Engine oil FIAT BRAVO 2007 2.G User Guide

When topping up take care
not to confuse the various
types of fluids: they are all in-
compatible with one another
and could seriously damage the car.
196
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE
CHECKING
FLUID LEVELS
1 Engine oil - 2 Battery - 3 Brake fluid
4 Windscreen/rear window/headlight wash-
er fluid - 5 Engine coolant
F0Q0616mfig. 1 - 1.4 16V version
F0Q0024mfig. 2 - 1.4 T-JET version
Never smoke while working
in the engine compartment;
gas and inflammable vapours may be
present, with the risk of fire.
WARNING
191-212 BRAVO GB 10-05-2007 9:21 Pagina 196

197
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE
fig. 3 - 1.9 Multijet 8V version
1 Engine oil - 2 Battery - 3 Brake fluid
4 Windscreen/rear window/headlight wash-
er fluid - 5 Engine coolant
F0Q0615m
2
3
4
5
1
F0Q0618mfig. 4 - 1.9 Multijet 16V 16V version
1 Engine oil - 2 Battery - 3 Brake fluid
4 Windscreen/rear window/headlight wash-
er fluid - 5 Engine coolant
191-212 BRAVO GB 10-05-2007 9:21 Pagina 197

198
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCEENGINE OIL fig. 5-6-7-8
Checking engine oil
Check the oil level a few minutes (about
5) after the engine has stopped, with the
car parked on level ground.
Remove the dipstick Aand clean it, put
it back in completely, remove it and check
that the level is within the MINand MAX
marks on the dipstick. The interval be-
tween the MINand MAXmarks corre-
sponds to about one litre of oil.
fig. 5 - 1.4 16V version F0Q0665m
Topping up engine oil
If the oil level is near or even below the
MINmark, add oil through the filler neck
B, until reaching the MAXmark.
Oil level shall never exceed the MAX
mark.
IMPORTANT If a routine check reveals
that the oil level is above the MAXmark,
contact Fiat Dealership to have the cor-
rect level restored.
IMPORTANT After adding or changing
the oil, let the engine turn over for a few
seconds and wait a few minutes after turn-
ing it off before you check the level.
fig. 7 - 1.9 Multijet 8V version F0Q0620mfig. 8 - 1.9 Multijet 16V version
A
B
F0Q0621m
Engine oil consumption
Max engine oil consumption is usually 400
grams every 1000 km.
When the car is new, the engine needs
to run in, therefore the engine oil con-
sumption can only be considered stabilised
after the first 5000 - 6000 km.
IMPORTANT The oil consumption de-
pends on driving style and the conditions
under which the car is used.
IMPORTANT Do not add oil with speci-
fications other than that already in the en-
gine.
F0Q0025mfig. 6 - 1.4 T-JET version
191-212 BRAVO GB 10-05-2007 9:21 Pagina 198

199
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE
When the engine is hot, take
care when working inside the
engine compartment to avoid burns.
Remember that when the engine is
hot, the fan may cut in: danger of in-
jury. Scarves, ties and other loose
clothing might be pulled by moving
parts.
WARNING
Used engine oil and filter con-
tain harmful substances for
the environment. Contact Fi-
at Dealership to have the oil
and filter changed.
ENGINE COOLANT FLUID
fig. 9-10
The coolant level shall be checked with
cold engine and shall not be lower than
the MINmark on the reservoir.
If the level is low, pour slowly a mixture
of 50% distilled water and 50%
PARAFLU
UPof the FL Seleniathrough
the filler neck A.
A 50-50 mixture of PARAFLU
UPand dis-
tilled water gives freeze protection to
–35°C.
For particularly hard climate conditions, we
recommend use of a 60% PARAFLU
UP
and 40% demineralized water mixture.
fig. 9 - 1.4 16V version F0Q0617mfig. 10 - 1.4 T-JET and 1.9 Multijet version F0Q0619m
The cooling system uses
PARAFLUUPantifreeze. Do
not add fluid having different
specifications from that al-
ready existing. PARAFLU
UPcannot be
mixed with other types of fluids. Should
other fluids be added, do not start the
engine and contact Fiat Dealership as
soon as possible.
Do not remove the reservoir
cap when the engine is hot:
you risk scalding yourself. The cool-
ing system is pressurised. If necessary,
replace the cap only with another
genuine one, otherwise system effi-
ciency could be compromised.
WARNING
191-212 BRAVO GB 10-05-2007 9:21 Pagina 199

228
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
INDEX
TECHNICAL
SPECIFICATIONSDASHBOARD
AND CONTROLS
For the correct function of the diesel versions with DPF use exclusively the original lubricant type. In emergency cases, where the
original product is not available, execute a fill up of only 0,5 lt. maximum and as soon as possible go to the Fiat Dealership.
In case of use of AE 5W-40 non original products, lubricants with minimum performances are accepted ACEA B4 for diesel en-
gines; in this case optimal performances of the engine are not guaranteed.
The use of products with inferior characteristics compared to ACEA C3 and ACEA B4 could cause damage, not covered by the
guarantee, to the engine.
For particularly rigid climatic conditions ask the Fiat Dealership for the appropriate product from the Seleniarange.
FLUIDS AND LUBRICANTS
RECOMMENDED PRODUCTS AND THEIR SPECIFICATIONS
Use Fluid and lubricant specifications Genuine fluids Change
for correct car operation and lubricants intervals
Synthetic-based oils, grade SAE 5W-40
FIAT 9.55535-S2 qualification or ACEA C3 specification.
Synthetic-based oils, grade SAE 5W-40
FIAT 9.55535- N2 qualification. Oils for petrol
engines
Oils for diesel
enginesAs per Service
Schedule
As per Service
Schedule SELENIA K P.E.
SELENIA WR
213-236 BRAVO GB 16-05-2007 10:11 Pagina 228

Mechanical gearbox
and differential
Mechanical gearbox
and differential
CV joints
on differential side
CV joints on wheel side
Brake and clutch
hydraulic controls
Radiator antifreeze propor-
tion: 50% distilled water and
50% PARAFLU
UP(❑)
To be used diluted
or undiluted
To be mixed with diesel fuel
(25 cc per 10 litres) Lubricants
and greases for
transmissions
Protective
agent
for radiators
229
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
INDEX
TECHNICAL
SPECIFICATIONS
TUTELA CAR
TECHNYX
TUTELA CAR
MATRYX
TUTELA
STAR 700
TUTELA ALL STAR
TUTELA TOP 4
PARAFLU
UP(●)
TUTELA
DIESEL ART
TUTELA
PROFESSIONAL
SC 35 Windscreen/
rear window/
headlight
washer fluid Brake
fluid
Additive for
diesel fuelSynthetic-based oil, grade SAE 75W-85
that passes API GL-4 PLUS, FIAT 9.55550 specifications.
Synthetic-based oil, grade SAE 75W-85
that passes API GL-4 specifications
Specifc grease to be used for constant-velocity joints with
low friction coefficient. N.L.G.I. 0-1 consistency.
Grease containing Molybdenum bisulphide for high
temperature appliances. N.L.G.I. 1-2 consistency.
Synthetic fluid, FMVSS n° 116 DOT 4, ISO 4925
SAE J1704, CUNA NC 956-01
Protective with antifreeze action, red colour
based on inhibited monoethylen glycol and organic formula,
that passes CUNA NC 956-16, ASTM D 3306 specifications.
Additive for diesel fuels with protective action for Diesel engines
Mixture of alcohol and surfactants CUNA NC 956-11
Use Fluid and lubricant specifications Genuine fluids Applicationsfor correct car operation and lubricants
(●) IMPORTANT Do not add or mix fluids having different specifications from that already existing.
(❑) For particularly hard climate conditions, we recommend use of a 60% PARAFLUUPand 40% demineralized water mixture.
213-236 BRAVO GB 16-05-2007 10:11 Pagina 229

ENGINE OIL CHANGE
1.4 16V- 1.4 T-JET 150 HP
- 1.9 Multijet 8V - 1.9 Multijet 16V
Tank capacity 57
Reserve8-10
Refuel petrol engines with unleaded petrol with octane rating (RON) no lower than 95 only (EN 228 Specifications)
Refuel diesel engines with diesel fuel for motor vehicles only (EN 590 Specifications)
FUEL CAPACITIES (litres)
Fiat Group Automobiles S.p.A. - Quality - Assistenza Tecnica - Ingegneria Assistenziale - Largo Senatore G. Agnelli, 5 - 10040 Volvera - Torino (Italia) - Print N. 603.81.209 - 05/2007 - 1stEdition
1.4 16V- 1.4 T-JET 150 HP 1.9 Multijet8V- 1.9 Multijet 16Vlitres kg litres kg
Fuel tank 2.75 2.4 4.4 3.8
Engine sump and filter 2.9 2.55 4.7 4.0
Add +0.3 bar to the prescribed inflation pressure when the tyres are warm. Recheck pressure value with cold tyres.
With snow tyres, add +0.2 bar to the inflation pressure value prescribed for standard tyres.
When running at speed higher than 160 km/h, inflate tyres at full load inflation values.
T.P.M.S. system not available for tyre 195/65 R15 91H.
COLD TYRE INFLATION PRESSURE (bar)
195/65 R15 91H 2.3 2.3 2.6 2.6
1.4 16V205/55 R16 91H 2.3 2.3 2.6 2.6
225/45 R17 91V 2.3 2.3 2.6 2.6
195/65 R15 91H 2.3 2.3 2.6 2.6
1.9 Multijet 8V205/55 R16 91H 2.3 2.3 2.6 2.6
225/45 R17 91V 2.3 2.3 2.6 2.6
225/40 R18 92V 2.6 2.6 2.9 2.9
1.4 T-JET 150 HP195/65 R15 91V 2.3 2.3 2.6 2.61.9 Multijet 16V
205/55 R16 91V 2.3 2.3 2.6 2.6
225/45 R17 91V 2.3 2.3 2.6 2.6
225/40 R18 92V 2.6 2.6 2.9 2.9STANDARD TYRES
Size Medium load Full load
Front Rear Front Rear
237-244 BRAVO GB 10-05-2007 9:23 Pagina 244