clock FIAT DOBLO COMBI 2013 Owner handbook (in English)

113
KNOW
YOUR
VEHICLE
SAFETY
STAR

TING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICING
AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
PROTECTING THE ENVIRONMENT
The devices for reducing petrol engine emissions are the
following:
❒three-way catalytic converter;
❒Lambda sensors;
❒evaporation prevention system.
In addition, do not let the engine run, even for a test, with
one or more spark plugs disconnected.
The following devices are used for reducing diesel fuel en-
gine emissions:
❒oxidising catalytic converter;
❒exhaust gas recirculation system (EGR);
❒diesel particulate filter (DPF) (for versions/markets
where provided).
To close
1) Fit the cap (complete with key) and turn it clockwise
until it clicks once or more.
2) Turn the key clockwise and extract it, then close the
flap.
The hermetic seal may cause a slight increase in pressure
in the tank. A suction noise when you release the cap is
therefore entirely normal.
Do not place naked flames or lit cigarettes
near to the fuel tank opening: fire risk. Keep
your face away from the fuel tank open-
ing to avoid breathing in harmful vapours.

168
KNOWYOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICA TIONS
INDEX
F0V0099mfig. 147F0V0100mfig. 148
CYLINDER REPLACEMENT PROCEDURE
To replace the cylinder, proceed as follows:
❒ disconnect B-fig. 148;
❒ turn the canister anticlockwise to lift it out;
❒ insert the new canister and turn it clockwise;
❒ connect B to the canister and fit the filler tube A into
its allocated space.
FOR CHECKING AND RESTORING
PRESSURE ONLY
The compressor may also be used for restoring pressure
only. Release the quick coupling and connect directly to
the tyre valve fig. 147; in this way, the canister will not
be connected to the compressor and no sealing fluid will
be injected.

170
KNOWYOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICA TIONS
INDEX
F0V0027mfig. 149
BULB TYPES fig. 149
Various types of bulbs are fitted to your vehicle.
A Glass bulbs: pushed into position. Pull to extract.
B Bayonet-type bulbs: to remove from its holder, press the bulb in and turn it anti-clockwise.
C Tubular bulbs: release them from their contacts to re- move. D Halogen bulbs: to remove the bulb, release the clip
holding the bulb in place.
E Halogen bulbs: to remove the bulb, release the clip holding the bulb in place.

172
KNOWYOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICA TIONS
INDEX
F0V0028mfig. 150F0V0029mfig. 151
CHANGING AN EXTERIOR BULB
For the type of bulb and relevant power rating, see
“Changing a bulb”.
FRONT LIGHT CLUSTERS fig. 150
The front light clusters contain sidelight, dipped beam, main
beam and direction indicator bulbs.
The bulbs are arranged inside the light cluster as follows:
A Direction indicators.
B Side lights and dipped beam headlights;
C Daytime running lights and main beams.
To access the bulbs, remove the snap-fitted covers.
SIDE LIGHTS
To change the bulb, proceed as follows:
❒ remove the protective cover B-fig. 150;
❒ turn the bulb holder A-fig. 151 anticlockwise and pull
it out;
❒ remove the bulb B and replace it;
❒ refit the new bulb, put the bulb holder A-fig. 151 back
into place and then refit the protective cover B-fig. 150
properly.

173
KNOW
YOUR
VEHICLE
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICING
AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
F0V0030mfig. 152F0V0031mfig. 153
DIRECTION INDICATORS
Front
To change the bulb, proceed as follows:
❒ remove the protective cover A-fig. 150;
❒ turn the bulb holder C-fig. 153 anticlockwise and pull
it out;
❒ remove the bulb B-fig. 153 by pushing it in slightly and
turning it anticlockwise;
❒ replace the bulb and refit the bulb holder C by turning
it clockwise and locking it properly into place;
❒ reattach the protective cover A-fig. 150;
Side
IMPORTANT Go to a Fiat Dealership to have bulbs for
the side direction indicators replaced, because they are lo-
cated inside the wing mirror.
DIPPED BEAM HEADLIGHTS
To change the bulb, proceed as follows:
❒
remove the protective cover B-fig. 150;
❒ disconnect the electric connector;
❒ release the bulb holding clips A-fig. 152;
❒ remove the bulb B-fig. 152 and replace it;
❒ fit the new bulb, ensuring that the outline of the metal
part lines up with the grooves on the headlight parabo-
la. Then reconnect the electrical connector and reat-
tach the bulb holding clips A;
❒ refit the protective cover B-fig. 150 correctly.

174
KNOWYOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICA TIONS
INDEX
F0V0032mfig. 154F0V0033mfig. 155
DAYTIME RUNNING LIGHTS
To change the bulb, proceed as follows:
❒ remove the protective cover C-fig. 150;
❒ turn the bulb holder E-fig. 155 anticlockwise and pull
it out;
❒ remove the snap-fitted bulb;
❒ replace the bulb and refit the bulb holder E by turning
it clockwise and locking it properly into place;
❒ reattach the protective cover C-fig. 150;
FRONT FOG LIGHTS
(for versions/markets where provided)
IMPORTANT Go to a Fiat Dealership to have the front
fog light bulbs replaced.
MAIN BEAM HEADLIGHTS
To change the bulb, proceed as follows:
❒
remove the protective cover C-fig. 150;
❒ disconnect the electric connector;
❒ release the bulb holding clips D-fig. 154;
❒ remove the bulb and replace it;
❒ fit the new bulb, ensuring that the outline of the metal
part lines up with the grooves on the headlight parabo-
la. Then reconnect the electrical connector and reat-
tach the bulb holding clips D;
❒ refit the protective cover C-fig. 150 correctly.

175
KNOW
YOUR
VEHICLE
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICING
AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEXTo access bulbs A – B – D – F, loosen the four fastening
screws E-fig. 157 and extract the bulb holder. To change
the bulb, push it in gently and turn it anticlockwise (“bay-
onet” fixture), then remove and replace it.
REAR LIGHT CLUSTERS
The rear light clusters contain taillight, brake light, direc-
tion indicator and reverse/rear fog light bulbs. To access
the light clusters, proceed as follows:
❒
open the rear doors;
❒ undo the fastening screws A-fig 156;
❒ disconnect the electrical connector and then remove
the light cluster.
The bulbs are arranged inside the light cluster fig. 157 as
follows:
A Brake lights
B Direction indicators
C Reverse lights
D Taillights
F Taillights/rear fog light;
To change the reverse light bulbs, turn bulb holder
C-fig. 157 anticlockwise, extract the snap-fitted bulb and
replace it.
F0V0034mfig. 156

177
KNOW
YOUR
VEHICLE
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICING
AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
F0V0037mfig. 161
F0V0179mfig. 160
NUMBERPLATE LIGHTS
(for versions with swing doors)
Proceed as follows to replace the bulbs A-fig. 162:
❒ manoeuvre the holding tabs at the points indicated in
the diagram, and remove the lens by lifting to the left;
❒ remove the bulbs by releasing them from the side con-
tacts; insert the new bulbs and make sure they are cor-
rectly clamped between these contacts;
NUMBERPLATE LIGHTS
(for hatchback versions)
Proceed as follows to replace the bulbs A-fig. 160:
❒
manoeuvre the holding tabs at the points indicated by
the arrows, and remove the bulb holder;
❒ turn the bulb holder B-fig. 161 anticlockwise, then re-
move the bulb C.
F0V0036mfig. 162
F0V0231mfig. 159b

269
KNOW
YOUR
VEHICLE
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICING
AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEXDashboard .................................. 3
Dead lock device ....................... 8
Defrosting-demisting – rear windscreen ..... 46-49-58
– windscreen and front side windows .......... 45-48-57
Demisting/defrosting – door mirro rs ..........46-49-58
– rear windscreen ..... 46-49-58
– windscreen and front side windows ................ 45-49
Diesel filter ............................. 206
– water in the filter warning light ..................... 151
Diesel particulate filter (DPF) ..................................... 114
Digital di splay ........................... 14
– control buttons .................. 14
– Set-up menu ....................... 15
– standard screen ................. 14Dipped beam headlights
– bulb replace ment.............. 173
– switching on......................... 59
Direction indicators – front bulb replacement ... 173
– rear bulb replacement ..............175-176
– side bulb replacement ..... 173
– switching on ....................... 60
Document holder clip ............. 76
Door lock ing ............................ 77
Doors – central locking .................... 77
– child safety device ............. 80
– load compartment unlocking device ................ 77
– opening/closing from the inside ........................ 79-80
– remote opening/closing ....... 6
Cleaning your vehicle
– engine compartment ...... 216
– exterior ............................. 214
– interio rs ............................ 216
Climate control system ... 47-51 – Air vents .............................. 43
Climate control vents ............ 43
Clock – adjusting .............................. 22
Clutch – technical specifications .... 224
CO
2emissions at exhaust .. 257
CODE Card ............................... 5
Constant speed regulator (Cruise Control) ................... 63
Control buttons ...................... 70
Cruise Control (constant speed regulator) .................... 63
Cut-off system ......................... 70

276
KNOWYOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING
LIGHTS AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEXSetting the clock ....................... 22
Side air bags (side bag - window bag) ......... 130-131-132
– general warnings ............. 131
Side/taillights – front bulb replacement ... 172
– rear bulb replacement ..............175-176
– switching on......................... 59
Sliding side doors ..................... 78
Smart washing (windscreen wipers) ............. 61
Snow cha ins ........................... 141
Sockets ................................ 72-73
Spare wheel ........................... 228 – technical specifications .... 228
Spark plugs (type) .................. 223
Speed block system .............. 102
Speedometer .....................14-19
Start&Stop system ................. 104Starting and driving
............... 133
Steering lock and ignition switch ........................................ 9
Steering wheel adjustment .... 39
Steering wheel levers ....... 59-61
Steering wheel lock.................... 9
Steering wheel – adjustment lever ................ 39
– turning circle ..................... 225
Steering – steering wheel adjustment lever ..................................... 39
– technical data ................... 225
Sun visors ................................. 75
Suspensions ............................ 225
Switching courtesy lights on/off ....................................... 69
Symbols ....................................... 4 T
ailgate
– emergency opening from the inside ........................ 85-86
– opening with remote control ............................... 6-7
Technical specifications. ....... 219
Third brake light .................... 176
Top speeds ............................. 229
Topping up the engine oil ... 202 – specifications .................... 247
Tow hook
– installation ................189-190
Towing the vehicle ............... 189
Towing trailers ...................... 139
Trailer (towing) .............189-190
– installing the tow hook .......................... 189-190
Transmission
– technical data ................... 224