lock FORD AEROSTAR 1996 1.G Owners Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 1996, Model line: AEROSTAR, Model: FORD AEROSTAR 1996 1.GPages: 353, PDF Size: 2.87 MB
Page 9 of 353
6 %
*
[IN05500(ALL)06/95]
q
on the Safety Compliance Certification Label
Ð this label is attached to the left front door
lock facing or the door latch post pillar. It is
required by the National Highway Traffic
Safety Administration and is made of special
material. If someone tampers with it, it will
be destroyed and/or a destruction pattern
will appear.
*
[IN05515(ALL)05/95]
The label contains the name of the manufacturer,
the month and year of manufacture, the
certification statement and the Vehicle
Identification Number. The label also contains
Gross Vehicle Weight Rating and Gross Axle
Weight Ratings, wheel and tire data and
information codes for additional vehicle data.
For further information about the Safety
Compliance Certification Label and the
information contained on it, refer to the Index.
%*
[IN05545(ALL)06/95]
Federal Highway Administration
Regulation
*
[IN05560(ALL)06/95]
Regulations such as those issued by the Federal
Highway Administration or issued pursuant to
the Occupational Safety and Health Act (OSHA),
and/or state and local laws and regulations may
require additional equipment for the way you
intend to use the vehicle. It is the responsibility
of the registered owner to determine the
applicability of such laws and regulations to
your intended use for the vehicle, and to
arrange for the installation of required
equipment. Your Ford dealer has information
about the availability of many items of
equipment which may be ordered for your
vehicle.
File:02cpina.ex
Update:Tue Aug 29 17:33:02 1995
Page 14 of 353
12
*
[SR02501(ALL)06/95]
RWARNING
Never wear the shoulder belt under the
arm. Never swing it around the neck over
the inside shoulder. Never use a single
belt for more than one person or across
more than one seating position. Each
seating position in your vehicle has a
specific safety belt assembly which is
made up of one buckle and one tongue
that are designed to be used as a pair.
Failure to follow these precautions could
increase the risk and/or severity of injury
in a collision.
*
[SR02550(ALL)08/95]
RWARNING
To reduce the risk of serious injury in a
collision, children should always ride with
the seatback upright.
*
[SR02601(ALL)06/95]
RWARNING
Never drive or ride with a twisted or
jammed safety belt. If you cannot untwist
or unjam the safety belt, see the nearest
qualified technician immediately.
*
[SR02700(ALL)08/95]
RWARNING
Never let a passenger hold a child on his
or her lap while the vehicle is moving.
The passenger cannot protect the child
from injury in a collision.
*
[SR02900(ALL)08/95]
RWARNING
Lock the doors of your vehicle before
driving to lessen the risk of the door
coming open in a collision.
File:03cpsra.ex
Update:Tue Aug 29 17:35:04 1995
Page 15 of 353
13
%*
[SR03000(ALL)05/95]
Combination Lap and Shoulder
Belts
*
[SR03200(ALL)06/95]
While your vehicle is in motion, the combination
lap and shoulder belt adjusts to your movement.
However, if you brake hard, turn hard, or if
your vehicle receives an impact of 5 mph
(8 km/h) or more, thelap/shoulder belt locks
and helps reduce your forward movement.
*
[SR03400(ALL)05/95]
After you get into your vehicle, close the door
and lock it. Then adjust the seat to the position
that suits you best.
*
[SR03500(ALL)05/95]
Pull the combination lap/shoulder belt from the
retractor so that the shoulder portion of the belt
crosses your shoulder and chest. Be sure the belt
is not twisted. If it is, remove the twist. Insert
the belt tongue into the proper buckle until you
hear a snap and feel it latch. Make sure the
tongue is securely fastened to the buckle by
pulling on tongue.
*
[SR03600(ALL)06/95]
quarter page art:0010018-B
Fastening the front seat combination lap and shoulder belt
[SR03650(ALL)05/95]
NOTE: Be sure to read and understand
Important Safety Belt Informationat the beginning
of this chapter.
File:03cpsra.ex
Update:Tue Aug 29 17:35:04 1995
Page 16 of 353
14 [SR03800(ALL)06/95]
one third page art:0095046-AUnfastening the combination lap and shoulder belts Ð
front and rear outboard seating positions
*
[SR03900(ALL)07/95]
While the belt retracts, guide the tongue to its
original position to prevent it from striking you
or the vehicle.
*
[SR04000(ALL)05/95]
Safety Belts for Front Outboard Passenger
and Rear Outboard Seating Positions
*
[SR04210(ALL)05/95]
Your vehicle is equipped with a dual locking
mode retractor on theshoulderbelt portion of
the combination lap/shoulder safety belt for the
front seat outboard passenger and rear outboard
passengers.
*
[SR04220(ALL)05/95]
Dual locking mode retractors operate in two
ways:
*
[SR04230(ALL)06/95]
Vehicle sensitive (emergency) locking mode
*
[SR04240(ALL)05/95]
In this operating mode, the shoulder belt
retractor will allow the occupant freedom of
movement, locking tight only on hard braking,
hard cornering or impacts of approximately
5 mph (8 km/h) or more. The retractor can also
be made to lock by pulling on the belt.
File:03cpsra.ex
Update:Tue Aug 29 17:35:04 1995
Page 17 of 353
15 %
*
[SR04250(ALL)08/95]
Automatic locking mode
*
[SR04260(ALL)07/95]
In this operating mode, the shoulder belt
retractor will be automatically locked and will
remain locked when the combination
lap/shoulder safety belt is buckled, and does not
allow the occupant freedom of movement. This
mode provides the following:
*
[SR04270(ALL)07/95]
q
A tight lap/shoulder belt on the occupant.
*
[SR04280(ALL)07/95]
q
Child safety seat installation.
*
[SR04300(ALL)07/95]
This modemust be usedwhen installing a child
safety seat on the front passenger seat and rear
outboard seats where dual locking retractors are
provided.
*
[SR04310(ALL)07/95]
To switch the retractor from the emergency
locking mode to the automatic locking mode,
perform the following steps:
*
[SR04320(ALL)08/95]
1. Buckle the lap/shoulder combination belt.
*
[SR04330(ALL)08/95]
2. Grasp the shoulder portion of the belt and
pull downward until all of the belt is
extracted and, when allowed to retract, a
clicking sound is heard. At this time, the belt
retractor is in the automatic locking mode
(child restraint mode).
*
[SR04340(ALL)08/95]
3. A clicking sound will continue to be heard
as the belt is allowed to retract. This
indicates that the retractor is in the
automatic locking mode.
*
[SR04350(ALL)07/95]
NOTE: When the combination lap/shoulder
belt is unbuckled and allowed to
retract completely, the retractor will
switch to the vehicle sensitive
(emergency) locking mode. See the
detailed instructions underSafety Seats
for Childrenin this chapter.
File:03cpsra.ex
Update:Tue Aug 29 17:35:04 1995
Page 23 of 353
21
*
[SR07500(ALL)06/95]
Pull the belt across your hips andinsert the
tongue into the correct buckleon your seat
until you hear a snap and feel it lock. Make sure
the buckle is securely fastened.
%*
[SR07700(ALL)06/95]
If you need to lengthen the belt, unfasten it and
tip the belt tongue at a right angle to the belt.
Pull the belt tongue over your lap until it
reaches the buckle.
*
[SR07800(ALL)06/95]
If you need to shorten the belt, pull on the loose
end of the webbing until the belt fits snugly.
[SR07900(ALL)08/95]
one third page art:0000029-F
Unfastening the lap belts for the center front and center
rear seating positions Ð end release buckle shown (other
buckle similar)
*
[SR08600(ALL)08/95]
To unfasten the belt, push the release button on
the end of the buckle. This allows the tongue to
unlatch from the buckle.
*
[SR08800(ALL)07/95]
RWARNING
The lap belts should fit snugly and as low
as possible around the hips, not around
the waist.
File:03cpsra.ex
Update:Tue Aug 29 17:35:04 1995
Page 37 of 353
35
*
[SR16025(ALL)08/95]
When installing a child safety seat, be sure to
use the correct safety belt buckle for that seating
position, and make sure the tongue is securely
fastened in the buckle. For a shoulder/lap belt
combination with a sliding tongue, make sure
the retractor is in the automatic locking mode.
*
[SR16090(ALL)07/95]
All child restraint systems are designed to be
secured in vehicle seats by lap belts or by the
lap portion of a lap-shoulder belt.
*
[SR16100(ALL)06/95]
RWARNING
If you do not properly secure the safety
seat, the child occupying the seat may be
injured during a collision or sudden stop.
An unsecured safety seat could also injure
other passengers.
*
[SR16125(ALL)08/95]
RWARNING
Carefully follow all of the manufacturer's
instructions included with the safety seat
you put in your vehicle. If you do not
install and use the safety seat properly,
the child may be injured in a sudden stop
or collision.
File:03cpsra.ex
Update:Tue Aug 29 17:35:04 1995
Page 39 of 353
37
[SR25601(ALL)08/95]
Installing Child Safety Seats in
the Front Seat and Rear Outboard
Seating Positions
[SR25650(ALL)08/95]
Your vehicle is equipped with a dual locking
mode retractor on the shoulder belt portion of
the combination lap/shoulder safety belt for the
right front seat passenger and rear outboard
passengers.
[SR25701(ALL)03/95]
If you choose to install a child safety seat or
infant carrier in these seating positions:
[SR25750(ALL)08/95]
1. Position the child seat on the seat of the
vehicle. In the front seat, adjust the vehicle
seat as far rearward as possible.
[SR25801(ALL)08/95]
2. Pull down on the shoulder belt, then grasp
the shoulder belt and lap belt together. See
Figure 1.
[SR25900(ALL)08/95]
half page art:0095072-AFile:03cpsra.ex
Update:Tue Aug 29 17:35:04 1995
Page 42 of 353
40
*
[SR26301(ALL)08/95]
4. Grasp the shoulder portion of the belt and
pull downward until all of the belt is
extracted and a click is heard. At this time,
the retractor is in the automatic locking
mode (child seat restraint mode). See
Figure 4.
[SR26401(ALL)08/95]
half page art:0011241-A
Setting the retractor to automatic locking mode
File:03cpsra.ex
Update:Tue Aug 29 17:35:04 1995
Page 43 of 353
41 [SR26500(ALL)08/95]
5. Allow the belt to retract. Pull up on the
shoulder webbing. A clicking sound will be
heard as the belt retracts. This indicates the
retractor is in the automatic locking mode.
Push down on the child seat while you pull
up on the belt to remove any slack in the
belt. See Figures 5 and 6.
[SR26601(ALL)08/95]
half page art:0011242-AFile:03cpsra.ex
Update:Tue Aug 29 17:35:04 1995