
C- Trip counter
D- Reset button for the trip counter.
Press to reset.Speedometer mileometre fig. 27
A- Mileometre
B- Speedometer
C- Trip counter
D- Reset button for the trip counter.
Press to reset.REV COUNTER fig. 28
If the needle is in the zone with the
red notches, it shows your car’s en-
gine is over-revving. This is only ac-
ceptable for a few moments.
IMPORTANT The electronic in-
jection control system will progres-
sively cut off the fuel supply when the
engine is “overrevving” with conse-
quent loss of engine power.
fig. 26
P5S00635m
fig. 27
P5S00636m
fig. 28
P5S00637m
Page 42 of 170
41
FRONT AND REAR
FOGLIGHTS fig. 43
The controls are situated on the cen-
tre tunnel.
They only function if the ignition key
is at MAR.
When a button is pushed to turn the
lights on, it lights up itself.
A- ON/OFF button for the front
foglights (where fitted). The dipped
beam headlights must be on to oper-
ate these lights.B- ON/OFF button for the rear fog-
lights (where fitted). The dipped beam
headlights or the front foglights must
be on to operate these lights.
The rear foglights will be switched off
when the ignition key is turned to
STOP. If required, you will need to
turn them on again the next time you
start the engine.FUEL CUT-OFF SWITCH fig. 44
This is a safety cut-out which comes
into play in the case of an accident to
block the fuel supply and thus stop the
engine.
If you cannot see any fuel leaks and
the car is in a fit state to continue its
journey, press button Ato reactivate
the fuel supply system.
After an accident, remember to turn
the ignition key toSTOPto avoid the
battery running down.
fig. 44
P5S00653m
fig. 43
P5S00652m
If, after an accident, you
can smell petrol or see that
the fuel feed system is leaking, to
avoid the risk of fire, do not reset
the switch.
WARNING